Question is ⇒ For VLF antennas radiation resistance is usually of the order of, Options are ⇒ (A) less than one ohm, (B) 13 to 20 ohms, (C) around 100 ohms, (D) more than 200 ohms, (E) , Leave your comments or Download question paper.

Question is ⇒ For VLF antennas radiation resistance is usually of the order of, Options are ⇒ (A) less than one ohm, (B) 13 to 20 ohms, (C) around 100 ohms, (D) more than 200 ohms, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For VLF antennas radiation resistance is usually of the order of
A.	less than one ohm [Correct Answer]
B.	13 to 20 ohms [Wrong Answer]
C.	around 100 ohms [Wrong Answer]
D.	more than 200 ohms [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following

Generation of SSB signals
Design of minimum phase type filters
Representation of band pass signals

Which of the above applications is Hilbert transform used?
1 only
1, 2 and 3
1, 2 only
1 and 3

⇒ In figure, a voltmeter of internal resistance 1200 Ω is connected across 600 Ω resistance and it reads 5 V. The value of
1200 Ω
2400 Ω
3600 Ω
7200 Ω

⇒ Steady state conditions are considered to be achieved in R-L circuits at the end of __________ time constant.
one
two
four
five

⇒ Which of the following be true for a CE transistor amplifier if the emitter resistor value is made equal to zero?

Its gain will increase
Its stability will increase
Its gain will decrease
Its stability will decrease

Select the correct answer from the codes given below
1 and 2
2 and 3
3 and 4
1 and 4

⇒

Assertion (A): In CC amplifier the collector is at ac ground

Reason (R): CC amplifier is also called emitter follower

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The maximum phase difference between the applied voltage and current in a RLC series current with finite values of R, L, C, and f can be
less than 90°
less than 45°
180°
30°

⇒ In figure, capacitor is uncharged. The switch is closed at t = 0 at t = 0⁺ di/dt100 A/s
-100 A/s
1000 A/s
-1000 A/s

⇒ The advantage of FET over BJT is
high input impedance
lower noise
no thermal runaway
all of the above

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ In a composite filter terminating half sections are used for impedance matching.
TRUE
FALSE

⇒ The current wave shown in figure is applied by a 0.1 F capacitor at t = 0. At t = 0⁺, the voltage across capacito
0
4 V
10 V
20 V

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ A two branch parallel tuned circuit has 100 Ω resistance and 0.1 H inductance in one branch and 10^-6 F capacitor in the other. At resonance frequency, the dynamic resistance is
10 Ω
100 Ω
1000 Ω
10000 Ω

⇒ The most widely used LC oscillator is
Hartley oscillator
Crystal oscillator
Colpitt's oscillator
Clapp's oscillator

⇒ A cycloconverter can be
step down
step up
step down or step up
none of the above

⇒ The term efficacy, is defined by
same as efficiency
measure of the ability of a device to produce a desired effect
input/output
(efficiency)²

⇒ When temperature is more than ferromagnetic curie temperature, the behaviour of a ferromagnetic material is similar to that of paramagnetic material.
TRUE
FALSE

⇒ Double integration of unit step function leads to
an impulse
a parabola
a ramp
a doublet

⇒ PIL colour picture tube has the main advantage that
it is cheap
it ensures purity in colour
it is self convergent
both (a) and (b)

⇒ (FE35)₁₆ XOR (CB15)₁₆ is equal to
(3320)₁₆
(FE35)₁₆
(FF50)₁₆
(3520)_l6

⇒ In a single phase half wave ac regulator feeding a resistive load, the rms load current
is always positive
may be positive or negative
is always negative
can be even zero

⇒ The applications of shift registers are
Time delay
Ring counter
Serial to parallel data conversion
Serial to serial data conversion
Which of the above are correct?
1, 2, 3
2, 3, 4
1, 2, 3, 4
1, 2, 4

⇒ In a waveguide if TE mode exist for z direction propagation, then
E_z = 0, H_z ≠ 0
E_z = 0, H_z = 0
E_z ≠ 0, H_z = 0
E_z ≠ 0, H_z ≠ 0

⇒ The first geostationary satellite was named
Intelsat I
Intelsat II
Intelsat III
Early bird

⇒ The voltage and current distributions on a grounded λ/4 dipole (Marconi antenna) are similar to those of a half wave dipole in space.
TRUE
FALSE

⇒ In a JFET
gate source cut off voltage is equal to V_DS
gate source cut off voltage is equal to pinch off voltage
gate source cut off voltage is twice the pinch off voltage
gate source cut off voltage is equal to negative pinch off voltage

⇒ Hari (H), Gita (G), Irfan (I) and Saira (S) are sibiligs (i.e. brothers and sisters). All were born on 1st January. The age difference between any two successive siblings (that is born one after another) is less than 3 years. Given the following fa
HSIG
SGHI
IGSH
IHSG

⇒ In which of these does thermionic emission occur?
LED
LCD
VF display
None

⇒ Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?
Variable tuning inductor
Ganged tuning inductor
Variable capacitor
Variable preset

⇒ A 400 W carrier is modulated to a depth of 75 percent. The total power in modulated wave will be
38.5 W
400 W
512.5 W
615.5 W

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math