Question is ⇒ Giga watt is equal to, Options are ⇒ (A) 1012 W, (B) 109 W, (C) 106 W, (D) 103 W, (E) , Leave your comments or Download question paper.

Question is ⇒ Giga watt is equal to, Options are ⇒ (A) 1012 W, (B) 109 W, (C) 106 W, (D) 103 W, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Giga watt is equal to
A.	10¹² W [Wrong Answer]
B.	10⁹ W [Correct Answer]
C.	10⁶ W [Wrong Answer]
D.	10³ W [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A DC voltage source is connected across a series R - L - C circuit. Under steady-state conditions, the applied DC voltage drops entirely across the
R only
C only
L only
R and L combination

⇒ A PC has typically
5 to 10 KB of main memory
10 to 100 KB of main memory
100 to 256 KB of main memory
256 KB to 1 MB of main memory

⇒ A series resonant circuit is fed by a voltage having rms value V. At resonance, the voltage across inductance V_L and voltage across capacitance V_C are related as
V_L > V_C
V_L < V_C
V_L = V_C
V_L = 0.5 V_C

⇒ Which antenna is frequently used for local area transmission at UHF/VHF?
Ground monopole
Turnstile antenna
Slot antenna
Loop antenna

⇒ Homodyne detection means
coherent detection
non-coherent detection
asynchronous detection
none of the above

⇒ Noise can be reduced by increasing sampling rate
TRUE
FALSE
can't say
insufficient data

⇒ When thyristors are connected in parallel, the current distribution may become non-uniform due to
inductive effect of current carrying conductors
capacitive effect of current carrying conductors
both inductive and capacitive effects
none of the above

⇒ As frequency is increased, the skin effect
increases
decreases
remains the same
either (b) or (c)

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ Given a power supply filter circuit, what measurements must be made of determine percentage regulation
current through and voltage across the capacitor
d.c. load voltage and r.m.s. load voltage
current through load and voltage across load resistance
number of turns and gauge of secondary winding of transformer

⇒ Which of the following is the main difference between waveguide and transmission line?
Waveguides cannot be coupled to coaxial lines
Waveguides have no standing wave ratio
Transmission line does not suffer from the effect of low cut off frequency
Waveguides are not distributed like transmission lines

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
0.3 V
0.5 V
1 V
1.5 V

⇒ Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because
it loads the circuit to maximum extent
it loads the circuit moderately
it does not load the circuit at all
it uses centre zero galvanometer instead of Voltmeters

⇒ In a series resonant circuit Q is more than 10. Then the lower half power frequency ω₁, and resonant frequency ω₀ are related as
ω₁ = ω₀ + bandwidth
ω₁ = ω₀ + 0.5 (bandwidth)
ω₁ = ω₀ - 0.5 (bandwidth)
ω₁ = ω₀ + bandwidth

⇒

Assertion (A): Linear ICs include audio amplifier, wideband amplifier, RF amplifier and IF amplifier

Reason (R): The error voltage in a feedback circuit is very small

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The polar plot of G(jω) = 1/jω is
positive imaginary axis
positive real axis
negative imaginary axis
negative real axis

⇒ A 4 line to 16 line decoder has
16 inputs and 4 outputs
4 inputs and 16 outputs
either (a) or (b)
neither (a) nor (b)

⇒ There is no hysteresis phenomenon is any dielectric material.
TRUE
FALSE

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ The response of a thermistor overs the whole of its temperatures range is
linear
non-linear
almost linear
either (a) or (c)

⇒ A dc separately excited motor has a constant field current. The armature is fed from a single phase supply through a semi-converter. When a = 0, speed is 600 rpm. If a = 90°, the speed is likely to be
about 300 rpm
about 150 rpm
about 75 rpm
about zero

⇒ Which one is correct statement?

Circuit is always open
Network is always open
Circuit is always closed
Network is always closed

1, 2
2, 3
3, 4
1, 4

⇒ Which of the following memory is preferred in case of calculators?
Dynamic RAM
Dynamic ROM
Static ROM
Static RAM

⇒ Which op-amp circuit uses a diode as one of the circuit components?
Integrating amplifier
Differentiating amplifier
Logarithmic amplifier
Summing amplifier

⇒ The number of channels in a stereophonic system is
8
4
2
1

⇒ For a microprocessor system using IO-mapped IO the following statement is NOT true
memory space available is greater
not all data transfer instructions are available
IO and memory address spaces are distinct
IO address space is greater

⇒ Two capacitors of 1 μF and 2 μF capacitance are connected in parallel across a 30 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be
30 μC each
60 μC each
30 μC and 60 μC respectively
60 μC and 30 μC respectively

⇒ Sound waves are electromagnetic waves.
TRUE
FALSE

⇒ An electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis is
synchro control transformer
LVDT
stepper motor
tacho generator

⇒ In 8085 microprocessor, what is the length of A-register?
6 bits
8 bits
12 bits
16 bits