Question is ⇒ For input and later stages, BI-FET op-amp use, Options are ⇒ (A) JFETs and MOSFETs respectively, (B) MOSFETs and JFETs respectively, (C) JFETs and BJTs respectively, (D) BJTs and JFETs respectively, (E) , Leave your comments or Download question paper.

Question is ⇒ For input and later stages, BI-FET op-amp use, Options are ⇒ (A) JFETs and MOSFETs respectively, (B) MOSFETs and JFETs respectively, (C) JFETs and BJTs respectively, (D) BJTs and JFETs respectively, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For input and later stages, BI-FET op-amp use
A.	JFETs and MOSFETs respectively [Wrong Answer]
B.	MOSFETs and JFETs respectively [Wrong Answer]
C.	JFETs and BJTs respectively [Correct Answer]
D.	BJTs and JFETs respectively [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following functions would have only odd powers of x in its Taylor series expansion about the point x = 0?
sin (x³)
sin (x²)
cos (x³)
cos (x²)

⇒ In figure v₁ = 8 V and v₂ = 8 V. Which diode will cond
D₁ only
D₂ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
7.07 mA and 70.7 V
70.7 mA and 70.7 V
0.707 mA and 70.7 V
7.07 mA and 70.7 x 10³ V

⇒ An RLC series circuit is excited by a step voltage E. The units of roots of characteristic equation are
seconds
1/seconds
tesla
henry

⇒ When transient and steady state response require improvement; a __________ is used.
Lead compensator
Lag - Lead compensator
Lag compensator
Integrator

⇒ If a class C power amplifier has an input signal with frequency of 200 kHz and the width of collector current pulses of 0.1 ms, then the duty cycle of the amplifier will be
0.01
0.02
0.1
0.2

⇒ When a CE transistor is cut off
voltage across collector reduces to zero
voltage across collector is maximum
maximum collector current flows
maximum voltage appears across the load resistance

⇒ In 8085 the address space size is
64 kbits
64 k bytes
32 kbits
16 k bytes

⇒ In a series circuit with X_L constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE

⇒ In single tone FM discriminator (S₀/N₀) is
proportional to deviation
proportional to cube of deviation
proportional to square of deviation
none of the above

⇒ F = ∑(0, 3, 4, 5, 7) =
[B ⊕ C] + AC
B'C' + BC + AC
AB + BC + CA
None

⇒ Figure shows the terminals of a transistor in plastic package TO 18. T
terminals 1, 2, 3 are emitter, collector, base respectively
terminals 1, 2, 3 are emitter, base, collector respectively
terminals 1, 2, 3 are base, emitter collector, respectively
terminals 1, 2, 3 are collector, emitter, base respectively

⇒ In figure V_BE = 0.7 V. The base curren
above 97 μA
about 97 mA
about 75 μA
about 75 mA

⇒ In home tape recorders the tape width is 2 inches.
TRUE
FALSE

⇒ A voltage wave is i = 100 sin (ωt). Its average value calculated over one half cycle is
zero
70.72 V
63.70 V
none of the above

⇒ The depletion type MOSFET can operate in
depletion mode only
enhancement mode only
depletion or enhancement mode
neither depletion nor enhancement mode

⇒ Typical switching time for ECL is
5 nano seconds
5 micro seconds
5 milli seconds
5 seconds

⇒ In 8085 the instruction MOV A, B is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ The number of roots of s³ + 2s² + 7s + 3 = 0 in the left half of the s-plane is :
zero
one
two
three

⇒ If a signal band limited for f_m is sampled at a rate less than 2 f_m the reconstructed signal will be
smaller in amplitude
distorted
having higher frequencies suppressed
none of the above

⇒ For the gate in the given figure the output wil
0
1
A
A

⇒ Which of the following real expressions is incorrect in Pascal?
Y - X
(A + B) (C + D)
X / Y - Z
P * Z - 5.0

⇒ The impurity commonly used for realizing the base region of a n-p-n transistor is
gallium
indium
boron
phosphorus

⇒ VF glows with __________ colour when activated.
Red
Orange
Bluish green
none of these

⇒

Assertion (A): The gall tinsley potentiometer is a coordinate potentiometer and has two exactly similar potentiometers.

Reason (R): An ac potentiometer may measure the unknown voltage in polar form or rectangular coordinate form.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of these has poor overload capacity?
PMMC instrument
Hot wire instrument
Dynamometer instrument
Both (a) and (c)

⇒ Maxterm designation for A + B + C is
M₀
M₁
M₃
M₄

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ A standard cell of 1.0185 V is used with a slide wire potentiometer. The balance was obtained at 60 cm. When an unknown emf was connected, the balance was obtained at 82 cm. The magnitude of unknown emf is
1.39 V
0.75 V
13.9 V
7.45 V

⇒ If Z(s) has a pole at origin, the realization leads to
a resistance in series
an inductance in series
a capacitance in series
a resistance or capacitance in series