Question is ⇒ Four wires of same material, the same cross-sectional area and the same length when connected in parallel give a resistance of 0.25 ω. If the same four wires are connected is series the effective resistance will be, Options are ⇒ (A) 1 ω, (B) 2 ω, (C) 3 ω, (D) 4 ω, (E) , Leave your comments or Download question paper.

Question is ⇒ Four wires of same material, the same cross-sectional area and the same length when connected in parallel give a resistance of 0.25 ω. If the same four wires are connected is series the effective resistance will be, Options are ⇒ (A) 1 ω, (B) 2 ω, (C) 3 ω, (D) 4 ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Four wires of same material, the same cross-sectional area and the same length when connected in parallel give a resistance of 0.25 ω. If the same four wires are connected is series the effective resistance will be
A.	1 ω [Wrong Answer]
B.	2 ω [Wrong Answer]
C.	3 ω [Wrong Answer]
D.	4 ω [Correct Answer]
View Answer 9 -16 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Resistance of a material always decreases if
temperature of material is decreased
temperature of material is increased
number of free electrons available become more
none of the above is correct

⇒ How are 500 ω resistors connected so as to give an effective resistance of 750 ω ?
Three resistors of 500 ω each, in parallel
Three resistors of 500 ω each, in series.
Two resistors of 500 ω each, in parallel.
Two resistors of 500 ω each, in parallel and the combination in series with another 500 ω resistor.

⇒ The temperature coefficient of resistance of some material is negative. The material is
Copper
Aluminium
Iron
Gennanium

⇒ Two resistors R1 and R2 give combined resistance of 4.5 ω when in series and 1 ω when in parallel, the resistances are
2 ω and 2.5 ω
1 ω and 3.5 ω
1.5 ω and 3 ω
4 ω and 0.5 ω

⇒ With rise in temperature the resistance of semi-conductors
decreases
increases
first increases and then decreases
remains constant

⇒ For determining the polarity of the voltage drop across a resistor, it is necessary to know the
value of resistor.
value of current.
direction of current flowing through the resistor.
value of emf in the circuit.

⇒ The resistance of a few metres of wire conductor in closed electrical circuit is (a) practically zero (b) low
practically zero
low
high
very high

⇒ The resistance of a parallel circuit consisting of two branches is 12 ohms. 1f the resistance of one branch is 18 ohms, what is the resistance of the other?
18 ω
36 ω
48 ω
64 ω

⇒ Which of tite following materials has the least resistivity?
Zinc
Lead
Mercury
Copper

⇒ The temperature-coefficient of resistance of conductors is
Positive
Negative
Neutral
First A then C

⇒ A closed switch has a resistance of
zero
about 50 ohms
about 500 ohms
infinity

⇒ Temperature co-efficient of resistance is expressed in terms of
obms/°C
mhos/ohm°C
ohms/ohm°C
mhos/°C

⇒ With rise in temperature the resistance of pure metals
increases
decreases
first increases and then decreases
remains constant

⇒ The insulation resistance of a cable of length 10 km is 1 Mega Ohm's. For a length of 100 km of same cable, the insulation resistance will be
1 Mega Ohm
10 Mega Ohm
0.1 Mega Ohm
0.01 Mega Ohm

⇒ Resistance of a wire always increases if
temperature is reduced.
temperature is increased.
number of free electrons available become less.
number of free electrons available become more.

⇒ Three resistances of 10 ohms, 15 ohms and 30 ohms are connected in parallel. The total resistance of the combination is
5 ohms
10 ohms
15 ohms
55 ohms

⇒ An open resistor, when checked with an ohm-meter reads
zero
infinite
high but within tolerance
low but not zero

⇒ Twelve 1 ω resistance are used as edges to form a cube. The resistance between two diagonally opposite corners of the cube is
5/6 ω
1 ω
6/5 ω
3/2 ω

⇒ N equal resistances are first connected in series and then connected in parallel. What is the ratio of the maximum to the minimum resistance ?
n
¹
^n²

n²
¹/_n

⇒ A rheostat differs from potentiometer in the respect that it
has lower wattage rating
has higher wattage rating
has large number of turns
offers large number of tappings

⇒ A 3 ω resistor having 2 A current will dissipate the power of
2 watts
4 watts
6 watts
8 watts

⇒ The resistance of two wires is 25 ω when connected in series and 6 ω when joined in parallel. The resistance of each wire is
10 ω, 15 ω
20 ω, 30 ω
5 ω, 10 ω
10 ω, 20 ω

⇒ With three resistances connected in parallel, if each dissipates 20 W the total power supplied by the voltage source equals
10 W
20 W
40 W
60 W

⇒ Four wires of same material, the same cross-sectional area and the same length when connected in parallel give a resistance of 0.25 ω. If the same four wires are connected is series the effective resistance will be
1 ω
2 ω
3 ω
4 ω

⇒ Four resistances 80 ω, 50 ω, 25 ω and R are connected in parallel. Current through 25 ω resistance is 4 A. Total current of the supply is 10 A. The value of R will be
66.66 ω
40.25 ω
36.36 ω
76.56 ω

⇒ The resistance of a conductor varies inversely as
length
area of cross-section
temperature
resistivity

⇒ A thermistor has
positive temperature coefficient
negative temperature coefficient
zero temperature coefficient
variable temperature coefficient

⇒ A resistance having rating 10 ohms, 10 W is likely to be a
metallic resistor
carbon resistor
wire wound resistor
variable resistor

⇒ Which of the following is an ohmic conductor?
Transistors
Thermionic valves
Constanton
Electrolyte

⇒ If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes
0.4 ohm
0.6 ohm
0.8 ohm
1.0 ohm