Question is ⇒ For transmission of power over a distance of 200 km, the transmission voltage should be, Options are ⇒ (A) 132 kV, (B) 66 kV, (C) 33 kV, (D) 11 kV, (E) , Leave your comments or Download question paper.

Question is ⇒ For transmission of power over a distance of 200 km, the transmission voltage should be, Options are ⇒ (A) 132 kV, (B) 66 kV, (C) 33 kV, (D) 11 kV, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For transmission of power over a distance of 200 km, the transmission voltage should be
A.	132 kV [Correct Answer]
B.	66 kV [Wrong Answer]
C.	33 kV [Wrong Answer]
D.	11 kV [Wrong Answer]
View Answer 11 -9 Explanation:- Answer : A Discuss it below : Charanpreet Said on 2016-03-12 00:16:32 greater the distance greater the voltage !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Series capacitors on transmission lines are of little use when the load VAR requirement is
large
small
fluctuating
any of the above

⇒ In context of corona, if the conductors are polished and smooth, which of the following statements is correct ?
Hissing sound will be more intense
Power loss will be least
Corona glow will be uniform along the length of the conductor
Corona glow will not occur

⇒ Which of the following is usually not the generating voltage ?
6.6 kV
8.8 kV
11 kV
13.2 kV

⇒ If the voltage is increased x times, the size of the conductor would be
reduced to 1/x² times
reduced to 1/x times
increased x times
increased to x² times

⇒ Due to which of the following reasons aluminium is being favoured as busbar material ?
Low density
Low cost
Ease of fabrication
None of the above

⇒ When the load at the receiving end of a long transmission line is removed, the sending end voltage is less than the receiving end voltage. This effect is known as
Ferranti effect
Proximity effect
Kelvin effect
Faraday effect

⇒ By which of the following a bus-bar is rated ?
Current only
Current and voltage
Current, voltage and frequency
Current, voltage, frequency and short time current

⇒ By which of the following systems electric power may be transmitted ?
Overhead system
Underground system
Both (a) and (b)
None of the above

⇒ The spacing between phase conductors of a 220 kV line is approximately equal to
2 m
3.5 m
6 m
8.5 m

⇒ Resistance grounding is used for voltage between
33 kV to 11 k V
11 kV to 33 kV
33 kV to 66 kV
none of the above

⇒ In which of the following voltage regulators the effect of dead zero is found ?
Electromagnetic type
Magnetic amplifier
Electronic type using integrated circuits
All of the above

⇒ Skin effect exists only in
a.c. transmission
high voltage d.c. overhead transmission
low voltage d.c. overhead transmission
cables carrying d.c. current

⇒ Corona usually occurs when the electrostatic stress in air around the conductor exceeds
6.6 kV (r.m.s. value)/cm
11 kV (r.m.s. value)/cm
22 kV (maximum value)/cm
30 kV (maximum value)/cm

⇒ The colour of the neutral of three-core flexible cable is
blue
brown
red
black

⇒ Low voltage cables are meant for use up to
1.1 kV
3.3 kV
6.6 kV
11 kV

⇒ Which of the following regulations is considered best ?
0.5
0.2
0.1
0.02

⇒ Large industrial consumers are supplied electrical energy at
400 V
11 kV
66 kV
400 kV

⇒ Which of the following bus-bar schemes has the lowest cost ?
Ring bus-bar scheme
Single bus-bar scheme
Breaker and a half scheme
Main and transfer scheme

⇒ The ground ring transmission lines are used to
reduce the transmission losses
reduce the earth capacitance of the lowest unit
increase the earth capacitance of the lowest unit
none of the above

⇒ The effect of corona can be detected by
presence of zone detected by odour
hissing sound
faint luminous glow of bluish colour
all of the above

⇒ Steepness of the travelling waves is alternated by ____ of the line
capacitance
inductance
resistance
all of the above

⇒ For which of the following, the excitation control method is satisfactory ?
Low voltage lines
High voltage lines
Short lines
Long lines

⇒ For which of the following equipment current rating is not necessary ?
Circuit breakers
Isolators
Load break switch
Circuit breakers and load break switches

⇒ System grounding is done so that
inductive interference between power and communication circuits can be controlled
the floating potential on the lower voltage winding for a transformer is brought down to an insignificant value
the arcing faults to earth would not set up dangerously high voltage on healthy phases
for all above reasons

⇒ The distributors for residential areas are
single phase
three-phase three wire
three-phase four wire
none of the above

⇒ The charging current in the cables
leads the voltage by 180°
leads the voltage by 90°
lags the voltage by 90°
lags the voltage by 180°

⇒ The use of strain type insulators is made where the conductors are
dead ended
at intermediate anchor towers
any of the above
none of the above

⇒ Besides a method of trial and error, which of the following methods is employed for solution o f network problems in interconnected system ?
Circulating current method
Thevenin's theorem
Superposition of currents
Direct application of Kirchhoff's laws

⇒ The cause of damage to the lead sheath of a cable is
crystallisation of the lead through vibration
chemical action on the lead when buried in the earth
mechanical damage
all of the above

⇒ Power system stability is least affected by
reactance of generator
input torque
losses
reactance of transmission line