Question is ⇒ Half power point directions for broadside is, Options are ⇒ (A) 60°, (B) 30°, (C) 45°, (D) at any angle, (E) , Leave your comments or Download question paper.

Question is ⇒ Half power point directions for broadside is, Options are ⇒ (A) 60°, (B) 30°, (C) 45°, (D) at any angle, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Half power point directions for broadside is
A.	60° [Correct Answer]
B.	30° [Wrong Answer]
C.	45° [Wrong Answer]
D.	at any angle [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If a zero is added to a second order underdamped system
the peak overshoot is increased
the peak overshoot is decreased
the peak overshoot remains unchanged
either (a) or (b)

⇒ Which device has internal positive feedback?
Two cavity klystron amplifier
Multi-cavity klystron amplifier
Reflex klystron amplifier
All of the above

⇒ For maximum transfer of power, internal resistance of the source should be
equal to load resistance
less than the load resistance
greater than the load resistance
none of the above

⇒ The total number of channels allotted for cellular telephone is
666
333
221
111

⇒ His rather casual remarks on politics __________ his lack of seriousness about the subject.
masked
belied
cherish
conserve

⇒

Assertion (A): When a high reverse voltage is applied to a p-n junction the diode breaks down.

Reason (R): High reverse voltage causes Avalanche effect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.999 V, the resolution is
1 V
0.01 V
1 mV
1 μV

⇒ Which of the following is not a valid real variable in FORTRAN 77?
ANUT
MONEY
A MONEY
BS

⇒

Match the following:

	List I (Circuit)		List II (Characteristics)
A.	Darlington pair	1.	uses pnp and npn transistors used as power amplifier
B.	CB amplifier	2.	Voltage gain nearly 1 and high input impedance
C.	Cascade amplifier	3.	low input impedance used for high frequency isolation

A-1, B-2, C-3
A-2, B-3, C-1
A-2, B-1, C-3
A-3, B-1, C-2

⇒ The three sides of an admittance triangle denote
G, B, Y
R, X, Y
G, B, Z
(R, Y, Z) or (R, X, Z)

⇒

Assertion (A): If an event A can happen in m ways and another event B can happen in n ways, both can happen in mn ways.

Reason (R): Two events are mutually exclusive if happening of either precludes the occurrence of other.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In CE amplifier the base current is very high.
TRUE
FALSE

⇒ Boolean algebra obeys
commutative law
associative law
distributive law
commutative, associative and distributive law

⇒ Which of the following are linear ICs?
RF and IF amplifiers
Wide band amplifier
Audio amplifiers
All of the above

⇒ As regards single phase dual converter
the change in operation from one quadrant to the other is faster in non-circulating current mode
the change in operation from one quadrant to the other is faster in circulating current mode
the time response to change in operation from one quadrant to other is the same in both the modes
the time response to change in operation from one quadrant to the other may be faster in any of the two modes

⇒ The main advantage of CMOS circuit is
high gain
high output impedance
low power consumption
high gain and high output impedance

⇒ The two conductors of a single phase transmission line suspended in air carry currents in opposite directions. The force per unit length on each conductor varies
directly as the current in either conductor
directly as the distance between the two conductors
directly as the square of the current in either conductor
inversely as the square of the distance between the two conductors

⇒ Z_L = 200 Ω and it is desired that Z_i = 50 Ω The quarter wave transformer should have a characteristic impedance of
100 Ω
40 Ω
10000 Ω
4 Ω

⇒ δ(t - b) is a pulse function.
TRUE
FALSE

⇒ The number of key words in C is
4
8
16
32

⇒ A conditionally stable system has
one phase crossover frequency
two phase crossover frequencies
two or more phase crossover frequencies
one or more phase crossover frequencies

⇒ Which of the following modulation is analog in nature?
PCM
DPCM
DM
PDM

⇒ In the circuit of figure, v₁ = v₂ = 10 V.
I₁ = I₂
I₁ > I₂
I₂ > I₁
I₁ = 0

⇒ The circuit of figur
Precision integrator
Hartley oscillator
Butterworth high pass filter
Wien bridge oscillator

⇒ The r_e model equivalent circuit shown in figure is
CE amplifier
CC amplifier
CB amplifier
None of the above

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒ For most static RAM the maximum access time is about
1 ns
10 ns
100 ns
1 μs

⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE

⇒ ALE stands for
Address Latch Enable
Accumulator Latch Enter
Address Latch Enter
Accumulator Latch Enable

⇒ LVDT is used to measure
displacement
pressure
temperature
any of the above