Question is ⇒ Generally a servomotor operates at, Options are ⇒ (A) high torque and high speed, (B) low torque and low speed, (C) low torque and high speed, (D) high torque and low speed, (E) , Leave your comments or Download question paper.

Question is ⇒ Generally a servomotor operates at, Options are ⇒ (A) high torque and high speed, (B) low torque and low speed, (C) low torque and high speed, (D) high torque and low speed, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Generally a servomotor operates at
A.	high torque and high speed [Wrong Answer]
B.	low torque and low speed [Wrong Answer]
C.	low torque and high speed [Correct Answer]
D.	high torque and low speed [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Armstrong modulator generates
AM signals
FM signals
PM signals
both (b) and (c)

⇒ If R(t) is autocorrelation of a waveform v(t) and R(0) is autocorrelation for t = 0, then
R(0) > R(t)
R(0) ≥ R(t)
R(0) < R(t)
R(0) ≤ R(t)

⇒ A transistor amplifier with 85% efficiency is expected to be
class A
class B
class C
class AB

⇒ At t = 0⁺, the current i_{1- V/2R
- V/4R
- V/R
zero}

⇒ In a monolithic IC, resistors are formed from
ceramic material
manganin wire
P-type semiconductor
aluminium ribbon

⇒ A circuit which cannot demodulate SSB is
balanced modulator
product detector
BFO
phase discriminator

⇒ An e-mail message can be sent to many recipients.
TRUE
FALSE

⇒ When a reverse bias is applied to a p-n junction, the width of depletion layer.
decreases
increases
remains the same
may increase or decrease

⇒ Which synthesis procedure requires the use of mutual inductance?
Foster's synthesis
Cauer synthesis
Bott-Duffin synthesis
Brune's synthesis

⇒ Speech amplifiers are usually operated as
class A
classes AB
class B
class C

⇒ Orbital disturbances of a geosynchronous satellite are caused by the
moon
sun
earth
all of the above

⇒ A full wave diode rectifier using centre tapped transformer has diodes with forward resistance of 50 ohms each. The load resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulation is
0.2
0.5
1
2

⇒ The peak factor is the ratio of
peak and rms values
peak and average values
rms and average values
none of the above

⇒ As per Matthiessen's rule, the total resistivity r of a conductor can be written as r = r_i + aT, where r_i and a are constants and T is absolute temperature. At very low temperatures
aT = 0
aT > r_i
aT ∼ r_i
aT < r_i

⇒ The forbidden energy gap for silicon is
0.12 eV
1.12 eV
0.72 eV
7.2 eV

⇒ In 8085 the pins for + 5 V input and ground are
20 and 40 respectively
40 and 20 respectively
1 and 2 respectively
1 and 1 respectively

⇒ Insertion of a dielectric material between the plates of an air capacitor
increases the capacitance
decreases capacitance
has no effect an capacitance
increases breakdown voltage

⇒ In the wheatstone bridge in figure, each resistance is increased by 0.05%. The value of v₀ will
50 mV
5 mV
0.1 mV
zero

⇒ In figure, V_{020 V
10 V
5 V
0}

⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about
50 mV
60 mV
66 mV
80 mV

⇒ When p-n junction is reverse biased the holes in p material move towards the junction and electrons in n material move away from the junction.
TRUE
FALSE

⇒ In auxiliary commutated chopper, the peak value of thyristor current is
equal to peak value of load current
equal to peak value of capacitor current
sum of peak value of load current and capacitor current
none of the above

⇒ If f₁ (t) and f₂ (f) are two functions of time and a and b are constants, then
L [af₁(t) + bf₂(t)] = aF₁(s) + bF₂(s)
L [af₁(t) + bf₂(t)] = aF₁(s) - bF₂(s)
L [af₁(t) + bf₂(t)] =[aF₁(s)]/[bF₂(s]
None of the above

⇒ In the amplifier circuit figure the quiescent point voltage and current
12 V, 5 mA
12 V, 2 mA
10 V, 2 mA
10 V, 5 mA

⇒ Consider the following statements about DRAM

Page mode read operation is faster than RAS read
RAS input remains active during column address strobe
The row and column addresses are strobed into the internal buffers using RAS and CAS inputs respectively

Which of the above statements are correct?
1 and 3 only
All
1 and 2 only
2 and 3 only

⇒ e^-3^t is a
energy signal
power signal
Both (a) and (b)
none

⇒ A balanced modulator is used in the generation of which of the following?
DSB-SC signal
FM signal
PM signal
PAM signal

⇒ Which one of the following compounds is widely used for making ferrites?
FeO
CuO
MgO
Fe₂O₃

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ Which of following antenna does not depend upon the frequency?
Log-periodic
Parabolic
Conical
All of the above