Question is ⇒ For Ergodic Process, Options are ⇒ (A) ensemble Average equal to time Average, (B) ensemble Average is not equal to time Average, (C) ensemble Average > Time Average, (D) ensemble Average < Time Average, (E) , Leave your comments or Download question paper.

Question is ⇒ For Ergodic Process, Options are ⇒ (A) ensemble Average equal to time Average, (B) ensemble Average is not equal to time Average, (C) ensemble Average > Time Average, (D) ensemble Average < Time Average, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For Ergodic Process
A.	ensemble Average equal to time Average [Correct Answer]
B.	ensemble Average is not equal to time Average [Wrong Answer]
C.	ensemble Average > Time Average [Wrong Answer]
D.	ensemble Average < Time Average [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 8086 the flag which enables or disables external interrupts is
IF
DF
TF
CF

⇒ Some words like READ, WRITE, STOP etc. cannot be used as variable names in Fortran 77.
TRUE
FALSE

⇒ In an amplifier circuit the emitter is at ac ground potential in a
CB circuit
CC circuit
CE circuit
both CB and CE circuit

⇒ The power density spectrum of noise voltage of resistor R can be expressed as
2 kTR
1 kTR
0.5 kTR
0.25 kTR

⇒ A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.999 V, the resolution is
1 V
0.01 V
1 mV
1 μV

⇒

Assertion (A): EM waves are attenuated as they travel outward from a source

Reason (R): Both field intensity and power density follow inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a JFET
drain current is very nearly equal to source current
drain current is much less than source current
drain current may be equal to or less than source current
drain current may be even more than source current

⇒ Figure shows four D type FFs are connected as a shift register using an XOR gate. The initial state and 3 subsequent states for 3 clock pulses are also g
0
1111
1001
1000

⇒ What is the correct sequence of the following step in the fabrication of a monolithic, Bipolar junction transistor?

Emitter diffusion
Base diffusion
Buried layer formation
E pi-layer formation

Select the correct answer using the codes given below:
3, 4, 1, 2
4, 3, 1, 2
3, 4, 2, 1
4, 3, 2, 1

⇒ If a number of even functions are added, the resultant sum is
even function
odd funtion
either even or odd function
mixture of odd amd even functions

⇒ In following circuit, steady state is reached with S open, S is closed at t = 0, the current I at t = 0⁺ is give
9 Ω
6 Ω
7 Ω
10 Ω

⇒ Figure shows a Wheatstone bridge with RTD to one arm. If resistance of RTD = 1020 Ω, the voltage V₀
49 mV
51 mV
48 mV
45 mV

⇒ Internet is a worldwide network of computers where most of the information is freely available.
TRUE
FALSE

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ In a tape recorder
the width of air gaps of record and erase heads is almost equal
the air gap of record head is wider than the air gap of erase head
the air gap of erase head is wider than the air gap of record head
any of the two air gaps can be wider than the other

⇒ When tracing through a resistance we always get a voltage drop.
TRUE
FALSE

⇒ The loops ' for , 'while' , 'do-while' are used in
Fortran 77
Pascal
C
none of the above

⇒ In a low power factor wattmeter, compensation for pressure coil current is provided.
TRUE
FALSE

⇒ A CMOS amplifier when compared to an N-channel. MOSFET, has the advantage of
higher cut off frequency
higher voltage gain
higher current gain
lower current drain from the power supply, there by less dissipation

⇒ If one wants to design a binary counter, preferred type of flip-flop is
D-type
SR type
Latch
JK type

⇒ In a single sideband suppressed carrier AM system, the modulation index is changed from 0 to 1, the power content of the signal
will be quarter
will be doubled
will increase by 50 percent
will increase by 25 percent

⇒ Magnesium is alloyed with conducting materials for antenna primarily with the purpose of
increasing efficiency
improving radiative power
reducing weight
increasing density

⇒ When a P-N junction is unbiased, the junction current at equilibrium is
zero as no charges cross the junction
zero as equal number of carriers cross the barrier
mainly due to diffusion of majority carriers
mainly due to diffusion of minority carriers

⇒ If INT = 50 and LOOT = 30, the result of assignment statement SAL = INT + LOOT is
50
80
8
5

⇒ Power Point is a presentation software.
TRUE
FALSE

⇒ Turn on time of a transistor switch is equal to sum of (where t_r is rise time, t_d is delay time)
t_s - t_r
t_s - t_f
t_d + t_r
2t_r

⇒ It is desired to clean up ragged looking pulsed that have been distorted during transmission from one place to another, which of the following device will be appropriate?
Multiplexer
D/A converter
JK flip-flop
Schmitt trigger

⇒ An antenna has a gain of 44 dB. Assuming that the main beam of the antenna is circular in cross-section the beamwidth will be
0.4456°
1.4456°
2.4456°
3.4456°

⇒ 7BF₁₆ = __________ ₂
0111 1011 1110
0111 1011 1111
0111 1011 0111
0111 1011 0011

⇒ In 8085 microprocessor, which of the following interrupts is unmaskable interrupts?
RST 5.5
RST 7.5
TRAP
INTR