Question is ⇒ For frequency up to 1650 kHz, the transmitting antenna is used a, Options are ⇒ (A) parabolic dish, (B) vertical antenna, (C) yagi antenna, (D) turnstile antenna, (E) , Leave your comments or Download question paper.

Question is ⇒ For frequency up to 1650 kHz, the transmitting antenna is used a, Options are ⇒ (A) parabolic dish, (B) vertical antenna, (C) yagi antenna, (D) turnstile antenna, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For frequency up to 1650 kHz, the transmitting antenna is used a
A.	parabolic dish [Wrong Answer]
B.	vertical antenna [Correct Answer]
C.	yagi antenna [Wrong Answer]
D.	turnstile antenna [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In cable TV local programmes can be telecast at any frequency.
TRUE
FALSE

⇒ The radiation resistance of a λ/16 wire dipole in free space will be nearly
1 Ω
3 Ω
13 Ω
30 Ω

⇒ In the given figure,
(A + B)C + DE
AB + C(D + E)
(A + B)C + D + E
none of the above

⇒ In a ballistic galvanometer, a charge of 100 μC gives a first swing of 25°. The charge required to cause first swing of 50° is
200 μC
400 μC
50 μC
25 μC

⇒ A conditionally stable system is stable for the value of gain between two critical values. It is unstable if
the gain is increased beyond upper critical value
the gain is decreased below lower critical value
both (a) and (b)
none of the above

⇒ The total number of channels allotted for cellular telephone is
666
333
221
111

⇒ In Z_RC (s) has a pole at s = ∞, the last element in first Foster realization is
R
C
R and C in series
R and C in parallel

⇒ A band limited signal is sampled at the Nyquist rate. The signal can be recovered by passing the samples through
an RC filter
an envelope detector
a PPL
an ideal low pass filter with the appropriate bandwidth

⇒ The first and second subscripts in models of circular waveguides depict
the number of full sine wave variations in circumference in direction and Bessel function variations in radial direction respectively
the Bessel function variations in radial direction and the number of full sine wave variations in circumference direction respectively
the Bessel function variations in circumference direction and number of full sine wave variations in radial direction respectively
none of the above

⇒ Which of the following diode is designed to operate in the breakdown region?
Signal diode
Power diode
Zener diode
None of the above

⇒ Two identical silicon diodes D₁ and D₂ are connected back to back shown in figure. The reverse saturation current I_s of each diode is 10^-8 amps and the breakdown voltage V_Br is 50 v. Evaluate the voltages V_D1 and V_D2 dropped across the diodes D₁ and D₂ assuming KT/q to be 25
4.983 V, 0.017 V
- 4.98 V, - 0.017 V
0.17 V, 4.983 V
- 0.017 V, - 4.98 V

⇒ In FM, increased depth of modulation increases
modulation
modulation index
bandwidth
all of the above

⇒ If B = 4 + j3, (B)^1/3 =
2 ∠30°
2 ∠36.87°
1.71 ∠12.3°
1.71 ∠30°

⇒ In which amplifier circuit is gate conductance negligible?
JFET amplifier
MOSFET amplifier
Both JFET and MOSFET amplifier
None of the above

⇒ DVD uses
Laser beam for both recording and playback
Laser beam for recording and video head for playback
Video head for recording and laser beam for playback
None of the above

⇒ In all metals
conductivity decreases with increase in temperature
current flow by electrons as well as by holes
resistivity decreases with increase in temperature
the gap between valence and conduction bands is small

⇒ In a positive-edge-triggered JK flip-flop, a low J and a low K produce __________ state. A high __________ on the rising edge of the clock.
inactive, reset
active, reset
active, toggle
inactive, toggle

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ For the circuit shown in the following figure I₀-I₃ are inputs to the 4:1 multiplexer R(MSB) and S are control
PQ + PQ S + Q R S
P Q + PQ R + P Q S
P Q R + P QR + PQRS + Q R S
PQ R + PQR S + P Q R S + Q R S

⇒ The factors which govern fan out of CMOS gates are
maximum permissible propagation delay
input capacitance of each load
both (a) and (b)
neither (a) nor (b)

⇒ The voltage across the secondary of the transformer in a half wave rectifier with a shunt capacitor filter is 50 volts. The maximum voltage that will occur on the reverse biased diode will be
100 V
88 V
50 V
25 V

⇒ In the given figure assume that initially Q = 1 with Clock Pulses being given, the subsequent states of Q wil
1, 0, 1, 0, 1......
0, 0, 0, 0, 0......
1, 1, 1, 1, 1......
0, 1, 0, 1, 0......

⇒ The drift velocity of electrons and holes is proportional to electric field strength.
TRUE
FALSE

⇒ In a TWT the axial component of electric field advances along the tube
at a velocity that is almost equal to speed of light
at a velocity that is a small fraction of speed of light
at a velocity that is about 50% of speed of light
at a velocity that may be even more than speed of light

⇒ When an electric field E is applied to solid and liquid insulating materials, the internal field E_i acting at the location of atom is such that
E_i = E
E_i > E
E_i < E
E_i may be equal to or less than E

⇒ For a transistor to have-a larger β it must have and a
close to zero
close to 0.5
close to unity
nearly infinite

⇒ If (225)_Y = (165)₈ find value of Y
7
8
9
11

⇒ The power consumption of a present day colour TV receiver is about
8 W
80 W
200 W
400 W

⇒

Assertion (A): For high frequency lines inductive reactance is very high as compared to ac resistance.

Reason (R): Due to skin effect ac resistance of line is higher than dc resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A full wave rectifier using centre tapped transformer and a bridge rectifier use similar diodes and have equal no load output voltage. Under equal load conditions
Output voltage of bridge rectifier
Output voltage of bridge rectifier will be more than that of other
Output voltage of both will be exactly equal
Output voltage of any one may be more than that of other