Question is ⇒ F's complement of (2BFD)<sub>hex</sub> is, Options are ⇒ (A) E 304, (B) D 403, (C) D 402, (D) C 403, (E) , Leave your comments or Download question paper.

Question is ⇒ F's complement of (2BFD)<sub>hex</sub> is, Options are ⇒ (A) E 304, (B) D 403, (C) D 402, (D) C 403, (E) , Leave your comments or Download question paper. hex is, Options are ⇒ (A) E 304, (B) D 403, (C) D 402, (D) C 403, (E) , Leave your comments or Download question paper. '/> hex is, Options are ⇒ (A) E 304, (B) D 403, (C) D 402, (D) C 403, (E) , Leave your comments or Download question paper. '/>Previous question Next question


Q1.	F's complement of (2BFD)_hex is
A.	E 304 [Wrong Answer]
B.	D 403 [Wrong Answer]
C.	D 402 [Correct Answer]
D.	C 403 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Choose the correct option, if b (branch), n (nodes), l (links)
b = n + l - 1
no. of twig = n - 1
b = n - l + 1
b, a

⇒ Consider the following statement associated with bipolar junction transistor and JFET

The former has higher input impedance than the later
The former has higher frequency stability than the later
The later has lower noise figure than the former
The later has higher power rating than the former.

Of these statements
1 and 2 are correct
2 and 3 are correct
3 and 4 are correct
1 and 4 are correct

⇒ The number of inputs and outputs of a full adder are
3 and 2 respectively
2 and 3 respectively
4 and 2 respectively
2 and 4 respectively

⇒ In rectifier circuits, ripple factor RF and form factor FF are related as
RF = (FF² - 1)^0.5
RF = FF
RF = FF - 1
RF = (FF - 1)^0.5

⇒ The p mode of operation of magnetron signifies that
the phase difference between adjacent anode poles is p radians
the phase difference between adjacent anode poles is a multiple of p radians
the total phase shift around the periphery is p radians
none of the above

⇒ Fidelity of a receiver represents
the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output
the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies
the variation of the output with the modulation frequency when the output impedance is a resistance
none of the above

⇒ In figure, which value of Z_L will cause maximum power to be transferred to the l
2 + j2 Ω
2 - j2 Ω
- 2 Ω
2 Ω

⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R_E
decrease the voltage gain and decrease the I/P impedance
increase the voltage gain and decrease the I/P Impedance
decrease the voltage gain and Increase the I/P impedance
none of the above

⇒ The current through R₁ is(If β = 99, V_BE = 0.7
0.1 mA
0.35 mA
0.2 mA
none

⇒ In narrowband FM, the modulation index is
near unity
about 100
about 0.1
about 300

⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is
30 V
60 V
15 V
10 V

⇒ The depletion type MOSFET can operate in
depletion mode only
enhancement mode only
depletion or enhancement mode
neither depletion nor enhancement mode

⇒ In 8085 microprocessor, if instruction RST is written in a program then the program will jump to location
0020 H
0024 H
0028 H
002 CH

⇒ Push pull amplifier is
voltage amplifier
current amplifier
power amplifier
none of the above

⇒ The gain of a current element is
0 dB
1.67 dB
1.76 dB
3 dB

⇒ The zinc can of a dry cell serves as positive terminal.
TRUE
FALSE

⇒ An RL admittance function can also be realized as
RC admittance function
RC impedance function
LC admittance function
LC impedance function

⇒ Select the correct relation
∇(AB) = A ∇ B + B ∇ A
∇ . (AB) = ∇ A . B + A ∇ B
∇ x (AB) = ∇ A x B + A ∇ B
All of the above

⇒ In a D latch
data bit D is fed to S input and D to R input
data bit D is fed to R input and D to S input
data bit D is fed to both R and S inputs
data bit D is not fed to any input

⇒ For the circuit shown in the figure, the current
indeterminate due to indeterminate data
zero
4 Amp
8 Amp

⇒ In a CRO the Y plates are oriented
horizontally
vertically
at an angle of 20° of horizontal
at an angle of 70° of horizontal

⇒ For a BJT, avalanche multiplication factor depends on
V_CE
V_CB
V_BE
none

⇒ Ferromagnetic materials exhibit
a linear B-H behaviour
a non-linear B-H behaviour
an exponential B-H behaviour
none of the above

⇒ What happens when a paramagnetic material is heated above Curie temperature?
It becomes diamagnetic
It becomes nonmagnetic
It becomes ferromagnetic
It becomes anti-ferromagnetic

⇒

Assertion (A): Acceptor extrinsic semiconductor has higher conductivity than intrinsic semiconductor.

Reason (R): Addition of p-type impurity produces an allowable discrete energy level just above valence band.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ For a hollow waveguide, the axial current must necessarily be
combination of conduction and displacement current
conduction current only
time varying conduction current and displacement current
displacement current only

⇒ The pole-zero plot given below corresponds
low pass filter
high pass filter
band pass filter
notch filter

⇒ Which of the following directives in 8085 causes one byte to be reserved in the memory?
D S
D B
D W
E Q U

⇒ How much r.m.s. current does a 300 W, 200 V bulb take from the 200V, 50 Hz power line?
0.5 A
1.5 A
0.0833333333333333
0.125

⇒ A signal m(t) = 5 cos 2p 100 t frequency modulates a carrier. The resulting FM signal
0.1 kHz
6 kHz
3.2 kHz
100 kHz