Question is ⇒ For small size high frequency coils, the most common core material is, Options are ⇒ (A) air, (B) ferrite, (C) powdered iron, (D) steel, (E) , Leave your comments or Download question paper.

Question is ⇒ For small size high frequency coils, the most common core material is, Options are ⇒ (A) air, (B) ferrite, (C) powdered iron, (D) steel, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For small size high frequency coils, the most common core material is
A.	air [Correct Answer]
B.	ferrite [Wrong Answer]
C.	powdered iron [Wrong Answer]
D.	steel [Wrong Answer]
View Answer 5 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Continuous and aperiodic	1.	Fourier representation is continuous and aperiodic
B.	Continuous and Periodic	2.	Fourier representation is discrete and aperiodic
C.	Discrete and aperiodic	3.	Fourier representation is continuous and periodic
D.	Discrete and periodic	4.	Fourier representation is discrete and periodic

A-3, B-2, C-4, D-1
A-1, B-3, C-2, D-4
A-1, B-2, C-3, D-4
A-2, B-1, C-4, D-3

⇒ For the logic circuit of the given figure the simplified Boolean expressio
Y = AB + A C
Y = (AB) (A C)
Y = ABC
Y = A B + A C

⇒ One can format a disc using window explorer.
TRUE
FALSE

⇒ The operations which occur most frequently in a computer are
fetch
execute
both (a) and (b)
none of the above

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register D are stored
054 CH
054 DH
054 EH
054 FH

⇒ In the signal flow graph in the given figure the number of forward paths and pairs of non-touching loops are respecti
3 and 1
3 and 2
4 and 2
2 and 4

⇒

Assertion (A): A ballistic galvanometer is used to measure charge.

Reason (R): In a flux meter, the damping is large.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): PIN diode is used as a fast switch.

Reason (R): PIN diode has very high resistance when reverse biased and very low resistance when forward biased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The advantage of FET over BJT is
high input impedance
lower noise
no thermal runaway
all of the above

⇒ An amplitude modulated signal occupies a frequency range from 395 kHz to 405 kHz. If can be demodulated by which of the following?
Using an envelope detector and filter
Multiplying with a 395 kHz local signal
Multiplying with a 405 kHz local signal
Low pass filtering with cut off at 400 kHz

⇒ Ferrites are
hard materials
brittle materials
not easily machinable
materials with all above properties

⇒ Consider the following stateme
2 and 4
1 and 2
1 only
3 and 4

⇒ A narrowband amplifier is one that has a passband
limited to 2000 Hz only
limited to audio frequency range only
near cut off region of active device
approximately 10% of its central frequency

⇒ In a photodiode the current is due to
majority carriers
minority carriers
both majority and minority carriers
either (a) or (b)

⇒ The first machine cycle of an instruction is always
a memory read cycle
a fetch cycle
a input/output read cycle
a memory write cycle

⇒ If E_y is the voltage applied to Y plates, the vertical deflection of beam is proportional to
E_y
E_y
E_y^1.5
E_y²

⇒ A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
230 V
0.5 x 230 V
2 x 230V
230/2V

⇒ A half adder can be used only for adding
1 s
2 s
4 s
8 s

⇒ Cross talk is due to reception of portions of a signal from one channel into another.
TRUE
FALSE

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒ In a circuit the value of resistor is made four times. The noise voltage generated by this resistance will
be doubled
be increased four times
remain the same
become half

⇒ For the system in the given figure, the gain margi
0
low
+ ∞
none of the above

⇒ No load d.c. output will be least in case of
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ The use of microprocessor control in automobiles results in
improved fuel economy
improved car control
advanced information system for driver
all of the above

⇒ The transfer function of a controller is given as K_p + K_d.s where K_p and K_d are constants. What type of controller is this?
Proportional
Proportional plus integral
Proportional plus derivative
Integral plus derivative

⇒ Figure below shows D type Flip-Flops connected as shift register, then outputs Q_D, Q_C, Q_B, Q_A are given
1 and 2 only
2 and 3 only
1, 2 and 3
none of these

⇒ Find the electric charge required on the earth and moon to balance their gravitational attraction if the charge on the earth is 10 times that on the moon.
1.73 TC
17.3 GC
17.3 TC
1.73 GC

⇒ Consider the following applications

TV tuning
Active filter
Microwave frequency multiplication

In which of above can a varactor diode be used?
1 2 and 3
l and 2 only
1 and 3 only
2 and 3 only

⇒ Why does a FM radio station perform better than and AM station radiating the same actual power?
FM is immune to noise
AM has only two sidebands while FM has more
FM uses larger bandwidth for large modulation depth.
Capture effects appears in FM.

⇒ If a zero is added to a second order underdamped system
the peak overshoot is increased
the peak overshoot is decreased
the peak overshoot remains unchanged
either (a) or (b)