Question is ⇒ For the system in the given figure. The transfer function C(s)/R(s, Options are ⇒ (A) G1 + G2 + 1, (B) G1 G2 + 1, (C) G1 G2 + G2 + 1, (D) G1 G2 + G1 + 1, (E) , Leave your comments or Download question paper.

Question is ⇒ For the system in the given figure. The transfer function C(s)/R(s, Options are ⇒ (A) G1 + G2 + 1, (B) G1 G2 + 1, (C) G1 G2 + G2 + 1, (D) G1 G2 + G1 + 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the system in the given figure. The transfer function C(s)/R(s
A.	G₁ + G₂ + 1 [Wrong Answer]
B.	G₁ G₂ + 1 [Wrong Answer]
C.	G₁ G₂ + G₂ + 1 [Correct Answer]
D.	G₁ G₂ + G₁ + 1 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a paramagnetic material, susceptiblity increases with increasing temperature.
TRUE
FALSE

⇒ Magnetic recording tape is most commonly made from
small particles of iron
silicon iron
ferric-oxide
silver nitrate

⇒ In the context of error detection in satellite transmission, ARQ stands for
Automatic Repeat Request
Automatic Relay Request
Accelerated Recovery Request
Automatic Radiation Quenching

⇒ The most serious problems in ac bridge measurement is
eddy currents
leakage current
residual magnetism
stray fields

⇒

Assertion (A): The response of a network to an impluse is determined only by the parameters of the network.

Reason (R): If f(t) is a unit parabolic function, its Laplace transform is 1/s³

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Consider the following

Maximum energy of electrons liberated photoelectrically is independent of light intensity
Maximum energy of electrons liberated photoelectrically varies nonlinearly with frequency of incident light.

(1) is true and (2) is false
(1) and (2) both are true
(1) is false and (2) is true
(1) and (2) both are false

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The power gain is
125
250
1125
3125

⇒ The frequency at which the piezoelectric effect occurs is primarily determined by
the weight of the crystal
thickness of the crystal
length of the crystal
gain structure of the crystal

⇒ Which of these devices have four layers?
UJT
SCR
TRIAC
SCR and TRIAC

⇒ In communication receivers the fidelity is provided by
audio stage
detector range
mixer stage
all of the above

⇒ Choose the correct match for input resistance of various amplifier configurations shown below configurat
CB-LO, CC-MO, CE-HI
CB-LO, CC-HI, CE-MO
CB-MO, CC-HI, CE-LO
CB-HI, CC-LO, CE-MO

⇒ The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10^-6 N-m on full scale. If B = 1 Wb/m², range of meter is
1 mA
2 mA
3 mA
4 mA

⇒ Padders are used in a receiver to
discard the carrier
facilitate tracking
filter the input signal
suppress noise

⇒ The antenna diameter of a radar system is doubled. The maximum range will
be doubled
become four times
be halved
decrease to one fourth

⇒ 1101₂ - 1001₂ =
1000
100
10
1

⇒ A computer program is used to read N and compute N !. IF N = 6, the result will be
6
12
720
1040

⇒ A perfect conductor is a perfect absorber of electromagnetic waves.
TRUE
FALSE

⇒ The output of basic DTL configuration is
low when one of the input is high
low when all inputs are high
high when all inputs are high
high when all inputs are low

⇒ A permanent magnet moving coil measures
true rms value
dc value
peak value
rms plus dc value

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ The damping ratio of a pair of complex poles when expressed in terms of angle θ measured from jω axis equal to
sin θ
cos θ
tan θ
cot θ

⇒ If there is phase error in the carrier signal for the detection of SSB signals, then
the output gets reduced, but a phase distortion results
the output is not reduced, but a phase distortion results
the output is not reduced, and also no distortion
the output is reduced, no phase distortion

⇒ How many free electrons does a p type semiconductor has?
only those produced by thermal energy
only those produced by doping
those produced by doping as well as thermal energy
any of the above

⇒ Which of the following statements is incorrect?
Ideal voltage source is one whose internal resistance is zero
Ideal voltage source is one whose internal conductance is zero
Ideal voltage source is one whose generated voltage is equal to the available terminal voltage
Ideal current source is one whose internal conductance is zero

⇒ In ac circuits maximum power is delivered to a load if load impedance is conjugate of source impedance.
TRUE
FALSE

⇒ Which of the following antennas uses a number of varying length parallel elements?
Helical antenna
Pyramidal Horn
Comer reflection antenna
Yagi-Uda antenna

⇒ If the temperature of an extrinsic semiconductor is increased so that the intrinsic carrier concentration is doubled, then
the majority carrier density is doubled
the minority carrier density is doubled
the minority carrier density becomes 4 times the original value
both the majority and minority carrier densities double

⇒ What happens when forward bias is applied to a junction diode?
Majority carrier current is reduced to zero
Minority carrier current is reduced to zero
Potential barrier is increased
Potential barrier is decreased

⇒ Consider the following statements a half adder.

As a half subtractor also
has two outputs C_H = x x y and S_n = x ⊕ y for two inputs x and y
has two outputs CH = x + y and SH = x ⊕ y for two inputs x and y
is a combinational circuit

Which of the statements given above is/are correct?
1, 3, 4
1, 2, 4
4 only
2 and 3

⇒ The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplifica
AB
BC
CD
BD