Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | For hydro-dynamically smooth boundary, the friction coefficient for turbulent flow is. |

A. | constant [Wrong Answer] |

B. | dependent only on Reynolds number [Correct Answer] |

C. | a function of Reynolds number and relative roughness [Wrong Answer] |

D. | dependent on relative roughness only [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :Shriram Bairwa Said on 2018-12-04 05:55:52For rough pipe and C But for smooth and is B !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The weight per unit volume of a liquid at a standard temperature and pressure is called

Specific weight

Mass density

Specific gravity

None of these

⇒ The major loss of energy in long pipes is due to.

sudden enlargement

sudden contraction

gradual contraction or enlargement

friction

⇒ The velocity distribution for laminar flow through a circular tube.

is constant over the cross-section

varies linearly from zero at walls to maximum at centre

varies parabolically with maximum at the centre

none of the above

⇒ Drag force is a function of

Velocity of the body

Mass density of the fluid

Projected area of the body

All of the above

⇒ The buoyancy depends upon the

Pressure with which the liquid is displaced

Weight of the liquid displaced

Viscosity of the liquid

Compressibility of the liquid

⇒ Flow in a pipe is laminar if the Reynold's number is

Less than 2000

Between 2000 and 4000

Between 4000 and 6000

Equal to 10000

⇒ Froude number is the ratio of inertia force to

Pressure force

Viscous force

Gravity force

Elastic force

⇒ The horizontal to vertical side slope in case of cippoletti weir ?

1 : 1

1 : 4

1 : 2

4 : 1

⇒ For a sphere of radius 15 cm moving with a uniform velocity of 2 m/sec through a liquid of specific gravity 0.9 and dynamic viscosity 0.8 poise, the Reynolds number will be

300

337.5

600

675

⇒ 1 atm. pressure is equivalent to

1.315 kgf/cm

^{2}

1000 newton

760 mm Hg

14.7 pascal

⇒ Which of the following has highest coefficient of discharge ?

sharp edged orifice

venturimeter

Borda's mouthpiece running full

CipoUetti weir

⇒ The ratio of average velocity to maximum velocity for steady laminar flow in circular pipes is.

1/2

2/3

3/2

2

⇒ A barometer is used to measure

Very low pressure

Very high pressure

Pressure difference between two points

Atmospheric pressure

⇒ If the Froude's number of flow in an open channel is more than 1.0 then the flow is said to be

Critical

Shooting

Streaming

Transitional

⇒ An open cubical tank of 2 m side is filled with water. If the tank is rotated with an acceleration such that half of the water spills out, then the acceleration is equal to.

g/3

g/2

2g/3

g

⇒ If x is the distance from leading edge, then the boundary layer thickness in laminar flow varies as.

x

x/2

x/3

x/7

⇒ The power channel that extends from the intake works to the power house is called

Lead race

Head race

Diversion canal

Penstock

⇒ A wooden cylinder floats vertically in water with half of its length immersed. The density of wood is

Equal to that of water

Half the density of water

Double the density of water

The question is incomplete

⇒ The sheet of water flowing through a notch or over a weir is known as

Nappe

Crest

Height of weir/notch

Sill

⇒ A boat with wood is floating in a lake. If the wood is thrown in the lake the water level will

Go up

Go down

Remain unchanged

None of the above

⇒ The pressure drag depends upon

The boundary layer formation

The separation of boundary layer

The size of wake

Both (B) and (C) above

⇒ Coefficient of velocity of venturimeter

is independent of Reynolds number

decreases with higher Reynolds number

is equal to the coefficient of discharge of venturimeter

none of the above

⇒ If the weight of a body immersed in a fluid exceeds the buoyant force, then the body will.

rise until its weight equals the buoyant force

tend to move downward and it may finally sink

float

none of the above

⇒ The friction drag is more than pressure drag for

A sphere

A streamlined body

A circular disc placed normal to the flow direction

An air foil

⇒ Which of the following is used to measure the discharge ?

current meter

venturimeter

pitot tube

hotwire anemometer

⇒ The distance from pipe boundary, at which the turbulent shear stress is one-third die wall shear stress, is.

1/3 R

1/2 R

2/3 R

3/4R

⇒ A boat with scrap iron is floating in a lake. If the scrap iron is thrown in the lake the water level will

Go up

Go down

Remain unchanged

None of the above

⇒ Coefficient of velocity of venturimeter.

is independent of Reynolds number

decreases with higher Reynolds number

is equal to the coefficient of discharge of venturimeter

none of the above

⇒ A wooden piece floats half submerged in a tub of water. If the system is transferred to a lift ascending, with acceleration the wooden piece will

Sink a little more

Rise a little

Remain half submerged

Will sink to the bottom

⇒ A piece of length more than double the diameter of orifice fitted externally or internally to the orifice is called a

Notch

Weir

Mouth piece

Nozzle