Question is ⇒ For which of the following equipment current rating is not necessary ?, Options are ⇒ (A) Circuit breakers, (B) Isolators, (C) Load break switch, (D) Circuit breakers and load break switches, (E) , Leave your comments or Download question paper.

Question is ⇒ For which of the following equipment current rating is not necessary ?, Options are ⇒ (A) Circuit breakers, (B) Isolators, (C) Load break switch, (D) Circuit breakers and load break switches, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For which of the following equipment current rating is not necessary ?
A.	Circuit breakers [Wrong Answer]
B.	Isolators [Correct Answer]
C.	Load break switch [Wrong Answer]
D.	Circuit breakers and load break switches [Wrong Answer]
View Answer 15 -6 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ By which of the following methods voltage of transmission can be regulated ?
Use of series capacitors to neutralise the effect of series reactance
Switching in shunt capacitors at the receiving end during heavy loads
Use of tap changing transformers
Any of the above methods

⇒ Which of the following materials is not used for transmission and distribution of electrical power ?
Copper
Aluminium
Steel
Tungsten

⇒ A booster is a
series wound generator
shunt wound generator
synchronous generator
none of the above

⇒ Power system stability is least affected by
reactance of generator
input torque
losses
reactance of transmission line

⇒ Low voltage cables are meant for use up to
1.1 kV
3.3 kV
6.6 kV
11 kV

⇒ The surge resistance of cables is
20 ohms
50 ohms
200 ohms
300 ohms

⇒ The minimum clearance between the ground and a 220 kV line is about
4.3 m
5.5 m
7.0 m
10.5 m

⇒ Large industrial consumers are supplied electrical energy at
400 V
11 kV
66 kV
400 kV

⇒ Which of the following are connected by the service mains ?
Transformer and earth
Distributor and relay system
Distributor and consumer terminals
Distributor and transformer

⇒ The wooden poles well impregnated with creosite oil or any preservative compound have life
from 2 to 5 years
10 to 15 years
25 to 30 years
60 to 70 years

⇒ The loads on distributors systems are generally
balanced
unbalanced
either of the above
none of the above

⇒ A 3-phase 4 wire system is commonly used on
primary transmission
secondary transmission
primary distribution
secondary distribution

⇒ Corona is likely to occur maximum in
transmission lines
distribution lines
domestic wiring
all of the above

⇒ In a D.C. 3-wire distributor using balancers and having unequal loads on the two sides
both balancers run as generators
both balancers run as motors
balancer connected to lightly- loaded side runs as a motor
balancer connected to heavily- loaded side runs as a motor

⇒ By which of the following factors is the sag of a transmission line least affected ?
Current through the conductor
Ice deposited on the conductor
Self weight of conductor
Temperature of surrounding air

⇒ The cause of damage to the lead sheath of a cable is
crystallisation of the lead through vibration
chemical action on the lead when buried in the earth
mechanical damage
all of the above

⇒ Pin type insulators are generally not used for voltages beyond
1 kV
11 kV
22 kV
33 kV

⇒ A feeder, in a transmission system, feeds power to
distributors
generating stations
service mains
all of the above

⇒ Out of the following which type of poles are bulky ?
Transmission towers
Concrete poles
Tubular steel poles
Wooden poles

⇒ Besides a method of trial and error, which of the following methods is employed for solution o f network problems in interconnected system ?
Circulating current method
Thevenin's theorem
Superposition of currents
Direct application of Kirchhoff's laws

⇒ Which of the following materials is used for overhead transmission lines ?
Steel cored aluminium
Galvanised steel
Cadmium copper
Any of the above

⇒ Earthing is necessary to give protection against
danger of electric shock
voltage fluctuation
overloading
high temperature of the conductors

⇒ Owing to skin effect
current flows through the half cross-section of the conductor
portion of the conductor near the surface carries more current and core of the conductor carries less current
portion of the conductor near the surface carries less current and core of the conductor carries more current
any of the above

⇒ Transmitted power remaining the same, if supply voltage of a D.C. 2-wire feeder is increased 100 percent, saving in copper is
25 percent
50 percent
75 percent
100 percent

⇒ Which of the following is a static exciter ?
Rectifier
Rotorol
Amplidyne
D.C. separately excited generator

⇒ Which of the following regulations is considered best ?
0.5
0.2
0.1
0.02

⇒ The operating voltage of supertension cables is upto
3.3 kV
6.6 kV
11 kV
33 kV

⇒ The distributors for residential areas are
single phase
three-phase three wire
three-phase four wire
none of the above

⇒ In the cables sheaths are used to
prevent the moisture from entering the cable
provide strength to the cable
provide proper insulation
none of the above

⇒ The material commonly used for insulation in high voltage cables is
lead
paper
rubber
none of the above