Question is ⇒ For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?, Options are ⇒ (A) Δ.E = 0, (B) Δ.E = 0, (C) Δ x E = 0, (D) Δ x E = 0, (E) , Leave your comments or Download question paper.

Question is ⇒ For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?, Options are ⇒ (A) Δ.E = 0, (B) Δ.E = 0, (C) Δ x E = 0, (D) Δ x E = 0, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?
A.	Δ.E = 0 [Wrong Answer]
B.	Δ.E = 0 [Wrong Answer]
C.	Δ x E = 0 [Wrong Answer]
D.	Δ x E = 0 [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a synchro transmitter
input is angular position of rotor shaft and output is stator voltages
input is stator voltages and output is angular position of shaft input is rotor voltage and output is angular position of rotor shaft
input is rotor voltage and output is angular position of rotor shaft
input is angular position of rotor shaft and output is rotor voltage

⇒ The input to negative clamper has a peak value of V_p. Then in the output the positive and negative peaks are nearly
0 and -2 V respectively
V_p and -V_p respectively
2 V_p and 0 respectively
none of the above

⇒ If a signal band limited for f_m is sampled at a rate less than 2 f_m the reconstructed signal will be
smaller in amplitude
distorted
having higher frequencies suppressed
none of the above

⇒ The effect of source inductance in a 3 phase fully controlled bridge converter is to
decrease the output voltage
increase the output voltage
decrease the output voltage and increase the output current
increase the output voltage and decrease the output current

⇒ Frequency modulation consists in
varying the frequency and amplitude of the carrier in accordance with the instantaneous value of modulating signal
varying the amplitude of the carrier in accordance with the instantaneous value of the modulating voltage
varying the frequency of the carrier voltage in accordance with the instantaneous value of the modulating voltage
vary the frequency of the carrier voltage

⇒ All poles and zeros of a driving point immittance function of an L-C network
should lie on the jω axis
should lie on the +ve real axis
should lie on the - ve real axis
can lie anywhere in s-plane

⇒ TDM
can be used with PCM only
interleaves pulses belonging to different transmissions
combines five groups into a super group
stacks 24 channels in adjacent frequency slots

⇒ The signal in 8086 are in minimum mode when
MN / Mx pin is tied to V_cc
MN / Mx pin is grounded
MN / MX pin is left open
none of the above

⇒

Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse.

Reason (R): Transistor find widespread application in power electronic circuits.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following statements is correct?
Convex lens has positive focal power and concave lens have negative focal power
Convex lens has negative focal power and concave lens have positive focal power
All lens have positive focal power
All lens have negative focal power

⇒ In figure, the battery has remained switched on for a long time. At t = 0 the switch is closed. The current i(t) is likely t
6
6 - 3e^-1
6 + 3e^-1
3 - 6e^-1

⇒ In Vidicon camera tube, the resistance of photoconductive material on the target plate
is constant
is more in darkness and less in brightness
is more in brightness but less in darkness and brightness
may be more or less in darkness and brightness

⇒ The pre-emphasis circuit is used
prior to modulation
after demodulation
for low frequency components of the signal
none of the above

⇒ In a forward biased p-n junction current enters p material as hole current and leaves n material as electron current of the same magnitude.
TRUE
FALSE

⇒ Consider the following assert
Only S2 is true
SI and S2 are both true but S2 is not a reason for SI
SI and S2 are both true and S2 is a reason for SI
Both SI and S2 are false

⇒ If a dipole is meant for a frequency of 1 MHz, the length of each rod is about
5 m
20 m
100 m
50 m

⇒ A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is
2
4
8
18

⇒ Which of the following amplifier circuits has highest input impedance?
Circuit using BJT
Circuit using JFET
Circuit using MOSFET
Either (a) or (b)

⇒ Binary 1000 will be the result of which of the following?
Binary 1000 - 100
Binary 1011 - 1111
Binary 1111 - 111
Binary 11111 - 1111

⇒ If a complex voltage wave is applied to a pure inductance, the resulting current wave is much smoother than the voltage wave.
TRUE
FALSE

⇒ A 12 bit ADC is used to convert analog voltage of 0 to 10 V into digital. The resolution is
2.44 mV
24.4 mV
1.2 V
none of the above

⇒ Find I for circuit shown b
0.125
0.0416666666666667
0.0833333333333333
0

⇒ Current density has the dimensions
IL
IL^-2
IL^-3
I²L^-2

⇒ Huffman code is also known as redundancy code
TRUE
FALSE
in some cases
depend upon efficiency

⇒ When a source is delivering maximum power to a load through a network, the ratio of power delivered to the source power
may be 50% or less than 50%
is 50%
may be 50% or more than 50%
may be 50% or more less than 50%

⇒ The terminals of a power BJT are called
emitter, base, collector
emitter, base, drain
source, base, drain
source, base, collector

⇒ A transistor may fail due to
open weld at the wire leads to the semi-conductor
short circuit caused by momentary overloads
overheating due to circuit failures
any of the above

⇒ The circuit in the figure is has two CMOS-NOR gates. This circuit functions
flip-flop
schmitt trigger
monostable multivibrator
astable multivibrator

⇒ Which of the following circuits can operate class AB for audio power output?
Emitter follower
Push pull
Cascade
Darlington pair

⇒ When two 4 bit parallel adders are cascaded we get
4 bit parallel adder
8 bit parallel adder
16 bit parallel adder
none of the above