Question is ⇒ For the polynomial P(s) = s5 + s4 + 2s3 + 2s2 + 3s + 15 The number of roots which lie in the right half of the s plane is :, Options are ⇒ (A) 4, (B) 2, (C) 3, (D) 1, (E) , Leave your comments or Download question paper.

Question is ⇒ For the polynomial P(s) = s5 + s4 + 2s3 + 2s2 + 3s + 15 The number of roots which lie in the right half of the s plane is :, Options are ⇒ (A) 4, (B) 2, (C) 3, (D) 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the polynomial P(s) = s⁵ + s⁴ + 2s³ + 2s² + 3s + 15 The number of roots which lie in the right half of the s plane is :
A.	4 [Wrong Answer]
B.	2 [Correct Answer]
C.	3 [Wrong Answer]
D.	1 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure, S is closed at t = 0. At t = t₁, I = 1 A and di/dt = 1 A/s. Then the value of
1 H
2 H
3 H
4 H

⇒ Which one of the following is an active component?
Diode (p-n)
Transistor as Amplifier
Transformer
Inductor

⇒ For a parallel two wire line with both conductors touching each other, the characteristic impedance is about
300 Ω
200 Ω
80 Ω
24 Ω

⇒ A 4 cm by 3 cm rectangular waveguide with air cavity, is operating at 12 GHz with TE₁₁ mode. The cut-off frequency is:
6.25 GHz
4.75 GHz
1.5 GHz
8.75 GHz

⇒ The logic function f(A B, C) = Σm(0, 2, 4, 5, 6) represente
i
i, ii
i, iii
i, ii, iii

⇒ Which one of the following is a cut set of the graph in the given fig
1, 2, 3, and 4
2, 3, 4, and 6
1, 4, 5, and 6
1, 3, 4, and 5

⇒ P flag is for parity.
TRUE
FALSE

⇒ The transfer function of transportation lag is
G(jω) = e^jωT
G(jω) = e^-jωT
G(jω) = (1 + jωT)
G(jω) = (1 - jωT)

⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm^-3. Density of electrons = 8 x 10¹³ cm^-3, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.
0.43 Ω-m
0.34 Ω-m
0.42 Ω-m
0.24 Ω-m

⇒ Conductivity σ, mobility μ and Hall coefficient K_H are related as
μ = σK_H
σ = μK_H
K_H = μσ
K_H =(μσ)^1.1

⇒ In figure, the battery has remained switched on for a long time. At t = 0 the switch is closed. The current i(t) is likely t
6
6 - 3e^-1
6 + 3e^-1
3 - 6e^-1

⇒ Bipolar IC memories are fabricated using
high density versions of the bipolar transistor flip-flop
low density versions of the unipolar transistor flip-flop
high density versions of the MOSFET
low density versions of the MOSFET

⇒ Noise limiter is provided on AM receivers to
reduce interfering noise due to ignition system
reduce noise due to electrical storms
reduce interference due to electrical machinery
all of the above

⇒ In an integral controller
the output is proportional to input
the rate of change of output is proportional to input
the output is proportional to rate of change of input
none of the above

⇒ If ω₀ is the angular frequency of rotation of electron in the absence of magnetic field, the angular frequency ω, when a magnetic field B is acting is ω ≅ ω₀ + (e/2m)B.
TRUE
FALSE

⇒ Voltage V_L in the circuit when V_s < 0 where D is an ideal diode. (Take R₁ = R_s = R_L = 1 &o
0
1
1.5
cannot find

⇒ A short grounded vertical antenna has a length L which is 0.05λ at frequency f. If its radiation resistance at f is R ohms, then its radiation resistance at a frequency 2f will be
R/2Ω
RΩ
2RΩ
4RΩ

⇒ The polarization of dielectric materials results in
production of eddy currents
creation of electric dipoles
absorption of electrons
release of high velocity protons

⇒ For a FM wave carrier modulating frequency is 10 kHz and bandwidth is 2 MHz. If the modulating signal amplitude is doubled, the bandwidth will be
0.5 MHz
1 MHz
2 MHz
4 MHz

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ An RLC series circuit has R = 8 Ω, X_L = 8 Ω and X_C = 8 Ω Its impedance is
8 + j 16 Ω
8 + j 8 Ω
8 Ω
24 Ω

⇒ The current flowing through a pure capacitor is called displacement current.
TRUE
FALSE

⇒ For the K map of the given figure the simplified Boolean expressio
A B + A B
B
A
AB

⇒ For the system of the given figure, the damping ratio of closed loop pole
1.5
1
0.5
0.25

⇒ Whenever a JFET operates above pinch-off voltage
depletion regions become smaller
drain current increase steeply
drain current starts decreasing
drain current remains nearly constant

⇒ In a series RLC circuit, the value of resistance for critical damping is
L/C
(L/C)^0.5
1/LC
2/L/C

⇒ The digit F in hexadecimal system is equivalent to number __________ in decimal system.
16
15
17
8

⇒ In the given figure shows a 4 bit serial in parallel out right shift register. The initial contents as shown are 0110. After 3 clock pulses the contents wil
0
101
1010
1111

⇒ Consider the following statements:

Strictly speaking C supports 1-dimensional arrays only.
An array element may be an array by itself.
Array elements need not occupy contiguous memory locations.

Which of the above statements is/are correct?
1 only
2 only
1 and 2
2 and 3

⇒ Natural commutation can be used in :
DC circuits only
AC circuits only
both AC and DC circuits
none of the above