Question is ⇒ For the circuit shown in figure low cut-off frequenc, Options are ⇒ (A) 1.59 Hz, (B) 159 Hz, (C) 1.59 kHz, (D) 1.59 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ For the circuit shown in figure low cut-off frequenc, Options are ⇒ (A) 1.59 Hz, (B) 159 Hz, (C) 1.59 kHz, (D) 1.59 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the circuit shown in figure low cut-off frequenc
A.	1.59 Hz [Correct Answer]
B.	159 Hz [Wrong Answer]
C.	1.59 kHz [Wrong Answer]
D.	1.59 MHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Nyquist stability criterion uses open loop frequency response characteristics.
TRUE
FALSE

⇒ A p matching network for coupling the transmitter output of the antenna is shown in figu
minimum D.C. plate current
maximum D.C. plate current
maximum RF antenna current
specified value of the D.C. plate current

⇒ An 8 level encoding scheme is used in a PCM system of 10 kHz channel BW. The channel capacity is
80 kbps
60 kbps
30 kbps
18 kbps

⇒ Most of the transistor data sheets specify the power rating for an ambient temperature of
10°C
25°C
50°C
75°C

⇒ A rare gas having N atoms/m³ is subjected to an electric field E. The electric dipole moment per unit volume is proportional to N and E.
TRUE
FALSE

⇒ Addition of a small amount of antimony to germanium will result in
formation of P-type semiconductor
more free electrons than holes in the semiconductor
antimony concentrating on the edges of the crystals
increased resistance

⇒ A 16 bit type ADC uses 1 MHz clock its maximum conversion time is __________ .
16 μs
15 ms
6.5 ms
66 ms

⇒ For an P-channel enhancement type MOSFET determine the drain current if K = 0.278 x 10^-3A/V², V_GS = -4V, V_T = -2V, Voltage equivalent at 27°C = 26 mV.
10 mA
1.11 mA
0.751 mA
46.98 mA

⇒ For an accurate clock period in 8085 it is preferable to use
Crystal
Crystal or LC resonant circuit
Crystal or RC circuit
LC or RC circuit

⇒ Troposphere is the portion of atmosphere
nearest to ground
between 50 to 90 km above ground
between 110 to 220 km above ground
between 250 to 350 km above ground

⇒ The directivity in a receiving antenna

increases the intercept area in forward direction
reduces the noise picked up from other sources
provides a means of discriminating against undesired signals originating in directions other than in which the desired transmitter lies.

Which of the above statements are correct?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒ The internal impedance of a source is 3 + j 4 Ω. It is desired to supply maximum power to a resistive load. The load resistance should be
3 Ω
4 Ω
7 Ω
5 Ω

⇒

Match the following:

	List I		List II
A.	bit	1.	10
B.	nat	2.	e
C.	decit	3.	2

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-2, C-1
A-2, B-3, C-1

⇒ In the given figure
A
B
A + B + C
ABC

⇒ The stud in a stud mounted SCR acts as
anode
cathode
gate
anode or cathode

⇒ A TV picture is to be transmitted over a channel of 6 MHz bandwidth at a 35 dB S/N ratio. The capacity of the channel is
50 Mbps
100 Mbps
36 Mbps
72 Mbps

⇒ One XOR gate can work as
one bit magnitude comparator
two bit magnitude comparator
either (a) or (b)
neither (a) nor (b)

⇒ The factor which will have least effect on the voltage at the load end of a two-wire supply circuit is
length of the circuit
whether supply frequency is 25 Hz or 50 Hz
amount of load on the circuit
cross-section of the circuit wires

⇒ Which of the following is invalid integer variable name in Fortran?
IAEG
I 124
AILG
MI AC

⇒ Consider the following program for 8085OACH
53 H
OADH
54 H

⇒ (1001-10) is equal to
7
(8)₈
(7)₄
(8)₄

⇒ Without a spectrum analyser, it is not possible to determine
carrier frequency
antenna pattern
pulse width
spurious signal strength and its location

⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts

⇒ Two current sources each of rms value 10 A have frequencies 40 Hz and 50 Hz respectively. They are connected in series, the expression for resultant wave is
i = 10 sin 40 t + 10 sin 50 t
i = 14.14 sin 40 t + 14.14 sin 50 t
i = 14.14 sin 80 pt + 14.14 sin 100 pt
i = 20 sin 80 pt + 20 sin 100 pt

⇒ Out of Metal-film type and Carbon-film type, the one with better tolerance specification is
carbon-film
metal-film type
both have same tolerance
none of these

⇒ RMS value is always higher than average value.
TRUE
FALSE

⇒ In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be
0.6 T
more than 0.6 T
less than 0.6 T
0.6 T or less than 0.6 T

⇒ The seven segment display used in watches and clocks generally uses
LED
LCD
Photodiode
FET

⇒ The total inductance of two coils is 60 mH in series aiding connection and 40 mH in series opposing connection. The mutual inductance between coils is
20 mH
10 mH
5 mH
2.5 mH

⇒ A + 1.9 lens has a focal length of 25 mm. The diameter of lens is about
13 mm
1.3 mm
130 mm
none of the above