Question is ⇒ Forbidden energy gap in germanium at 0 K is about, Options are ⇒ (A) 10 eV, (B) 5 eV, (C) 2 eV, (D) 0.78 eV, (E) , Leave your comments or Download question paper.

Question is ⇒ Forbidden energy gap in germanium at 0 K is about, Options are ⇒ (A) 10 eV, (B) 5 eV, (C) 2 eV, (D) 0.78 eV, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Forbidden energy gap in germanium at 0 K is about
A.	10 eV [Wrong Answer]
B.	5 eV [Wrong Answer]
C.	2 eV [Wrong Answer]
D.	0.78 eV [Correct Answer]
View Answer 3 -11 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Two sinusoidal signals of same amplitude and frequencies 10 kHz and 10.1 kHz are added together. The combined signal is given to an ideal frequency detector. The output of the detector is
0.1 kHz sinusoidal
10.1 kHz sinusoidal
a linear function
a constant

⇒ The disadvantage of FET over BJT is
poor high frequency performance
low power-handling ability
low values of voltage gain
all of the above

⇒ Decimal -90 equals __________ in 8 bit 2s complement
1000 1000
1010 0110
1100 1100
0101 0101

⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 1 GHz is about
100°
50°
5°
2°

⇒ If ROC of x[n] is R₁ then ROC of aⁿ x[n] is
R₁a
R₁/a
a/R₁
R₁ + a

⇒ In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
class A
class B
class C
class AB

⇒ In case of stabilized reactance modulator AFC system
phase modulator is converted into frequency modulation by equalizer circuit
the discriminator must have a fast time constant to provide demodulation
the higher discriminator frequency, the better oscillator frequency
the discriminator frequency must be too low, or the system will fail

⇒ The sum of positive real functions
is a positive real function
may be a positive real function or not
can not be a positive real function
either (b) or (c)

⇒ Which of the following pairs of semiconductors and current carriers is correctly matched?
Intrinsic : number of electrons = number of holes
P type : number of electrons > number of holes
N type : number of electrons < number of holes
Bulk : neither electrons nor holes

⇒ A bypass capacitor produces
dc ground
ac ground
both dc and ac ground
none of the above

⇒ Which statement is true for an ac circuit?
Active power is always less than apparent power
Active power cannot be more than apparent power
Active power is always more than reactive power
Active power cannot be more than reactive power

⇒ The statement that the line integral of magnetic field about any closed path is exactly equal to the direct current enclosed by that path, is known as
Ampere's circuital law
Coulomb's law
Electrostatic's theory
None of the above

⇒ A two port network is symmetrical if
z₁₁ z₁₂ - z₁₂ z₂₁ = 1
AD - BC = 1
h₁₁ h₂₂ - h₁₂ h₄₁ = 1
y₁₁ y₂₂ = y₁₂ y₂₁ = 1

⇒ In case of low level amplitude modulation system, the amplifiers following the modulated stage must be
class C amplifiers
linear devices
non-linear devices
harmonic devices

⇒ A wavelength of 1 mm could be expected in
VLF
HF
EHF
SHF

⇒

Assertion (A): The maximum efficiency of a class B push pull amplifier is 78.5%

Reason (R): A current mirror uses a compensating diode in parallel with the emitter diode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Consider the following statements about Yagi Uda antenna

It is unidirectional
Its gain is about 7 dB
It is used at VLF
The optimum separation is 0.11

Which of the above are correct?
1 and 2 only
1, 2, 4 only
1, 2, 3, 4
1 and 4 only

⇒ Typical switching time for ECL is
5 nano seconds
5 micro seconds
5 milli seconds
5 seconds

⇒ The circuit in figur
Cauer I form
Foster I form
Cauer II form
Foster II form

⇒ Which of the following directives in 8085 causes two bytes to be reserved in the memory?
D S
D B
D W
E Q U

⇒ Which material is generally used for LED?
Compounds of silica
Compounds of gallium
Compounds of phosphorus
Compounds of sulphur

⇒ The pole zero diagram of an impedance Z has a pole at s = - 6 and zero at s = - 4 as shown in figure the constant multiplier k = 1. For a signal I_s = cos 6t, the steady state voltage across Z is given in magnitude as u
0.6
0.84
7.2
none

⇒ RAMs can be built with bipolar or CMOS transistor RAMs that are not possible with bipolar transistors are
SRAM
SRAM, DRAM
DRAM
PROM

⇒ A carrier signal at frequency 100 MHz is frequency modulated with modulation index 2 by a signal at 2 kHz. At what frequencies are the sidebands produced?
102 MHz and 98 Mhz
100 MHz + 2 kHz, 100 MHz - 2 kHz
100 MHz ± Δf_d where f_d is frequency deviation
100 MHz ± 3n kHz, where n is 1, 2, ... S integer

⇒ Selectivity varies with receiving frequency, frequency is raised.
Somewhat better when the receiving frequency is raised
Somewhat better at intermediate frequency
Somewhat worse when the receiving frequency is lowered
Somewhat worse when the receiving frequency is raised

⇒ When the phase velocity of an EM wave depends on frequency in any medium, the phenomenon is called
scattering
polarization
absorption
dispersion

⇒ Values of V_T at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV

⇒ Consider the following statements regarding sources or error in a Q-meter:

If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.
If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.
The presence of distributed capacitance in a coil modifies the effective Q of the coil.

Which of the above statements are correct?
1, 2 and 3
1 and 2 only
2 and 3 only
1 and 3 only

⇒ In a computer the instructions, data, intermediate and final results during processing are held in ALU.
TRUE
FALSE

⇒ The pinch-off voltage is the drain voltage on the shorted gate drain curve above which the drain current becomes
almost negligible
very high
almost constant
highly variable