Question is ⇒ For determining the network functions of a two-port network, it is required to consider that, Options are ⇒ (A) all initial conditions remain same, (B) all initial conditions are zero, (C) part of initial conditions are equal to zero, (D) initial conditions vary depending on nature of network, (E) , Leave your comments or Download question paper.

Question is ⇒ For determining the network functions of a two-port network, it is required to consider that, Options are ⇒ (A) all initial conditions remain same, (B) all initial conditions are zero, (C) part of initial conditions are equal to zero, (D) initial conditions vary depending on nature of network, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For determining the network functions of a two-port network, it is required to consider that
A.	all initial conditions remain same [Wrong Answer]
B.	all initial conditions are zero [Correct Answer]
C.	part of initial conditions are equal to zero [Wrong Answer]
D.	initial conditions vary depending on nature of network [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ EEPROM permits
read operation only
read and byte erase operations
read, byte erase and byte write operations
read, byte erase, byte write and chip erase operations

⇒ Electric dipole moment is expressed in debye unit.
TRUE
FALSE

⇒ The loops ' for , 'while' , 'do-while' are used in
Fortran 77
Pascal
C
none of the above

⇒ Advanced low power Schottky is a part of
ECL family
CMOS family
TTL family
none of the above

⇒

Assertion (A): A JFET can be used as a current source.

Reason (R): In beyond pinch off region the current in JFET is nearly constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In phase modulation, the phase deviation is
proportional to the amplitude of the signal and varies with frequency
remains constant while amplitude and frequency of signal varies
proportional to the amplitude of the signal and independent of the frequency
none of the above

⇒ Hysteresis loss is proportional to
f and B^1.6_m
f and B_m
f² and B_m
f² and B²_m

⇒ The disadvantage of FET over BJT is
poor high frequency performance
low power-handling ability
low values of voltage gain
all of the above

⇒ A single phase half bridge inverter required to feed R-L loads needs
2 thyristors
4 thyristors
2 thyristors and two diodes
4 thyristors and 4 diodes

⇒ When an atom of polarizability a is placed in an electric field E, the energy stored in atom is 0.5 a E².
TRUE
FALSE

⇒ VLF is generally used for
telegraphy
satellite communication
instrument landing system
all of the above

⇒ A boot strap generally incorporates
CB configuration
CE configuration
emitter follower
none of the above

⇒ The waveguides compared to equivalent transmission lines at low frequency are
able to carry more power
less noisy
having lower attenuation
all of the above

⇒ One of the advantages of base modulation over collector modulation of a transistor class C amplifier is
improved efficiency
better linearity
high power output per transistor
the lower modulating power requirement

⇒ Which of the following is/are correct? The circuit shown in the fig
1 and 3
1 and 2
1 and 4
3 only

⇒ The input impedance of short-circuited line of length l where l < λ/4
inductive
capacitive
resistive
none of the above

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are
0101 and 5
0101 and 10
1010 and 5
1010 and 10

⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in
active region
saturation region
cut of region
inverted region

⇒ In a CRO, the time base signal is applied to
X plates
Y plates
either X or Y plates
alternately X and Y plates

⇒ The input impedance of op-amp circuit of figur
120 k ohm
110 k ohm
infinity
10 k ohm

⇒ What will be FSV in 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ
0.99 V
0.9 V
0.1 V
0

⇒ In solid dielectrics the rate of deterioration doubles for every 10-12°C rise in temperature.
TRUE
FALSE

⇒ At a frequency less than the resonant frequency
series circuit is inductive and parallel circuit is capacitive
series circuit is capacitive and parallel circuit is inductive
both circuits are capacitive
both circuits are inductive

⇒ The frequencies in ultra high frequency range are propagated by means of __________ waves
surface
ground
sky
space

⇒

Assertion (A): The duty cycle of a class C amplifier affects the power dissipation of transistor

Reason (R): At higher harmonics the efficiency of a class C amplifier becomes poor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Silicon and germanium have diamond structure. The number of atoms in a volume equal to a³ where a is the edge of elementary cube are
32
16
8
4

⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half the secondary winding is 40 V. If diodes are ideal, the average output voltage is
40 V
25.5 V
20 V
2.55 V

⇒ DOS has a command named ' DIRECTORY '.
TRUE
FALSE

⇒ The maximum concentration of the element which can be dissolved in solid silicon at a given temperature is termed as
Solid solubility
Dissolution coefficient
Solidification index
Concentration index