Question is ⇒ Good smoothing factor of a coil depends on, Options are ⇒ (A) inductance of the coil, (B) terminal voltage, (C) cross-sectional area of the wire of the coil, (D) property of the wire of the coil, (E) , Leave your comments or Download question paper.

Question is ⇒ Good smoothing factor of a coil depends on, Options are ⇒ (A) inductance of the coil, (B) terminal voltage, (C) cross-sectional area of the wire of the coil, (D) property of the wire of the coil, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Good smoothing factor of a coil depends on
A.	inductance of the coil [Wrong Answer]
B.	terminal voltage [Wrong Answer]
C.	cross-sectional area of the wire of the coil [Wrong Answer]
D.	property of the wire of the coil [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The signal define by the equations u(t - a) = 0 for t < a and u(t - a) = 1 for t ≥ a is
a unit step function
a shifted unit step function orginating at t = a
a pulse function
none of the above

⇒ In Bode diagram (log magnitude plot) of the factor 1/(1 + jωT) in the transfer function the log magnitude for ω << 1/T can be approximated by
0 dB
20 log ωT dB
-20 log ωT dB
none of the above

⇒ In TE and TM modes of rectangular waveguides having propagation in z direction
E_z and H_z are both zero
In TE mode E_z is zero and in TM mode H_z is zero
In TE mode H_z is zero and in TM mode E_z is zero
In both TE and TM modes both E_z and H_z are non-zero

⇒ When two 16-input multiplexers drive a 2-input MUX, what is the result?
2-input MUX
4-input MUX
16-input MUX
32 input MUX

⇒ Consider the following statements about directional coupler shown in the fi
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ A directional microphone gives an output of 0.5 mV whereas an omnidirectional one gives an output of 0.5 μV in the same position for the same sound pressure. The directivity of the directional microphone is
120 dB
90 dB
60 dB
30 dB

⇒ A wave E_m cos (bx - ωt) is a backward wave.
TRUE
FALSE

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ Internet is a worldwide network of computers where most of the information is freely available.
TRUE
FALSE

⇒

Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.

Reason (R): Phase angle of an R-L series circuit is tan^-1 (ωL/R).

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Absolute instruments are used in
laboratories
industries
power houses
standard laboratories

⇒ What are the ultimate purpose of minimizing logic expressions?

To get small size expression.
To reduce the number of variables in the given expression.
To implement the function of the logic expression with least hardware.
To reduce the expression for making it feasible for hardware implementation.

Select the correct answer from the codes given below:
1 only
2 and 3
3 only
3 and 4

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒ Which of the following buses does not exist in 8085?
Data bus
Address bus
Control bus
Exchange bus

⇒ For a series R-L-C circuit tuned at resonant frequency which of the following statements is correct?
The voltage across inductance is greater than applied voltage
The voltage across capacitance is greater than applied voltage
The voltage across both inductance and capacitance is greater than applied voltage
The voltage across both inductance and capacitance is less than applied voltage

⇒ An n type silicon bar 0.1 cm long and 100 μm² in cross-sectional area has a majority carrier concentration of 5 x 10²⁰/m³ and the carrier mobility is 0.13 m⁰/V-s at 300k. If the charge of an electron is 1.6 x 10^-19 coulomb, then the resistance of the bar is
10⁶ ohm
10⁴ ohm
10^-1 ohm
10^-4 ohm

⇒ The potential that appears at a point in space due to the current which caused it is called potential
accelerating
retardation
oscillating
lagging the current

⇒ One eV = 1.602 x 10^-19 joules.
TRUE
FALSE

⇒ Transconductance indicates the
control of output voltage by input voltage
control of output current by input voltage
control of input voltage by output current
control of input current by input voltage

⇒ A sine wave with slew rate distortion looks like
step wave
square wave
triangular wave
cosine wave

⇒ Consider the following:

A TV receiver antenna should pick up the TV signal and develop maximum voltage from the available strength of signal
It should reject unwanted signals
It should not suffer from co-channel interference
It should have a very narrowband

The correct statements are
1 and 2 only
1, 2 and 3 only
1, 2, 3, 4
2, 3 only

⇒ Using 4-bit numbers (n = 4) if k = 0011₂, how is k expressed in 2's complement?
1011₂
1101₂
1100₂
0101₂

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The power gain is
125
250
1125
3125

⇒ If the circumference of a spherical target is between 1 to 10 wavelength in a radar system, the situation is called
resonance region
Rayleigh region
optical region
binomial region

⇒ Figure shows a dc circuit fed by a current source. With respect to terminals AB, Thevenin's voltage and Thevenin's resistance
V_TH = 5 V, R_TH = 0.75 Ω
V_TH = 2.5 V, R_TH = 0.75 Ω
V_TH = 2.5 V, R_TH = 1 Ω
V_TH = 5 V, R_TH = 1 Ω

⇒ The thermal resistance of a BJT is about
100° C/W
200° C/W
20° C/W
2° C/W

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz

⇒ The number of lobes on each side of a 31 resonant antenna will be
2
3
4
6

⇒ A system with input x[n] and output y[n] is given as y[n] = (sin 5/6 pn) x(n) The system is
linear, stable and invertible
non-linear, stable and non-invertible
linear stable, non invertible
linear, unstable, invertible