Question is ⇒ For Disk partitioning th DOS command is, Options are ⇒ (A) F DISK, (B) H DISK, (C) A DISK, (D) D DISK, (E) , Leave your comments or Download question paper.

Question is ⇒ For Disk partitioning th DOS command is, Options are ⇒ (A) F DISK, (B) H DISK, (C) A DISK, (D) D DISK, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For Disk partitioning th DOS command is
A.	F DISK [Correct Answer]
B.	H DISK [Wrong Answer]
C.	A DISK [Wrong Answer]
D.	D DISK [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): CCIR-B system has 625 scanning lines per frame and 2 : 1 interlace.

Reason (R): The aspect ratio is 4 : 3

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ VLF is generally used for
telegraphy
satellite communication
instrument landing system
all of the above

⇒ The power rating of radio transmitters is around
100 mW
10 W
10 kW
10 MW

⇒ Flash ADC is
serial ADC
parallel ADC
series-parallel ADC
successive approximation ADC

⇒ A lead compensator
speeds up the transient response
increases the stability margin
increases the stability margin and speeds up the transient-response.
none of the above.

⇒ The circuit shown in the figure has 4 boxes each described by inputs P, Q, R and outputs Y, Z
4 bit adder giving P + Q
4 bit subtractor giving P - Q
4 bit subtractor giving Q - P
4 bit adder giving P + Q + R

⇒ As compared to 17.34° antenna, the total increase in the signal relayed by 4.5° antenna of INTELSAT-IV is
14.85
220
78
3.85

⇒ Which of the following has a major role in implementation of functions calls in C?
Processor's registers
Data segment
The heap
System stack

⇒ f_unity of an op-amp is about 1 kHz.
TRUE
FALSE

⇒ A series resonant circuit has R = 10 Ω, L = 1 μH and C = 1 mF. If R is increased to 20 Ω the resonant frequency
increases
decreases
remains constant
may increases or decreases

⇒ Words having 8 bits are to be stored into computer memory. The number of lines required for writing into memory are
1
2
4
8

⇒ For maximum output the width of air gap of audio head should be
equal to wavelength
half the wavelength
one quarter the wavelength
very small as compared to wavelength

⇒ The word 'LORAN' means
long range navigation
long range TV transmission
long range cable transmission
either (b) or (c)

⇒ The duration of sunspot cycle is
1 year
11 years
55 years
100 years

⇒ In a common Emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche breakdown of Base emitter junction
collector to Base Breakdown voltage with emitter open (βV_CBO)
collector Emitter Breakdown voltage with base open (βV_CBO)
zener breakdown voltage of the emitter base Junction

⇒ When the height of a vertical earthed antenna is less than λ/4
the base input impedance will be capacitive
the base input impedance will be purely resistive
the base input impedance will be inductive
the base input impedance will be negligibly small

⇒

Assertion (A): If we overdrive an amplifier the output signal may get clipped

Reason (R): To dissipate heat to atmosphere a heat sink is sometimes attached to the case of transistor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): In 8085, P flag is for parity checking.

Reason (R): If the result of ALU has even parity, P flag is set and if the result has odd parity, P flag is reset.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ For TV broadcast, picture signal is modulated in
SSB
VSB
FM
AM

⇒ What is the characteristic of a good control system?
Sensitive to parameter variation
Insensitive to input command
Neither sensitive to parameter variation nor sensitive to input commands
Insensitive to parameter variation but sensitive to input commands

⇒ In a loss less line the propagation constant is equal to
jωLC
LC
jωLC
LC

⇒ Which of the following flip-flop is used as a latch?
J K flip-flop
R S flip-flop
T flip-flop
D flip-flop

⇒ Which synthesis procedure requires the use of mutual inductance?
Foster's synthesis
Cauer synthesis
Bott-Duffin synthesis
Brune's synthesis

⇒ The current through a 1 mH inductance is i(t) = 2.56 x 10^-2 - 4 x 10³ t for 2 ≤ t ≤ 20 μ sec. The voltage across the inductor is
4
8
0
8 x 10³

⇒ Pagemaker is an application software for DTP.
TRUE
FALSE

⇒ If J = 12 and X = 24.4 the result of the following FORTRAN 77 program will be 12, 144, 73.2
15.0, 144.0, 73.2
15.0, 144.0, 73
15. 144. 73

⇒ A single phase dual converter consists of
two fully controlled converters connected in parallel
two fully controlled converters connected in antiparallel
two fully controlled semiconverters connected in antiparallel
two fully controlled semiconverters connected in parallel

⇒ A remote control for TV uses
LED in receiver and photodiode in transmitter
LED in transmitter and photodiode in receiver
LED in both transmitter and receiver
Photodiode in both transmitter and receiver

⇒ The sum of positive real function is positive real.
TRUE
FALSE

⇒ The type of noise that interfere very much with high frequency transmission is
white
transit time
flicker
shot