Question is ⇒ For the K map of the given figure the simplified Boolean expressio, Options are ⇒ (A) AC + A B, (B) A BC + A B C + A B C + AB C, (C) AC + A B + AC, (D) A C + A B + AB, (E) , Leave your comments or Download question paper.

Question is ⇒ For the K map of the given figure the simplified Boolean expressio, Options are ⇒ (A) AC + A B, (B) A BC + A B C + A B C + AB C, (C) AC + A B + AC, (D) A C + A B + AB, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the K map of the given figure the simplified Boolean expressio
A.	AC + A B [Correct Answer]
B.	A BC + A B C + A B C + AB C [Wrong Answer]
C.	AC + A B + AC [Wrong Answer]
D.	A C + A B + AB [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I (Double Rectifier)		List II (Number of Diodes)
A.	Full wave Bridge rectifier	1.	1
B.	Half wave rectifier	2.	2
C.	Full wave rectifier using centre tapped transformer	3.	4

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-1, C-3
A-3, B-1, C-2

⇒ In figure the bridge is balanced when Z₄
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°

⇒ Two ammeters having resistances of 0.5 Ω and 0.25 Ω and having full scale reading of 25 A each are connected in parallel. To ensure that neither of them goes beyond scale, the total current should not be more than
50 A
37.5 A
25 A
40 A

⇒ Loading of a line means
increasing inductance of line
increasing distributed inductance of line
decreasing distributed inductance of line
decreasing inductance of line

⇒ For a second order instrument, the optimum range of ξ (damping ratio), which gives good frequency response over a wide range of frequencies is
0.5 to 0.6
0.6 to 0.7
0.7 to 0.8
0.8 to 1.0

⇒ For the circuit shown in figure low cut-off frequenc
1.59 Hz
159 Hz
1.59 kHz
1.59 MHz

⇒ Which of the following is not a valid real constant?
-73.1
10251,3
10.23
-5.7381

⇒ A crowbar circuit is generally needed for protection under fault conditions.
TRUE
FALSE

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is
100
50
10
5

⇒

Assertion (A): Absolute instruments are used in standard laboratories.

Reason (R): Absolute instruments do not require calibration.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Ohmic range of carbon composition resistors is
10 to 100 ohms
10 to 10 K ohms
10 to 200 ohms
10 to 25 M ohms

⇒ A 256 x 4 EPROM has
8 address pins and 4 data pins
8 address pins and 8 data pins
4 address pins and 8 data pins
4 address pins and 4 data pins

⇒ For satellite transmission, analog signals may be converted into digital form with the help of
modem
transponder
codec
compandor

⇒ Addition of a small amount of antimony to germanium will result in
formation of p-type semiconductor
more free electrons than holes in semiconductor
antimony concentrating on the edges of the crystal
increased resistance

⇒ For VLF antennas radiation resistance is usually of the order of
less than one ohm
13 to 20 ohms
around 100 ohms
more than 200 ohms

⇒

Assertion (A): If a carrier is modulated by three sine waves and m₁, m₂, m₃ are the modulation indices, the total modulation index m_t
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): Inter-digitated geometry is widely used for microwave transistors.

Reason (R): Tuning at input and output of transistor uses MOS chip capacitors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Value of Z_L for maximum power transfe
R
R + jωL
R - jωL
None of these

⇒ Debye temperature of metals is
about 10 K
about 200 K
about 600 K
about 2 K

⇒ The reflection coefficient is generally a
complex number
fraction
imaginary number
none of the above

⇒ The minterm designation for ABCD is
m₈
m₁₀
m₁₄
m₁₅

⇒ The multiplier resistance and meter coil in a voltmeter are in
series
parallel
series-parallel
either (a) or (b)

⇒ On which of the following effect do thermocouples work?
Thomson effect
Seeback effect
Peltier effect
Joule effect

⇒ The effective height of a vertical radiator can be increased by
loading with lumped inductance
supporting on an insulator
capacitive loading
giving input more power

⇒ In a CD the channel separation is
1 μm
1.6 μm
2.5μm
4 μm

⇒ The figure shown below is designed to act as a constant current source across the load resistor. The β of transistor is 50. What is the value of load curr
1.96 mA
2 mA
2.04 mA
None

⇒ In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about
15 μV
30 μV
7.5 μV
10.6 μV

⇒ If A is 1011, A" is
1011
100
1100
1010

⇒ While AM has __________ frequencies, FM has __________ number of sidebands.
2, 3
3, 3
3, 5
3, infinite

⇒ Find value
1A
0A
0.45 A
None of these