Question is ⇒ Frequency range for satellite communication is, Options are ⇒ (A) 1 kHz to 100 kHz, (B) 100 kHz to 10 MHz, (C) 10 MHz to 100 MHz, (D) 1 GHz to 30 GHz, (E) , Leave your comments or Download question paper.

Question is ⇒ Frequency range for satellite communication is, Options are ⇒ (A) 1 kHz to 100 kHz, (B) 100 kHz to 10 MHz, (C) 10 MHz to 100 MHz, (D) 1 GHz to 30 GHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Frequency range for satellite communication is
A.	1 kHz to 100 kHz [Wrong Answer]
B.	100 kHz to 10 MHz [Wrong Answer]
C.	10 MHz to 100 MHz [Wrong Answer]
D.	1 GHz to 30 GHz [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As compared to a p-n junction diode
a schottky diode has lower cut in voltage and lower reverse saturation current
a schottky diode has higher cut in voltage and higher reverse saturation current
a Schottky diode has lower cut in voltage and higher reverse saturation current
a schottky diode has higher cut in voltage and lower reverse saturation current

⇒ For the 8085 assembly language program given below, the content of the accumulator after the execution of the progra
00H
45H
67H
E7H

⇒ In the circuit shown in figure, maximum power will be transferred
Z_L = 13 - j 9
Z_L = 13 + j 9
Z_L = 9 - j 13
Z_L = 9 + j 13

⇒

Match the following:

	List I		List II
A.	RF amplifier	1.	Amplifier received carrier and sidebands
B.	Loudspeaker	2.	Gives acoustic output
C.	Demodulator	3.	Has IF input and AF output
D.	IF amplifier	4.	Fixed-tuned to intermediate frequency

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-3, B-4, C-1, D-2
A-1, B-4, C-3, D-2

⇒ Four messages band limited to W, W, 2W and 3W respectively are to be multiplex using Time Division Multiplexing (TDM). The minimum bandwidth required for transmission of this TDM signal is
W
3W
6W
7W

⇒ The Fourier series of a real periodic function has only

Cosine terms if it is even
Sine terms if it is even
Cosine terms if it is odd
Sine terms if it is odd

Which of the above statements are correct?
(1) and (4)
(1) and (2)
(2) and (4)
(2) and (3)

⇒ In a conductor the conduction and valence bands overlap
TRUE
FALSE

⇒ Which of the following logic no resistors are used?
CMOS
TTL
4 n sec ECL
8 sec ECL

⇒ In transistor radio receivers the number of IF amplifier stages are
1
2
4
6

⇒ In 8085 eight address and data buses are multiplexed.
TRUE
FALSE

⇒ In figure, the reading of wattmeter will be proportio
V I cos θ
3 VI cos θ
3 VI sin θ
V I sin θ

⇒

Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.

Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Consider an arbitrary distribution of conducting bodies in a charge free space according to the uniqueness theorem, which of following are required to be specified in order that the field is uniquely determined everywhere?

Total charge on each conductor
Potential at each conductor surface
Potential at same of conductor and total charge on the remainder
Total charge as well as potential gradient on each conductor surface

Select the correct answer using the codes given below codes
1 and 3
2 and 4
1, 2, and 3
1, 2, 3, 4

⇒ A DIAC has two terminals, anode and cathode.
TRUE
FALSE

⇒

Assertion (A): Thermocouple instruments can be used for ac only.

Reason (R): Thermocouple instrument has a non linear scale.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A padder is basically a/an
insulator
variable resistor
capacitor
inductor

⇒ The number of digit 1 present in the binary representation of 3 x 512 + 7 x 64 + 5 x 8 + 3 is
8
9
10
12

⇒ Analysis of EM wave in waveguide based on
circuit theory
field theory
optical theory
both (a) and (b)

⇒ EPROM can be
UVPROM
EEPROM
both UVPROM and EEPROM
none of the above

⇒ Z_L = 200 Ω and it is desired that Z_i = 50 Ω The quarter wave transformer should have a characteristic impedance of
100 Ω
40 Ω
10000 Ω
4 Ω

⇒ A current of 3.18 A is flowing through resistance of 35.68 Ω. The voltage drop across resistance to the appropriate number of significant figures is
113.4624 V
113.462 V
113.46 V
113 V

⇒ To realize the full power of 8086 the pin of 8086 connected to ground is
DEN
ALE
INTR
MN / MX

⇒ A Hartley oscillator is used for
very low frequencies
radio frequencies
micro wave frequencies
audio frequency

⇒ All magnetic materials exhibit the phenomenon of saturation.
TRUE
FALSE

⇒ In a transistor I_E = 10 mA, I_CO = 0.5 μA and a = 0.995. Then I_CEO =
100 μA
25 μA
10.1 mA
10.5 mA

⇒ A resistor is rated at 0.75 watt, 1 kΩ. Its current rating is
1 mA
27.386 mA
1.268 mA
5.393 mA

⇒ Consider the following program for 8085 decimal 20
decimal 40
decimal 10
none of the above

⇒ In a push pull circuit
each transistor conducts for 180°
each transistor conducts for more than 180° but less than 360°
each transistor conducts for less than 180°
the period of conduction of each transistor depends on circuit configuration

⇒ The number of FF required for a divide by 12 circuit is
16
12
8
4

⇒ The network of the given figure
lag network
lead network
lag-lead network
any of the above