Question is ⇒ For representing two sinusoidal voltages on a phasor diagram, Options are ⇒ (A) Both voltages must be of the same frequency, (B) Both voltages must be sinusoidal but may be of different frequencies, (C) One of the voltages must be of 50 Hz, (D) The frequency of one must be integral of that of other, (E) , Leave your comments or Download question paper.

Question is ⇒ For representing two sinusoidal voltages on a phasor diagram, Options are ⇒ (A) Both voltages must be of the same frequency, (B) Both voltages must be sinusoidal but may be of different frequencies, (C) One of the voltages must be of 50 Hz, (D) The frequency of one must be integral of that of other, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For representing two sinusoidal voltages on a phasor diagram
A.	Both voltages must be of the same frequency [Correct Answer]
B.	Both voltages must be sinusoidal but may be of different frequencies [Wrong Answer]
C.	One of the voltages must be of 50 Hz [Wrong Answer]
D.	The frequency of one must be integral of that of other [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ __________ switch, a T flip-flop is used as __________ switch, a T flip-flop is used as switch
toggled, delay
delay, toggle
set reset
reset, set

⇒ If 137 + 276 = 435 how much is 731 + 672?
534
1403
1623
1513

⇒ The current through common emitter resistor of a differential amplifier is called
differential current
emitter current
ground current
tail current

⇒ A receiver having an RF amplifier and an IF of 450 kHz, has Q of the coils 65 and an incoming frequency of 1200 kHz. The image rejection of the receiver is
5870
3655
236
13.3

⇒ In a 4 bit D/A converter, the offset error is the output voltage when input digital voltage is
1111
0
either 1111 or 0000
none of the above

⇒ Two resistors R₁ = 36 Ω ± 5% and R₂ = 75 Ω ± 5% are connected in series. The total resistance is
111 ± 0 Ω
111 ± 2.778 Ω
111 ± 5.55 Ω
111 ± 7.23 Ω

⇒ The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6
1.2 kΩ
80 Ω
50 W
0

⇒ A MOSFET has a threshold voltage of 1 V and oxide thickness of 500 x 10^-8 [ε_r = 3.9; ε₀ = 8.85 x 10^-14 F/cm, q = 1.6 x 10^-19 c]. The region under the gate is ion implanted for threshold voltage tailoring. The base and type of impant required to shift threshold voltage to - 1 V are __________ .
8.6 x 10¹¹/cm², p-type
8.6 x 10¹¹/cm², n-type
0.86 x 10⁹/cm², p-type
1.02 x 10¹²/cm², n-type

⇒ A 3 kV circuit uses SCR of 800 V rating. If derating is 25%, the number of SCRs in series is
4
5
6
8

⇒

Assertion (A): Hay's bridge in particularly suitable for measuring inductance having a comparatively low resistance.

Reason (R): In Hay's bridge the value of frequency supply must be known.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If the switch is thrown to the START position, Q and Y will be equal to
Q = 0, Y = 0
Q= 1, Y= 1
Q = 1, Y = CLK
Q = 0, Y = CLK

⇒ Statement 1
Statement 1 is true but statement 2 is false
Statement 1 is false but statement 2 is true
Both the statements are true
Both the statements are false

⇒ In a four variable Karnaugh map, eight adjacent cells give a
two variable term
single variable term
three variable term
four variable term

⇒ The source of which of the following noise is different from that of the remaining?
Solar noise
Cosmic noise
Galactic noise
Atmospheric noise

⇒ Consider the real expression in Pascal language XZ and MP + K
XZ + Y and MP + K
(MP + K + X) / Y
Y / (MP + K)

⇒
Assertion (A): Even if TTL gates and CMOS gates used in a realization have the same power supply of + 5 V, suitable circuit is needed to interconnect them
Reason (R): V_OH, V_OL, V_IH and V_IL of a TTL gave are respectively 2.4, 0.4, 2 and 0.8 V respectively. If supply voltage is + 5 V. V_IL and V_IH for CMOS gate for the supply voltage of + 5 V are 1.5 V and 3.5 V respectively.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒
Assertion (A): The impedance of a series resonant circuit is minimum at resonance.
Reason (R): Resonance condition implies unity power factor condition.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is not a legal subscript?
J + 2
JA - 4
-3
3^* IA - 2

⇒ What is the approximate steady state current in the above circ
50 A
25 A
0.208333333333333
0.0416666666666667

⇒
Assertion (A): Two terminal black boxes of R and C can be identified by plotting their static V-I characteristics.
Reason (R): The V-I characteristic of resistance is a straight line of slope R passing through origin.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In figure, the short circuit current through terminal AB wil
1.5 A
0.125
0.0833333333333333
0.0416666666666667

⇒ The resistance in the circuit of the moving coil of a dynamometer wattmeter should be
very low
low
high
almost zero

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ If A = 3 + j1 and B = 4 + j3, A - B =
8.062 ∠29.7°
10 ∠45°
2.236 ∠243.43°
6.72 ∠243.43°

⇒ The frequency response of an ideal tuned amplifier should be as represented in figur
A
B
C
D

⇒ PA radar means
Phased Array radar
Pulsed Array radar
Pulse Amplitude radar
None of the above

⇒ IC (instruction cycle), FC (fetch cycle) and EC (executive cycle) are related as
IC = FC - EC
IC = FC + EC
IC = FC + 2EC
EC = IC + EC

⇒ Which of the following is not a conducting material?
Copper
Tungsten
Germanium
Platinum

⇒ Class C operation finds application in
RF power amplifiers
frequency multipliers
both (a) and (b)
neither (a) nor (b)

⇒ A choke coil has a resistance to reactance ratio of 0.2. The power factor of the choke coil is
less than 0.2 lagging
less than 0.2 leading
about 1
about 0

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math