Question is ⇒ Four terminal approach is used in measuring low resistance because it, Options are ⇒ (A) eliminates thermoelectric energy, (B) eliminates stray capacitance, (C) eliminates stray inductance, (D) eliminates the effect of leads and contacts, (E) , Leave your comments or Download question paper.

Question is ⇒ Four terminal approach is used in measuring low resistance because it, Options are ⇒ (A) eliminates thermoelectric energy, (B) eliminates stray capacitance, (C) eliminates stray inductance, (D) eliminates the effect of leads and contacts, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Four terminal approach is used in measuring low resistance because it
A.	eliminates thermoelectric energy [Wrong Answer]
B.	eliminates stray capacitance [Wrong Answer]
C.	eliminates stray inductance [Wrong Answer]
D.	eliminates the effect of leads and contacts [Correct Answer]
View Answer 4 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The question below consists of a pair of related words followed by four pairs of words. Select the pair that best expresses the relation in the original p
fallow : land
unaware : sleeper
wit : jester
renovated : house

⇒

Assertion (A): The resistivity of intrinsic semiconductor decreases with increase in temperature.

Reason (R): The forbidden gap decreases with increase in temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The temperature coefficient of a thermistor
is positive
is negative
zero
may be positive or negative depending on its composition

⇒ The classes of solid dielectrics are
A, B, C, D, E, F, H
A E B F H C D
Y A E B F H C
A E B F H C

⇒ Maximum power from a source having internal resistance R_i is delivered to a resistive load R_L, if
R_i > R_L
R_i < R_L
R_i = R_L²
R_i = R_L

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒ Figure shows a chopper feeding RLE load, The free wheeling diode conducts w
thyristor is on
thyristor is off
both when thyristor is on and thyristor is off
partly when thyristor is off and partly when thyristor is on

⇒ Which dc servomotor requires strongest permanent magnet?
Slotted armature
Surface wound armature
Surface wound with stationary rotor
Either (a) or (b)

⇒ BPSK stands for
Binary Phase Shifting Key
Broad Phase Shifting Key
Bit Phase Shifting Key
Binary Pulse Shifting Key

⇒ One ampere means the flow of
One coulomb each minute
One electron per second
One coulomb per second
One coulomb each hour

⇒

Assertion (A): The condition of minimum distortion in a transmission line is L = RC/G.

Reason (R): Line loading means addition of inductance to satisfy the condition L = RC/G.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The sinusoidally time varying vector fi
elliptically polarized
circularly polarized
linearly polarized
unpolarized

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒

Assertion (A): In microprocessor 8085 instruction LXIB, 90 FF H means register B and C are loaded with upper and lower bytes to get B = 90 H and C = FFH.

Reason (R): In 8085 the stack pointer indicates which memory location is to accessed.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The assigned carrier frequency of an FM broadcast station is 96.3 MHz. Its FM signal has a centre frequency of
10 MHz
455 kHz
48.15 MHz
96.3 MHz

⇒

Match the following:

	List I		List II
A.	C	1.	7 eV
B.	Si	2.	1.15 eV
C.	Ge	3.	0.75 eV
D.	Sn	4.	0.1 eV
E.	Pb	5.	0 eV

A-2, B-3, C-4, D-5, E-1
A-1, B-2, C-3, D-4, E-5
A-3, B-1, C-2, D-5, E-4
A-4, B-5, C-1, D-2, E-3

⇒ In a resistance loaded, RC coupled amplifier the d.c. component is blocked by
Transistor
C_C
R_B
R_C

⇒

Assertion (A): Millman's theorem helps in replacing a number of current sources in parallel by a single current source.

Reason (R): Maximum power transfer theorem is applicable only for dc, circuits.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which one of following is correct condition to check the stability of sysytem in terms of impulse response?
Σ(x(n)) < ∞
Σx(n) < 0
Σx(n) = 0
Σx(n) = ∞

⇒ In a radio receiver, if the intermediate frequency is too low
Image-frequency rejection will improve
Selectivity will be too sharp
The frequency selectivity of the local oscillator will have to be lowered
All of the above

⇒ Consider the following statements as regards advantages of CCD sensors as camera pick up tube

High sensitivity
Good spectral response
Image lag absent

Out of the above which are correct
1, 2, 3
1, and 2 only
1 and 3 only
2 and 3 only

⇒ In figure, R = 20KΩ and C = 75 pF. The converter clock frequency wil
606 Hz
1212 Hz
555 KHz
606 KHz

⇒ Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?
Variable tuning inductor
Ganged tuning inductor
Variable capacitor
Variable preset

⇒ As per BIS, the number of accuracy classes of instrument is
5
6
7
8

⇒ In some on-off controllers a differential gap is provided
to make the manufacture process easier
to prevent too often frequent operation of controller
both (a) and (b)
neither (a) nor (b)

⇒ A load Z_L = R_L + jX_L is to be matched using an ideal transformer to generator of internal impedance Z_S = R_S + jX_S. The ratio of transformer required is __________ .
|Z_S|/|Z_L|
R_L/R_S
R_L/Z_S
|Z_L|/R_S

⇒ In a p type material the Fermi level is 0.3 eV above valence band. The concentration of acceptor atoms is increased. The new position of Fermi level is likely to be
0.5 eV above valence band
0.28 eV above valence band
0.1 eV above valence band
below the valence band

⇒ Which of the following can be used as a rotating amplifier in a control system?

Amplidyne
Separately excited dc generator
Synchro
Self excited dc generator

Select the answer from the following codes:
3 and 4
1 and 2
1, 2 and 3
all

⇒ According to Siegel and Labus, antenna can be treated as
closed transmission line
shorted transmission line
earthed transmission line
opened-out transmission line

⇒ In Pascal if I = 55, 10 * I div 10 =
55
50
5.5
5