Question is ⇒ Given a power supply filter circuit, what measurements must be made of determine percentage regulation, Options are ⇒ (A) current through and voltage across the capacitor, (B) d.c. load voltage and r.m.s. load voltage, (C) current through load and voltage across load resistance, (D) number of turns and gauge of secondary winding of transformer, (E) , Leave your comments or Download question paper.

Question is ⇒ Given a power supply filter circuit, what measurements must be made of determine percentage regulation, Options are ⇒ (A) current through and voltage across the capacitor, (B) d.c. load voltage and r.m.s. load voltage, (C) current through load and voltage across load resistance, (D) number of turns and gauge of secondary winding of transformer, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Given a power supply filter circuit, what measurements must be made of determine percentage regulation
A.	current through and voltage across the capacitor [Wrong Answer]
B.	d.c. load voltage and r.m.s. load voltage [Correct Answer]
C.	current through load and voltage across load resistance [Wrong Answer]
D.	number of turns and gauge of secondary winding of transformer [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Depending on the technique used, digitized television requires a bit rate between __________ millions.
40 and 92.5
25 and 60
30 and 82.5
2

⇒ If output power of a radio receiver is doubled, its volume is increased by __________ dB.
2
3
1
-3

⇒ An SSB-AM signal cannot be demodulated by
Balanced modulator
Complete phase shift generator
Diode balanced modulator
Product detector

⇒ A JFET is a
unipolar device
bipolar device
tripolar device
none of the above

⇒ In an 8085 microprocessor, the instruction CMP B has been executed while the content of the accumulator is less than that of register B, As a result.
carry flag will be set but zero flag will be reset
carry flag will be reset but zero flag will be set
both carry flag and zero flag will be reset
both carry flag and zero flag will be set

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
0.76, 0.24
0.95, 0.3
0.24, 0.76
0.3, 0.95

⇒ A n-type silicon sample contains a donor concentration of N_d = 2 x 10¹⁶ cm^-3. The minority carrier hole lifetime is t_p0 = 5 μs. The thermal equilibrium generation rate of hole is:
1.125 x 10⁹ cm^-3 s^-1
0.625 x 10⁹ cm^-3 s^-1
4.5 x 10⁹ cm^-3 s^-1
2.25 x 10⁹ cm^-3 s^-1

⇒ In open circuit impedance parameters, the independent variables are
I₁ and I₂
V₁ and V₂
V₁ and I₁
V₂ and I₂

⇒ Which of the following is likely to be associated with FM radio broadcasting?
90 Hz
90 kHz
900 kHz
90 MHz

⇒ The function shown in figure, can represent a probability density function for A ________
A = 1/4
A = 1/6
A = 1/8
A = 1/2

⇒ In TV system in India IF video and IF audio frequencies are
33.4 and 28.4 MHz respectively
38.9 and 33.4 MHz respectively
43.8 and 38.9 MHz respectively
33.4 and 38.9 MHz respectively

⇒ A signal x₁(t) and x₂(t) constitute the real and imaginary parts respectively of a complex valued signal x(t). What form of waveform does x(t) possess?
Real symmetric
Complex symmetric
Asymmetric
Conjugate symmetric

⇒ Which one of the following is correct?
RAM is a volatile memory but ROM is non-volatile memory
RAM is non-volatile memory but ROM is volatile memory
Both ROM and RAM are volatile but in ROM data is not lost when power is switched off
Both ROM and RAM are non-volatile but in RAM data is lost when power is switched off

⇒ A series resonant circuit is fed by a voltage having rms value V. At resonance, the voltage across inductance V_L and voltage across capacitance V_C are related as
V_L > V_C
V_L < V_C
V_L = V_C
V_L = 0.5 V_C

⇒ A transistor is operated as non-saturated switch to eliminate
turn on time
turn off time
storage time
delay time

⇒ In the given circuit, the switch is open for a long time. At time t = 0, the switch is closed. What are the initial and final values of voltages across the induc
0 V and 0 V
0 V and 80 V
80 V and 0 V
80 V and 80 V

⇒ Three analog signals, having bandwidths 1200 Hz, 600 Hz, 600 Hz are sampled at their Nyquist rates, encoded with 12 bit words, and time division multiplexed. The bit rate for the multiplexed signal is
115.2 kbps
28.8 kbps
57.6 kbps
38.4 kbps

⇒ The ratio of tangential component of electric field at the surface of a conductor and the linear current density resulting from this field is __________ impedance
characteristic
critical
surface
polarizing

⇒ A dynamometer wattmeter is suitable for both dc and ac.
TRUE
FALSE

⇒ A half adder can be used only for adding
1 s
2 s
4 s
8 s

⇒ The area of an impulse is
1
0
∞
any finite value

⇒ In solid insulator materials having only one kind of atom, the types of polarization which exist are
electronic only
electronic and ionic
electronic, ionic and permanent
electronic and permanent

⇒ Given below impulse response of two sys
h₁(n) non causal and stable
h₁(n) non causal and stable
h₁(n) causal and not stable
h₁(n) causal and stable

⇒ AB + AB =
B
A
1
0

⇒

Assertion (A): The conductivity of an n type semiconductor increases with increase in temperature and increase in density of donor atoms.

Reason (R): Diffusion of carriers occurs in semiconductors.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a ripple counter,
whenever a flip flop sets to 1, the next higher FF toggles
whenever a flip flop sets to 0, the next higher FF remains unchanged
whenever a flip flop sets to 1, the next higher FF faces race condition
whenever a flip flop sets to 0, the next higher FF faces race condition

⇒ The operator precedence in Java is in the order
arithmetic operation, increment and decrement operation, comprassion, logical operation and assignment operation.
increment and decrement operation, arithmetic operation, comparison, logical operation and assignment operation.
comparison, arithmetic operation, increment and decrement operation, logical operation and assignment operation.
arithmetic operation, comparison operation, increment and decrement operation, logical operation and assignment operation.

⇒ During amplitude modulation, the phase angle of the modulating voltage changes by
0°
45°
90°
180°

⇒ When two 16-input multiplexers drive a 2-input MUX, what is the result?
2-input MUX
4-input MUX
16-input MUX
32 input MUX

⇒ The reflection coefficient on a line is 0.2 ∠45°. The SWR is
0.8
1.1
1.2
1.5