Question is ⇒ For pole-zero plot shown, the system is ________, Options are ⇒ (A) minimum phase, (B) maximum phase, (C) mixed phase, (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ For pole-zero plot shown, the system is ________, Options are ⇒ (A) minimum phase, (B) maximum phase, (C) mixed phase, (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For pole-zero plot shown, the system is ________
A.	minimum phase [Correct Answer]
B.	maximum phase [Wrong Answer]
C.	mixed phase [Wrong Answer]
D.	none of these [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ AGC voltage is applied to the stages which are
before the detector stage
after the detector stage
either before or after the detector stage
none of the above

⇒ In a 4-ary FSK, the frequencies are separated by f_s. Then they are
in phase
in phase opposition
orthogonal
none of the above

⇒

Assertion (A): A JFET can be used as a current source.

Reason (R): In beyond pinch off region the current in JFET is nearly constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a platinum RTD, the change in resistance for a temperature rise of 50° C is about
0.02
0.1
0.2
0.4

⇒ In a directional coupler
isolation (dB) equals coupling plus directivity
coupling (dB) equals isolation plus directivity
directivity (dB) equals isolation plus coupling
isolation (dB) equals (coupling) (directivity)

⇒ CMRR of an op-amp is about 0.1.
TRUE
FALSE

⇒

Assertion (A): Hollow waveguides are frequently used as transmission lines at microwave frequencies.

Reason (R): Waveguide has high power handling capacity, low loss and simple structure.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In figure V_i may vary from 15 to 20 V and load current may vary from 20 mA to 100 mA. Suitable maximum value of
20 Ω
50 Ω
100 Ω
200 Ω

⇒ If the load current is high, the pressure coil of wattmeter should be connected directly across the load.
TRUE
FALSE

⇒ For a half wave rectified voltage, the form factor and peak factor respectively are
1.11 and 2
1.57 and 2
1.11 and 1.11
1.57 and 2

⇒ Pulse modulation is often used in
microwave band
FL band
telegraphy
telephony

⇒ Transit time is considered as significant at
HF
MF
LF
all of the above

⇒ MOSFET can be used as a
current controlled capacitor
voltage controlled capacitor
current controlled inductor
voltage controlled inductor

⇒ In decimal system the base of radix is
0
1
10
e

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
114 kW
336 kW
384 kW
455 kW

⇒ I = dq/dt.
TRUE
FALSE

⇒ In which of the following device electrons will be the majority carriers?
P-type semiconductor
N-type semiconductor
N-P-N transistor
P-N-P transistor

⇒ In a base driver amplifier the voltage gain is the ratio of
ac collector voltage to ac base voltage
ac emitter voltage to ac base voltage
ac collector voltage to ac emitter voltage
ac base voltage to ac emitter voltage

⇒ The standard FORTRAN exponential form of decimal number - 0.000000023 is
2.3 E - 8
-2.3 E - 8
2.3 E - 7
-2.3 E - 7

⇒ Two rectangular waveforms of duration t₁ and t₂ seconds are convolved. What is the shape of the resulting waveform?
Triangular
Rectangular
Trapezoidal
Semi-circular

⇒

Match the following:

	List I		List II
A.	Total instantaneous value of emitter current	1.	I_E
B.	Quiescent value of emitter current	2.	i_E
C.	Instantaneous value of as component of emitter current	3.	I_e
D.	RMS value of ac component of emitter current	4.	i_e

A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3
A-2, B-1, C-3, D-4
A-2, B-3, C-4, D-1

⇒ The open loop frequency response of a unity feed back system is as u
20 dB and 15°
20 dB and 25°
6 dB and 15°
6 dB and 25°

⇒ Consider the following applications/ advantages of radar beacons

navigation
target identification
accurate tracking of enemy targets
large increase in maximum range

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2
2, 3, 4

⇒ A meter having 0-1000 μA range and 1000 Ω resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about
1 Ω
10 Ω
99 Ω
100 Ω

⇒ The following statements are true with respect to "Cascode Amplifier".

The reduction in h₁₂ and Miller capacitance result in negligible reverse internal feedback.
A's is large loads cannot be connected.
As a narrow band amplifier, it provides small range of c_μ is reduced.
As a narrow band amplifier it provides small range of frequencies parameters the effect of c_μ reduces.

only 1
only 1 and 4
only 2 and 4
only 1 and 3

⇒ In a positive-edge-triggered JK flip-flop, a low J and a low K produce __________ state. A high __________ on the rising edge of the clock.
inactive, reset
active, reset
active, toggle
inactive, toggle

⇒ In cell phone antennas are
monopole
loops
helical
lens

⇒ Consider the following program for 8085 decimal 20
decimal 40
decimal 10
none of the above

⇒ A voltage wave containing 10% third harmonic is applied to a scries R-L circuit. The percentage third harmonic content in the current wave will be
more than 10%
10% or less than 10%
less than 10%
10% or more or less

⇒ The emitter coupled pair of BJT's gives a linear transfer relation between the differential output voltage and the differential input voltage V_id only when the magnitude of V_id is less a times the thermal voltage, where a is
4
3
2
1