Question is ⇒ Four memory chips of 16 x 4 size have their address buses connected together. This system will be of size, Options are ⇒ (A) 64 x 4, (B) 16 x 16, (C) 32 x 8, (D) 256 x 1, (E) , Leave your comments or Download question paper.

Question is ⇒ Four memory chips of 16 x 4 size have their address buses connected together. This system will be of size, Options are ⇒ (A) 64 x 4, (B) 16 x 16, (C) 32 x 8, (D) 256 x 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Four memory chips of 16 x 4 size have their address buses connected together. This system will be of size
A.	64 x 4 [Wrong Answer]
B.	16 x 16 [Correct Answer]
C.	32 x 8 [Wrong Answer]
D.	256 x 1 [Wrong Answer]
View Answer 3 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The K-map for a Boolean function is shown in figure. The number of essential prime implicants for this functio
4
5
6
8

⇒ Geosynchronous communication satellites travel around the earth in circular orbits with a forward speed of about __________ km/h.
11200
0
36000
22800

⇒ Which of these is used in seven segment display?
PIN diode
LED
Photo diode
Tunnel diode

⇒ The stack is a specialized temporary __________ access memory during __________ and __________ instructi
random, store, load
random, push, load
sequential, store, pop
sequential, push, pop

⇒ The system shown in figure remains stable wh
k £ - 1
-1 < k < 1
l < k < 3
k > 3

⇒ The Boolean expression for the circuit of the given fi
A {F + (B + C) (D + E)}
A [F + (B + C) (DE)]
A + F + (B + C) (D + E)]
A [F + (BC) (DE)]

⇒ The current in a circuit with 10 Ω resistance is i = 3 + 4 sin (100 t + 45°) + 4 sin (300 t + 60°) A. The rms current and power dissipated are
41 A and 410 W
35 A and 350 W
5 A and 250 W
11 A and 1210 W

⇒ Consider the following statements

Acceptor level lies close the valence band.
Donor level lies close to the valence band.
n type semiconductor behaves as an insulator at 0 K.
p type semiconductor behaves as an insulator at 0 K.

Of these statements:
2 and 3 are correct
1 and 3 are correct
1 and 4 are correct
3 and 4 are correct

⇒ A class E chopper
can operate in second quadrant only
can operate in first or third quadrant
can operate in all the four quadrants
can operate in either second or third quadrant

⇒ The circuit in the given figur
half adder
full adder
half subtractor
full subtractor

⇒ Television transmission is by
ground waves
sky waves
space waves
all of the above

⇒ An air gap provided in the iron core of an inductor prevents
flux leakage
hysteresis loss
core saturation
heat generation

⇒ Calculate wave impedance for TE mode
(377)Ω
226 Ω
∞
629 Ω

⇒ In a flash type ADC, employing 15 comparators resolution with 10 volts reference; is expected to be :
0.625 V
0.656 V
0.525 V
insufficient data

⇒ An advantage of memory interlacing is that
a larger memory is obtained
effective speed of memory is increased
cost of memory is reduced
a non-volatile memory is obtained

⇒ A 555 timer can be used as
an astable multivibrator
monostable multivibrator
frequency Divider only
any of the above

⇒ A complex wave is 5 + 5 sin ωt. Its rms value is
7.07 V
5 V
10 V
6.12 V

⇒ The signal to noise ratio in telemetry should be better than
5 db
10 db
25 db
60 db

⇒ When a substance is repelled by a magnetic field it is known as
ferromagnetic
antiferromagnetic
diamagnetic
paramagnetic

⇒

Match the following:

	List I (Functional components)		List II (Device)
A.	Error detector	1.	Three phase FHP Induction motor
B.	Servo motor	2.	Synchro transmitter and control transformer
C.	Amplifier	3.	Tacho generator
D.	Feed back	4.	Armature controlled FHP dc motor
		5.	Amplidyne

A-2, B-4, C-1, D-5
A-4, B-2, C-5, D-3
A-2, B-4, C-5, D-3
A-1, B-2, C-3, D-5

⇒ The mobility of e^- for Ge and Si respectively is
1.66, 2.5
2.5, 1.66
2.7, 2.33
2.33, 2.7

⇒ The two modes of operation of three phase bridge inverters are known as
60° mode and 120° mode
90° mode and 120° mode
120° mode and 180° mode
120° mode and 240° mode

⇒ Which among the following waveforms can be reconstructed from its samples without distort
1 and 2
2 and 3
1 and 3
Only 2

⇒ In a uniformly doped BJT, assume that N_E, N_B and N_C are the emitter, base and collector dopings in atoms/cm³, respectively. If the emitter injection efficiency of the BJT is close unity, which one of the following conditions is TRUE?
N_E = N_B = N_C
N_E >> N_B and N_B > N_C
N_E = N_B and N_B < N_C
N_E < N_B < N_C

⇒ In figure, the current after a long time after closing of switc
0.0416666666666667
0.0833333333333333
0
infinity

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The mean free path of conduction electrons in copper is about 4 x 10^-8 m. For a copper block, find the electric field which can give, on an average, 1 eV energy to a conduction electron
2.62 x 10⁷ V/m
2.64 x 10⁷ V/m
2.5 x 10⁷ V/m
2.58 x 10⁷ V/m

⇒ Which of the following is true as regards telephone systems?
A larger facility carrying a larger load operates less efficiently than a smaller capacity
A larger facility carrying a lesser load operates more efficiently than a smaller capacity
A larger facility carrying a larger load operates more efficiently than a smaller capacity
A smaller capacity carrying a larger load operates more efficiently than a larger capacity

⇒

Assertion (A): In state space analysis, capacitors are taken to be in tree.

Reason (R): State variable analysis is very suitable for computer solution.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For signal diodes the PIV rating is usually in the range
1 V to 10V
10 V to 30V
30 V to 150V
150 V to 400V