Question is ⇒ Form factor is the ratio of, Options are ⇒ (A) Average value/r.m.s. value, (B) Average value/peak value, (C) r.m.s. value/average value, (D) r.m.s. value/peak value, (E) , Leave your comments or Download question paper.

Question is ⇒ Form factor is the ratio of, Options are ⇒ (A) Average value/r.m.s. value, (B) Average value/peak value, (C) r.m.s. value/average value, (D) r.m.s. value/peak value, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Form factor is the ratio of
A.	Average value/r.m.s. value [Wrong Answer]
B.	Average value/peak value [Wrong Answer]
C.	r.m.s. value/average value [Correct Answer]
D.	r.m.s. value/peak value [Wrong Answer]
View Answer 12 -5 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A resonance curve for a series circuit is a plot of frequency versus
Current
Voltage
Impedance
Reactance

⇒ A heater is rated as 230 V, 10 KW, AC. The value 230 V refers t
Average voltage
r.m.s. voltage
Peak voltage
None of these

⇒ The power factor at resonance in RLC parallel circuit is
Zero
0.08 Lagging
0.8 Leading
Unity

⇒ All the rules and laws of D.C. circuit also supply to A.C. circuit containing
Capacitance only
Inductance only
Resistance only
All above

⇒ Which of the following waves has the highest value of peak factor '?
Square wave
Sine wave
Half wave rectifier sine wave
Triangular wave

⇒ The r.m.s. value of a sine wave is 100A. Its peak value is
70.7 A
141.4A
150A
282.8 A

⇒ At half power points of a resonance curve, the current is____ times the maximum current.
1/2
1/ √2
√2
2

⇒ The capacitors for power factor correction are rated in terms of
Voltage
VA
kW
kVAR

⇒ The voltage of domestic supply is 220 V. This figure represents-
Mean value
r.m.s. value
Peak value
Average value

⇒ Power factor of an inductive circuit is usually improved by connecting capacitor to it in
Parallel
Series
Either (A) or (B)
None

⇒ The power is measured in terms of decibles in case of
Electronic equipment
Transformers
Current transformers
Auto-transformers

⇒ The ratio of active power to apparent power is known as ____ factor.
Demand
Load
Power
Form

⇒ The shunt element of prototype high pass filter is
Resistive
Inductive
Capacitive
Combination of L and C

⇒ The shunt element in a band pass filter is
Capacitive
Inductive
Parallel combination of L and C
Series combination of L and C

⇒ For the same peak value which of the following wave will have the highest r.m.s. value ?
Square wave
Half wave rectified sine wave
Triangular wave
Sine wave

⇒ In A.C. circuit laminated iron is invariably used in order to
Reduce eddy current loss
Increase heat radiation
Make assembly cheap and easier
Reduce circuit permeability

⇒ The unit of frequency of an A.C. signal is
Cycle
Cycle-sec
Hertz
Hertz/sec

⇒ The form factor of D.C. supply voltage is always
Zero
0.5
Unity
Infinite

⇒ The negative maximum of a cosine wave occurs at
30
45
90
180

⇒ The safest value of current the human body can carry for more than 3 second is
4 mA
9 mA
15 mA
25 mA

⇒ The power consumed in a circuit element will be least when the phase difference between the current and voltage
180°
90°
60°
0°

⇒ The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of____ degrees
90
60
45
30

⇒ Capacitors for power factor correction are rated in
kW
kVA
kV
kVAR

⇒ When an alternating current passes through an ohmic resistance the electrical power converted into heat is
Apparent power
True power
Reactive power
None of the above

⇒ Two sinusoidal quantities are said to be phase quadrature, when their phase difference is
0
30°
45°
90°

⇒ A network is said to be non-linear if it does not satisfy
Homogeneity condition
Superposition condition
Both (A) and (B)
Associative condition

⇒ Higher the Q of a series circuit
Broader its resonance curve
Narrower its pass band
Greater its band width
Sharper its resonace

⇒ For the same peak value, which of the following wave has the least mean value ?
Half wave rectified sine wave
Triangular wave
Sine wave
Square wave

⇒ The best place to install a capacitor is
Very near to inductive load
Across the terminals of the inductive load
Far away from the inductive load
Any where

⇒ Skin effect occurs when a conductor carries current at____ frequencies.
Very low
Low
Medium
High