Question is ⇒ Given that the band gap of cadmium sulphide is 2.5 eV, the maximum photon wavelength, for e<sup>-</sup>-hole pair generation will be, Options are ⇒ (A) 5400 mm, (B) 540 mm, (C) 5400 Å, (D) 540 Å, (E) , Leave your comments or Download question paper.

Question is ⇒ Given that the band gap of cadmium sulphide is 2.5 eV, the maximum photon wavelength, for e<sup>-</sup>-hole pair generation will be, Options are ⇒ (A) 5400 mm, (B) 540 mm, (C) 5400 Å, (D) 540 Å, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Given that the band gap of cadmium sulphide is 2.5 eV, the maximum photon wavelength, for e^--hole pair generation will be
A.	5400 mm [Wrong Answer]
B.	540 mm [Wrong Answer]
C.	5400 Å [Correct Answer]
D.	540 Å [Wrong Answer]
View Answer 4 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ During day time ionosphere can be considered to be consisting of
D, E, F₁ and F₂ layers
D, E, F₁ layers
D, E, F₂ layers
D and E layers

⇒ h parameters are used in transistor analysis.
TRUE
FALSE

⇒ Which one of the following cannot be used to remove the unwanted sideband in SSB?
Balanced modulator
Phase shift method
Filter system
Third method

⇒ A matched generator (Z_g = Z₀) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are
0.5 W, 0.5 W, 0 W
0 W, 0 W, 1 W
0.33 W each
0 W, 0.25 W, 0.25 W

⇒ When slider of the potentiometer AB is in the position shown in figure, what resistance reading would be indicated by an ohmmeter connected between A an
zero
infinite
can't say
none of the above

⇒ The block diagram of the given figure
On-off controller
On-off controller with differential gap
On-off controller with integral gap
Three position controller

⇒ The use of microprocessor control in automobiles results in
improved fuel economy
improved car control
advanced information system for driver
all of the above

⇒ A second order system exhibits 100% overshoot. The damping ratio is
0
1
< 1
> 1

⇒ The correct sequence of subsystem in an FM receiver is
mixer, RF amplifier, limiter, IF amplifier, discriminator, audio amplifier
RF amplifier, mixer, IF amplifier, limiter, discriminator, audio amplifier
RF amplifier, mixer, limiter, discriminator, IF amplifier, audio amplifier
mixer, IF amplifier, limiter, audio amplifier, discriminator

⇒

Assertion (A): A tree of graph contains all the nodes of the graph.

Reason (R): The number of links is always less than the number of tree branches.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a bipolar transistor which current is largest
collector current
base current
emitter current
base current or emitter current

⇒ The duty cycle of a radar transmitter is equal to
(PRF) (pulse width)
(PRF)/(pulse width)
(pulse width)/(PRF)
(pulse width) + (PRF)

⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple

⇒ For an I/p of V_s = 5 sin ωt (assuming ideal diode), circuit shown in the figure will behave
clipper, sine wave clipped at -2 V
clamper, sine wave clamped at -2 V
clamper, sine wave clamped at 0 volts
clipper, sine wave clipped at 2 V

⇒ If f(t)↔ F(jω), and f(t) is real, then F(- jω)
F(jω)
F*(j↔)
F*(- jω)
none of these

⇒ Transformer coupling in transistor amplifier circuits provides high efficiency, because
d.c. resistance is low
collector voltage is stepped up
flux linkages are incomplete
all of the above

⇒ Which of the following is not a conducting material?
Copper
Tungsten
Germanium
Platinum

⇒

Assertion (A): Bolometer is frequently used in microwave power measurement.

Reason (R): In a bolometer the input microwave power causes a change in resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The response of a function is decided by
the location of its zeros
the location of its poles
both (a) and (b)
none of the above

⇒ The 54/74164 chip is an 8-bit serial-input-parallel-output shift register. The clock is 1 MHz. The time needed to shift a 8-bit binary number into the chip is
1 μs
2 μs
8 μs
16 μs

⇒ The trapezoidal pattern of figure is obtained when examining an AM wave by an oscilloscope. Modulation factor of the wave
0.33
0.5
2
1

⇒ In the circuit shown in figure, maximum power will be transferred
Z_L = 13 - j 9
Z_L = 13 + j 9
Z_L = 9 - j 13
Z_L = 9 + j 13

⇒ A Schottky diode clamp is used along with a switching BJT for
reducing the power
reducing the switching time dissipation
increasing the value of β
reducing the base current

⇒ The auto correlation of a sampling function is a
triangular function
gate function
signum function
none of the above

⇒ If x^k is one sided to the ri
TRUE
FALSE

⇒

Assertion (A): Hall effect is used to determine whether the semi- conductor is p or n type.

Reason (R): Under the influence of field, holes and electrons move in opposite direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
1 H and 2 F
1 H and 1 F
2 H and 1 F
1 H and 2 F

⇒ Two coils having equal resistance but different inductances are connected in series. The time constant of the series combination is
average of the time constants of individual coils
sum of the time constants of the individual coils
geometric mean of the time constants of individual coils
product of the time constants of the individual coils

⇒ Consider the following stateme
1, 2 and 3
1 and 2 only
2 and 3 only
3 and 4 only

⇒ For a second order instrument, the optimum range of ξ (damping ratio), which gives good frequency response over a wide range of frequencies is
0.5 to 0.6
0.6 to 0.7
0.7 to 0.8
0.8 to 1.0