Question is ⇒ For type 2 system, the magnitude and phase angle of the term (jω)2 in the denominator, at ω = 0, are respectively, Options are ⇒ (A) 0 and - 90°, (B) 0 and + 90°, (C) infinity and - 180°, (D) infinity and + 180°, (E) , Leave your comments or Download question paper.

Question is ⇒ For type 2 system, the magnitude and phase angle of the term (jω)2 in the denominator, at ω = 0, are respectively, Options are ⇒ (A) 0 and - 90°, (B) 0 and + 90°, (C) infinity and - 180°, (D) infinity and + 180°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For type 2 system, the magnitude and phase angle of the term (jω)² in the denominator, at ω = 0, are respectively
A.	0 and - 90° [Wrong Answer]
B.	0 and + 90° [Wrong Answer]
C.	infinity and - 180° [Correct Answer]
D.	infinity and + 180° [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A signal x(t) = 100 cos (24p x 10³t) is ideally sampled with a sampling period of 50 μ sec and then passed through an ideal low pass filter with cut off frequency of 15 kHz Which of the following frequencies are present at the filter output?
12 kHz only
8 kHz only
12 kHz and 9 kHz
12 kHz and 8 kHz

⇒ In the circuit shown in the figure, the approximate voltage at the transist
base and emitter respectively are -8 V and -7.3 V
base and collector respectively are -8 V and -5 V
Collector and emitter respectively are -5 V and -7.3
base, emitter and collector respectively are -8 V, 7.3 V and -5 V

⇒ A transistor has a current gain of 0.99 in the CB mode. Its current gain in the CC mode is
100
99
1.01
0.99

⇒ Class A and class B chopper
operate in first quadrant
operate in second quadrant
class A chopper operates in first quadrant while class B operates in second quadrant
may operate in either first or second quadrant

⇒ In p type semiconductor holes are majority carriers.
TRUE
FALSE

⇒ Two 2 port circuits are connected cascaded. To determine the response, it is more convenient to use
O.C. impedance parameters
S.C. admittance parameters
ABCD parameters
h parameters

⇒

Match the following:

	List I (Set operation)		List II (Set operator)
A.	Set equality	1.	-
B.	Set inclusion	2.	=
C.	Set intersection	3.	< =
D.	Set difference	4.	∗

A-2, B-3, C-4, D-1
A-3, B-2, C-4, D-1
A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1

⇒ When atoms are held together by the sharing of valence electrons
each atom becomes free to move
neutrons start shifting
they form a covalent bond
some of the electrons are lost

⇒ The switch in the circuit shown was on position a for a long time, and is moved to position b at time t = 0. The current i(t) for t > 0 is give
0.2e^-125tu(t) mA
20e^-1250tu(t) mA
0.2e^-1250tu(t) mA
20e^-1000tu(t) mA

⇒

Assertion (A): The time response, usually, is slower with lag compensation.

Reason (R): The natural undamped frequency and bandwidth are increased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A Hartley oscillator is used for
very low frequencies
radio frequencies
micro wave frequencies
audio frequency

⇒ In selecting a satellite system, the First determining factor is its
EIRP
antenna size
coverage a sea
antenna gain

⇒ Two resistances are : R₁ = 36 Ω ± 1.89 Ω and R₂ = 75 Ω ± 3.75 Ω. The sum R₁ + R₂ along with limiting error is
111 Ω ± 1.8 Ω
111 Ω ± 3.75 Ω
111 Ω ± 5.55 Ω
111 Ω ± 1.95 Ω

⇒

Assertion (A): In p type semiconductor conduction is mainly due to holes.

Reason (R): In p type material the holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A transmitter radiates a power 20 KW and its base current is 18A. The radiation resistance of the antenna is
1111 Ω
900 Ω
75 Ω
62 Ω

⇒ A higher directivity is specified by
high gain low BW (Beamwidth)
high gain high BW
low gain high BW
none of the above

⇒ The Fourier series of an odd periodic function contains
odd harmonics only
even harmonics only
cosine harmonics only
sine harmonics only

⇒ In a D latch
D drives R and D drives S
D drives S and D drives R
D drives both R and S
D drives both R and S

⇒ In figure, the value of R shoul
12 Ω
6 Ω
3 Ω
1.5 Ω

⇒ The standard intermediate frequency for FM ratio is
10.7 MHz
4.5 MHz
75 kHz
455 kHz

⇒ For 0 < M < 1, the centres of M circle lie to the right of origin.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Ring modulator	1.	Clock recovery
B.	VCO	2.	Demodulation of FM
C.	Foster Seeley discriminator	3.	Frequency conversion
D.	Mixer	4.	Summing of two points
		5.	Generation of FM
		6.	Generation of DSB-SC

A-1, B-3, C-2, D-4
A-6, B-5, C-2, D-3
A-6, B-1, C-3, D-2
A-5, B-6, C-1, D-3

⇒ An impulse train is
a number of pulses
a number of pulses spaced from each other
a number of pulses all originating together
none of the above

⇒ Consider the following statements regarding the properties of an R-L-C series circuit under resonance:

Current in the circuit is in phase with applied voltage
Voltage drop across capacitor C and inductance L are equal in magnitude.
Voltage across the capacitor is equal in magnitude to the applied voltage.
Current in the circuit is maximum.

Which of the above statements is/are correct?
1 only
1, 2 and 4
2 and 4
1, 3 and 4

⇒ Which of the following pairs are correctly matched?

Brune's realisation : realisation with ideal transformer.
Cauer realisation : ladder realisation.
Bott Duffin realisation : with non ideal transformer.

Select the answer using the following codes:
1, 2 and 3
2 and 3
1 and 3
1 and 2

⇒ A Wien bridge oscillator uses Wien bridge for
tuning and phase shift
tuning
phase shift
either tuning or phase shift

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒ The potential of suppressor grid (with respect to cathode) is usually
zero
negative
positive
zero or positive

⇒ A metal loses electrons at room temperature.
TRUE
FALSE

⇒ The effective electrical length of an antenna is __________ its physical length
greater than
equal to
less than
none of the above