Question is ⇒ For iron, the ferromagnetic Curie temperature is, Options are ⇒ (A) about 20 K, (B) about 100°C, (C) about -20°C, (D) about 1000 K, (E) , Leave your comments or Download question paper.

Question is ⇒ For iron, the ferromagnetic Curie temperature is, Options are ⇒ (A) about 20 K, (B) about 100°C, (C) about -20°C, (D) about 1000 K, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For iron, the ferromagnetic Curie temperature is
A.	about 20 K [Wrong Answer]
B.	about 100°C [Wrong Answer]
C.	about -20°C [Wrong Answer]
D.	about 1000 K [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Flash converter ADC	1.	requires conversion time of a few μs
B.	Dual slope ADC	2.	requires DAC
C.	Successive approximation ADC	3.	minimizes the effect of power supply interference
		4.	requires complex hardware
		5.	is a tracking ADC

A-2, B-3, C-4
A-4, B-3, C-2
A-5, B-4, C-3
A-1, B-2, C-5

⇒ A push pull amplifier balance out
odd harmonics
even harmonics
both odd as well as even harmonics
neither odd nor even harmonics

⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.
TRUE
FALSE

⇒ A coaxial RF cable has a characteristic impedance of 50 Ω and C equal to 40 pF/m. The inductance is
1 μ H/m
10 μ H/m
0.1 μ H/m
0.01 μ H/m

⇒ The correct relation between energy and charge is
Energy = voltage/charge
Charge = Energy x voltage
Energy = voltage (charge)^0.5
Energy = voltage x charge

⇒ Which converter is used in HVDC transmission?
3 pulse
6 pulse
12 pulse
24 pulse

⇒ In radar PRF depends on maximum range.
TRUE
FALSE

⇒ Which of the following instruction modes does not exist in microprocessor 8085?
Inherent
Immediate
Absolute
Indirect

⇒ In Z_RC (s) = 0 at s = ∞, the last element in first Cauer form is
R
C
R and C in series
R and C in parallel

⇒ The resistance of a dc galvanometer is 20 Ω. A current of 10 mA causes full scale deflection. To convert it into 0-300 V voltmeter, we have to use a series resistance of
30000 Ω
29980 Ω
6000 Ω
15 Ω

⇒ The number of thyristors in a single phase fully controlled bridge rectifier is
16
8
4
2

⇒ Binary multiplication 1 x 0 =
1
0
10
11

⇒ Figure shows the equivalent circuit of resistor. The resistor is non-inductive w
R = L/C
LR = L/C
L = CR²
C = LR²

⇒ In a rectangular waveguide cutoff wavelength for TE₁₀mode is 8 cm. Then cutoff wavelength for TE₂₀ mode is
8 cm
6 cm
4 cm
2 cm

⇒ T- FF used as a
transfer Data switch
toggle switch
time delay switch
none

⇒ (22)₄ + (101)₃ - (20)₅ = (x)₄ + (4)_x+1 where x > 4. The value of x is
6
4
12
8

⇒ A current is flowing through a conductor with non-uniform area of cross-section. Then
current will be different at different cross-sections.
current will be the same at all the cross-sections.
current will be different but current density will be same at all the cross-sections
current will be the same but current density will be different at different cross-sections.

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The reflection coefficient will be
0.08 + j 0.32
0.32 + j 1.38
0.70 - j 2.97
1.1 + j 0.32

⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω

⇒ In 2's complement addition, the carry generated in the last stage is
added to LSB
neglected
added to bit next to MSB
added to the bit next to LSB

⇒ Integral control action
removes offset
may lead to oscillatory response
both (a) and (b)
neither (a) nor (b)

⇒ Radiation intensity does not depend upon
the antenna direction
antenna width
both (a) and (b)
none of the above

⇒ In a number system with radix r, the decimal value of 110 is equal to 4r. The decimal values of 111 and r respective are equal to
20, 5
16, 4
13, 3
8, 2

⇒ Which control action can never be used alone?
Proportional
Derivative
Integral
Both (b) and (c)

⇒ Microwave resonators are used in
microwave oscillators
microwave narrow band amplifier
microwave frequency metres
all of the above

⇒ Bode magnitude plot is drawn between
magnitude of network function and ω
dB magnitude and log ω
dB magnitude and ω
log_e (magnitude) and log ω

⇒ Due to the formation of Schottky defects the density of the crystal
increases slightly
increases appreciably
decreases slightly
decreases appreciably

⇒ In the spectrum of an FM wave
When modulation index is large, carrier frequency disappears
carrier frequency cannot disappear
amplitude of any side band depends on modulation index
the total number of side bands depend on modulation index

⇒ An op-amp is fed from a signal source through resistance R₁. If it is to work as sign changer, the feedback resistance R_f should be
equal to R₁
twice R₁
half R₁
either (b) or (c)

⇒ The feedback control system shown in figure is stable for what values of K and
K < 0, T > - 1
K > 0, T > 0
K > 0, T > - 1
K < 0, T > 0