Question is ⇒ For wired AND connection we should use, Options are ⇒ (A) TTL gates with active pull up, (B) TTL gates with open collector, (C) TTL gates without active pull up and with open collector, (D) any of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ For wired AND connection we should use, Options are ⇒ (A) TTL gates with active pull up, (B) TTL gates with open collector, (C) TTL gates without active pull up and with open collector, (D) any of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For wired AND connection we should use
A.	TTL gates with active pull up [Wrong Answer]
B.	TTL gates with open collector [Wrong Answer]
C.	TTL gates without active pull up and with open collector [Correct Answer]
D.	any of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Program counter in a digital computer
counts the number of program run in the machine
counts the number of times a subroutine is called
counts the number of times the loops are executed
points the memory address of the current or the next instruction to be executed

⇒ Nickel is a non-magnetic material.
TRUE
FALSE

⇒ A rare gas having N atoms/m³ is subjected to an electric field E. The electric dipole moment per unit volume is proportional to N and E.
TRUE
FALSE

⇒ As compared to a BJT amplifier circuit, a JFET amplifier circuit
has low input impedance
has high input impedance
has very low input impedance
may have either low or high input impedance

⇒ The time constant of the network shown in figur
2 RC
5/3 RC
RC/2
None of these

⇒ The dynamic equalising circuit consists of a series combination of capacitor C and resistor R_C across each thyristor. This resistance R_C (along with parallel connected diode)
limits charging current
limits discharging current
limits both charging and discharging currents
none of the above

⇒ In figure, the switch has been in closed position for a long time. At t = 0, the switch is opened. At t = 0⁺, the current R_{10.333333333333333
0.166666666666667
0.25
0.0833333333333333}

⇒ The access time of a word in 4 MB main memory is 100 ms. The access time of a word in a 32 kb data cache memory is 10 ns. The average data cache bit ratio is 0.95. The efficiency of memory access time is
9.5 ns
14.5 ns
20 ns
95 ns

⇒ Consider a baseband binary PAM receiver shown below. The additive channel noise n(t) is whit with power spectral density S_N(f) = N₀/2 = 10^-20 W/Hz. The low-pass filter is ideal with unity gain and cutoff frequency 1 MHz. Let Y_k represent the random variable y(t_k10¹⁰
10⁷
1.414 x 10^-10
2 x 10^-20

⇒ Consider the following statements for 8085
The most significant 8 bits of address are transmitted on the 8 lines on which data is transmitted.
Eight pins are dedicated to transmit the most significant 8 bits of memory address.
The least significant 8 bits of address are transmitted on the lines on which data is transmitted.
The data and leass significant 8 bits are transmitted at different points in time.
Which of the above statements are correct?
all
1, 2 and 3 only
2, 3 and 4 only
1, 3 and 4 only

⇒ RC network shown in the given figure can provide a maximum theoretical phase shif
90°
180°
270°
360°

⇒ The hex number EB₁₆ represents binary number of
11101011
10010110
10101100
11101011

⇒ A p-n junction diode has
low forward and high reverse resistance
a non-linear v-i characteristics
zero forward current till the forward voltage reaches cut in value
all of the above

⇒ A branched duplexer requires
TR tubes
ATR tube
both TR and ATR tube
none of the above

⇒ Earth's curvature affects the effective height of antenna.
TRUE
FALSE

⇒ The amplitude of a modulated RF aerial current is 6 A on the peaks of modulation and 4 A on the troughs of modulation. The value of carrier amplitude is
5
15
20
30

⇒ If transmission bandwidth is doubled in FM, SNR is
doubled
raised four times
decreased four times
halved

⇒ De Sauty bridge is very widely used due to
simplicity
perfect balance for imperfect capacitor
perfect balance for air capacitors
maximum sensitivity

⇒ Assume that x = 7, the Java operation x = x - means that final value of x is
7
-1
6
-6

⇒ A resistance strain gauge is usually
wire grid type
foil type
any of these
none of these

⇒ Induction wattmeter is an absolute instrument.
TRUE
FALSE

⇒ Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because
it loads the circuit to maximum extent
it loads the circuit moderately
it does not load the circuit at all
it uses centre zero galvanometer instead of Voltmeters

⇒ The values of 2⁵ in octal system is
40
20
400
200

⇒ As the ratio R_f/R_L increases the efficiency of a rectifier increases.
TRUE
FALSE

⇒ If q is charge on an electron, R is radius of electron orbit and ω is angular velocity of electron rotation, the magnetic dipole moment of electron in orbit is
0.5 qωR
0.5 q²ω²R²
0.5 qωR²
0.5 qω²R

⇒
Match the following:
List I List II
A. GTO 1. Widely used in digital computers
B. UJT 2. Used for freewheeling
C. Power Diode 3. Can be turned off by negative gate signal
D. MOSFET 4. Used in generating triggering pulses

A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1
A-3, B-4, C-2, D-1
A-2, B-1, C-3, D-4

⇒ At t = 0⁺, the current i_{1- V/2R
- V/4R
- V/R
zero}

⇒ Find the number of loop equation and number of possible trees for the given gr
7, 2097152
7, 262144
7.5764801
6, 823543

⇒
Assertion (A): SSB and ISB receivers have good S/N ratio
Reason (R): SSB and ISB receivers have good suppression of adjacent channels.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A logical expression Y = A + AB is equal to
Y = AB
Y = AB
Y = A + B
Y = A + B

	List I		List II
A.	GTO	1.	Widely used in digital computers
B.	UJT	2.	Used for freewheeling
C.	Power Diode	3.	Can be turned off by negative gate signal
D.	MOSFET	4.	Used in generating triggering pulses

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math