Question is ⇒ Hall's effect can be used to measure, Options are ⇒ (A) magnetic field intensity, (B) average number of holes, (C) carriers concentration, (D) electrostatic field intensity, (E) , Leave your comments or Download question paper.

Question is ⇒ Hall's effect can be used to measure, Options are ⇒ (A) magnetic field intensity, (B) average number of holes, (C) carriers concentration, (D) electrostatic field intensity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Hall's effect can be used to measure
A.	magnetic field intensity [Correct Answer]
B.	average number of holes [Wrong Answer]
C.	carriers concentration [Wrong Answer]
D.	electrostatic field intensity [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In intrinsic semiconductor at 300 K, the magnitude of free electron concentration in silicon is about
15 x 10⁴ per cm³
5 x 10¹² per cm³
1.45 x 10¹⁰ per cm³
1.45 x 10⁶ per cm³

⇒ In which condition does BJT behave like a closed switch?
Cut off
Saturation
Forward active
Reverse active

⇒ Consider the following differences between QPSK and MSK

The side lobes in MSK are relatively much smaller in comparison to the main lobe
The spectrum of MSK has a main centre lobe which is 1.5 times as wide as the main lobe of QPSK
The waveforms of both MSK and QPSK exhibit phase continuity

Which of the above statements are correct?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒ In a resistive ac circuit, the current __________ the voltage by __________ .
lags, 90°
lags, 45°
lags, 0°
leads 90°

⇒ The normal operation of JFET is
constant voltage region
constant current region
both constant voltage and constant current regions
either constant voltage or constant current region

⇒ Consider the following statements about Yagi Uda antenna

It is unidirectional
Its gain is about 7 dB
It is used at VLF
The optimum separation is 0.11

Which of the above are correct?
1 and 2 only
1, 2, 4 only
1, 2, 3, 4
1 and 4 only

⇒ The storage capacity of audio CD is 540 Mb per side.
TRUE
FALSE

⇒ JFET is also known as
linear device
square law device
inverse law device
logarithmic law device

⇒ In an n type semiconductor
number of free electrons and holes are equal
number of free electrons is much greater than the number of holes
number of free electrons may be equal or less than the number of holes
number of holes is greater than the number of free electrons

⇒ The capacitance of a capacitor is not affected by
area of plates
thickness of plates
∈_r
distance between plates

⇒ A class A transformer coupled power amplifier is to deliver 10 W output. The power rating of transistor should not be less than
5 W
10 W
20 W
40 W

⇒ If 8085 is required to add two 32 bit numbers, the numbers of addition sequences is
1
2
4
8

⇒ As per BIS, the number of accuracy classes of instrument is
5
6
7
8

⇒ To neglect a current source the terminals across the source are
replaced by some resistance
replaced by capacitance
open-circuited
short-circuited

⇒ The velocity of electromagnetic wave in a good conductor is
3 x 10⁸ m/s
more than 3 x 10⁸ m/s
very low
high

⇒ A computer memory is an ordered sequence of storage cells.
TRUE
FALSE

⇒ Thu advantage of using a dual stop ADC in a digital voltmeter is that
its conversion time is small
its accuracy high
output is in BCD format
it does not require a comparator

⇒ Thevenin's impedance of an ac network is in general
resistance
R and L in series
R and C in series
Either R and L or R and C in series

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the base current will be
35 μA
25 μA
15 μA
5 μA

⇒ A voltage V(t) is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt². If it is measured by a dc meter. The reading will be
0
4
2
2

⇒ The phenomenon known as "Early effect" in a BJT refers to a reduction of the effective base width caused by
electron-hole recombination at the base
reverse biasing of the base collector junction
forward biasing of emitter base junction
the early removal of stored base charge during saturation to cut off switching

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒ For a parallel two wire line with both conductors touching each other, the characteristic impedance is about
300 Ω
200 Ω
80 Ω
24 Ω

⇒ The system in the given figur
type 0 system
type 1 system
type 2 system
type 3 system

⇒ Programs like compilers, assemblers etc. are stored in a mircocomputer in
registers
cache memory
primary memory
mass storage

⇒ Octal 16 is equal to decimal
13
14
15
16

⇒ Which of the following pulse modulation is analog?
PCM
Differential PCM
PWM
Delta

⇒ ARQ stands for
Automatic Repeat Quest
Analog Repeat Request
Automatic Repeat Request
None Of the above

⇒ Transverse electric (TE) waves have
electric field component E in the direction of propagation
magnetic field component H in the direction of propagation
magnetic field component H in the direction of propagation and no component of electric field E in this direction
electric field component E in the direction of propagation and no component of magnetic field H in this direction

⇒ Bipolar IC memories are fabricated using
high density versions of MOSFET or low density versions of bipolar transistor flip-flop.
high density version of MOSFET or bipolar transistor flip-flop
low density versions of MOSFETs
high density versions of the bipolar transistor flip-flop.