Question is ⇒ For the characteristic equation s5 + s4 + 2s3 + 2s2 + 3s + 15 = 0, the number of roots in left half s plane are, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 5, (E) , Leave your comments or Download question paper.

Question is ⇒ For the characteristic equation s5 + s4 + 2s3 + 2s2 + 3s + 15 = 0, the number of roots in left half s plane are, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 5, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the characteristic equation s⁵ + s⁴ + 2s³ + 2s² + 3s + 15 = 0, the number of roots in left half s plane are
A.	1 [Wrong Answer]
B.	2 [Wrong Answer]
C.	3 [Correct Answer]
D.	5 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The electric field on the surface of a perfect conductor is 2V/m. The conductor is immersed in water with ε = 80 ε₀. The surface charge density on the conductor is ((ε₀ = 10^-9/36p)F/m)
0 c/m²
2 c/m²
1.8 x 10^-11 c/m²
1.14 x 10^-9 c/m²

⇒ A coil is connected across a 200 V, 50 Hz supply and takes a current of 10 A. The loss in the coil is 1000 W. The impedance and resistance of the coil are
10 Ω, 8 Ω
15 Ω, 8 Ω
20 Ω, 10 Ω
30 Ω, 15 Ω

⇒ A certain JK FF has t_pd = 12 nsec. The largest MOD counter that can be constructed from these FFs and still operate up to 10 MHz is
any
8
256
10

⇒ If f_h(t) is the Hilbert transform of f(t), and f(t) is a real valued signal, the pre-envelope of f(t) is
f(t) - jf_h(t)
f(t) + jf_h(t)
f_h(t) + jf(t)
f_h(t) - jf(t)

⇒ The factor which will have least effect on the voltage at the load end of a two-wire supply circuit is
length of the circuit
whether supply frequency is 25 Hz or 50 Hz
amount of load on the circuit
cross-section of the circuit wires

⇒ Whether a linear system is stable or unstable that it
is a property of the system only
depends on the input function only
both (a) and (b)
either (a) or (b)

⇒

Assertion (A): Most of actual systems are non-linear.

Reason (R): Non linearity may be due to saturation, dead zone, square law etc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A full adder is to be implemented using half adders and OR gates. A 4 bit parallel adder without any initial carry requires
8 half adders and 4 OR gates
8 half adders and 3 OR gates
7 half adders and 3 OR gates
7 half adders and 4 OR gates

⇒ Magnetic flux can be measured by
capacitive pick up
inductive pick up
resistive pick up
hall effect pick up

⇒ In a specimen of ferromagnetic material, as the flux density is increased from zero to 2.5 T, µ_r will
increase
decrease
first decrease then increase
first increase then decrease

⇒ Ohm's law is valid for
dc voltage and current
ac voltage and current
all voltages and current
dc and ac voltages and currents

⇒ A 4 bit down counter can count from
0000 to 1111
1111 to 0000
000 to 111
111 to 000

⇒ The amplitude of a random signal uniformly distributed between - 5 V and
0.0333 V
0.05 V
0.0667 V
0.10 V

⇒ An n channel JFET has I_DS whose value is
maximum for V_GS = 0 and minimum for V_GS negative and large
minimum for V_GS = 0 and maximum for V_GS negative and large
maximum for V_GS = 0 and minimum for V_GS positive and large
minimum for V_GS = 0 and maximum for V_GS positive and large

⇒ Which of the following is not a valid real constant?
-73.1
10251,3
10.23
-5.7381

⇒ In classical analogue, torque is analogous to
current
voltage
charge
voltage gradient

⇒ The ASCII code is for information interchange by a binary code for
alphabet only
number only
alpha-numeric and other common symbols
none of these

⇒ In a TV receiver the raster is normal but there is no sound and quality of picture is poor. The defective part is
power supply
loudspeaker
AGC, video IF amplifier, RF amplifier
horizontal oscillator

⇒ In a directional coupler
isolation (dB) equals coupling plus directivity
coupling (dB) equals isolation plus directivity
directivity (dB) equals isolation plus coupling
isolation (dB) equals (coupling) (directivity)

⇒ In figure which diode will conduct and what will be the value of V_{0D₃, 1 V
D₁, 2 V
D₂, 5 V
D₁, 5 V}

⇒

Assertion (A): A hot wire ammeter has a cramped scale.

Reason (R): The heat is proportional to square of current.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): Direct coupled amplifiers are rarely used

Reason (R): Direct coupled amplifiers suffer from the disadvantage of drift

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In p type semiconductor, the hole concentration
is nearly equal to density of acceptor atoms
is much greater than density of acceptor atoms
is much less than density of acceptor atoms
may be equal to or more or less than density of acceptor atoms

⇒ Program counter in a digital computer
counts the number of programs run in the machine
counts the number of times a subroutine
counts the number of time the loops are executed
points the memory address of the current or the next instruction

⇒ In a bipolar transistor, emitter efficiency is about
0.99
0.9
0.8
0.7

⇒ The basic circuit configuration for TTL resembles that of a
AND gate
NAND gate
NOR gate
OR gate

⇒ The current rating of a cable depends on
length of cable
diameter of cable
both length and diameter of cable
none of the above

⇒ The zeros of a minimum phase function lie on
imaginary axis
left half plane or origin
left half plane or imaginary axis
right half plane or origin

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V

⇒ Which of the following options is the closest in meaning to the world be
cyclic
indirect
confusing
crooked