Question is ⇒ For use at 50 Hz the range of scale of vibrating reed frequency meter is, Options are ⇒ (A) 25 - 75 Hz, (B) 40 - 60 Hz, (C) 47 - 53 Hz, (D) 42 - 58 Hz, (E) , Leave your comments or Download question paper.

Question is ⇒ For use at 50 Hz the range of scale of vibrating reed frequency meter is, Options are ⇒ (A) 25 - 75 Hz, (B) 40 - 60 Hz, (C) 47 - 53 Hz, (D) 42 - 58 Hz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For use at 50 Hz the range of scale of vibrating reed frequency meter is
A.	25 - 75 Hz [Wrong Answer]
B.	40 - 60 Hz [Wrong Answer]
C.	47 - 53 Hz [Correct Answer]
D.	42 - 58 Hz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure represen
NPN transistor
PNP transistor
Zener diode
Power diode

⇒ The constellation diagram of a modem has four states as shown in the figure given below. What is the bit rate of this mod
Two times its band rate
Four times its band rate
Same as band rate
Sufficient information is not given to give the answer

⇒ A 16 bit type ADC uses 1 MHz clock its maximum conversion time is __________ .
16 μs
15 ms
6.5 ms
66 ms

⇒ The zeros of a minimum phase function lie on
imaginary axis
left half plane or origin
left half plane or imaginary axis
right half plane or origin

⇒ DOS has a command named ' DIRECTORY '.
TRUE
FALSE

⇒

Assertion (A): The response of a network to an impluse is determined only by the parameters of the network.

Reason (R): If f(t) is a unit parabolic function, its Laplace transform is 1/s³

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In TE₁₀mode the largest electric field in a rectangular wave guide, occurs
along centre line of broad wall (i.e. x = a/2)
along the broad wall (i.e. x = 0 and x = a)
either (a) or (b)
neither (a) nor (b)

⇒ The number of product terms in the minimized sum of product expression obtained through the following K-map, where d, don't c
2
3
4
5

⇒ When a function Z(s) having a pole at infinity is realized, we get
a capacitance in series
a resistance in series
an inductance in series
a resistance or inductance in series

⇒ The velocity of sound waves in air
is constant at all temperatures
varies directly as temperature
varies inversely as absolute temperature
varies directly as square root of absolute temperature

⇒ The type of feedback in the following circuit diag
Voltage shunt
Current-shunt
Voltage series
Current series

⇒ For aeroplane and navigation frequency band is
VLF
UHF
VHF
EHF

⇒ Microwaves
get reflected by ionosphere
are absorbed by ionosphere
are neither reflected nor absorbed by ionosphere
are both reflected and absorbed by ionosphere

⇒ AM amplifier having noise figure of 20 dB and available power gain of 15 dB is followed by a mixer circuit having noise figure of 9 dB. The overall noise figure as referred to input in dB is
10.44
11.07
21.52
0.63

⇒ In which computer language is 'break' statement used
Fortran 77
Pascal
C
none of the above

⇒ A (75 - j 40) W load is connected to a co-axial line of z₀ = 75ω at 6 MHz. The load matching on the line can be accomplished by connecting
a short circuit stub at the load
an inductance at the load
a short circuit stub at a specific distance from the load
a capacitance at a specific distance from the load

⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere.
7.07
10
12.07
2.07

⇒ If e is the charge of an electron, R is the radius of its orbit and ω is the angular velocity of electron, the magnetic dipole moment μ_m of the orbit is |μ_m| = eωR².
TRUE
FALSE

⇒ Radiation efficiency of an antenna is defined as the ratio of
Total power radiated by an antenna to the net power accepted by the antenna from the connected transmitter
The frequency at which minimum power is radiated to the frequency at which maximum power is radiated
Total power accepted from the transmitter to total power generated by the transmitter
Power in main lobe to that in the side lobe

⇒ In 8085, TRAP is
always maskable
cannot interrupt a service subroutine
used for catastrophic events like temporary power failure
lowest priority interrupt

⇒ If luminance signal Y = 0.3 R + 0.59 G + 0.11 B, the hue of R - Y colour is
0.7 R - 0.59 G - 0.11 B
- 0.7 R + 0.59 G + 0.11 B
1.3 R - 0.59 G - 0.11 B
none of the above

⇒ Consider the following rectifier circuits :

half-wave rectifier without filter
full-wave rectifier without filter
full-wave rectifier with series inductance filter
full-wave rectifier with capacitance filter.

The sequence of these rectifier circuits in decreasing order of their ripple factor is
1, 2, 3, 4
3, 4, 1, 2
1, 4, 3, 2
3, 2, 1, 4

⇒ When modulation index of an AM wave is increased from 0.5 to 1, the transmitted power
remains the same
increases by 25%
increases by 33.3%
increases by 50%

⇒ A single phase semiconverter has a freewheeling diode. If the firing angle is a and the load is purely resistive, the periods of conduction and freewheeling respectively are
p - a and 0
p - a and a
p + a and 0
p + a and a

⇒

Assertion (A): A dynamic RAM chip has much smaller cell than a static RAM chip.

Reason (R): In dynamic RAM one bit of information is stored as the charge on a capacitor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In 8085 microprocessor, how many lines are there in address bus?
6
8
12
16

⇒ The following components are used to measure power output of a 2 kW TWT amplifier:

TWTA
Low pass/high pass filter
20 dB attenuator
40 dB directional complex with matched load
Power load

What is the correct sequence of connection of these components?
2 - 4 - 1 - 3 - 5
1 - 3 - 4 - 2 - 5
1 - 2 - 4 - 3 - 5
2 - 4 - 1 - 5 - 3

⇒ For a transistor if a_dc = 0.98 and emitter current I_E is 2 mA, then collector current will be
0.44 mA
0.88 mA
1.96 mA
3.32 mA

⇒ Fastest memory cell
bubble memory
core memory
semiconductor memory
superconductor memory

⇒ Which of the following READ statements is correct in FORTRAN 77?
READ *, HONEY (I), I = 1, 5
READ *, (HONEY (I), I = 1, 5)
READ * HONEY I, I = 1, 5
READ HONEY I, I = 1, 5