Question is ⇒ For demodulating PCM; it is first converted into, Options are ⇒ (A) PDM, (B) PPM, (C) PWM, (D) PAM, (E) , Leave your comments or Download question paper.

Question is ⇒ For demodulating PCM; it is first converted into, Options are ⇒ (A) PDM, (B) PPM, (C) PWM, (D) PAM, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For demodulating PCM; it is first converted into
A.	PDM [Wrong Answer]
B.	PPM [Wrong Answer]
C.	PWM [Wrong Answer]
D.	PAM [Correct Answer]
View Answer 3 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a linear op-amp circuit
the product of gain and bandwidth is constant
input can be dc only
input can be ac only
saturation may occur

⇒ Find the Fourier transform of the half cosine pulse as shown bel
0.5 {sin c [0.25(f - 1)] + sin c [2.5(f + 1)]}
0.5 {sin c [0.5(f - 1)] + sin c [0.5(f + 1)]}
0.25 {sin c [0.25(f - 1)] + sin c [0.25 (f - 1)]}
0.25 {sin c [0.5(f - 1)] + sin c [0.5(f - 1)]}

⇒ When negative feedback is used the fractional changes in closed loop gain are desensitized by the factor (1 + A_vβ)
TRUE
FALSE

⇒ Figure shows the equivalent circuit of resistor. The resistor is non-inductive w
R = L/C
LR = L/C
L = CR²
C = LR²

⇒ The chip 8254 is a 40 pin programmable interval timer. The number of its independent 16 bit counters is
2
3
4
5

⇒ When a p-n Junction is forward biased
the current flow is due to electrons only
the majority carriers in both p and n materials are driven toward the junction.
the majority carriers in both p and n materials are away from the junction.
both (a) and (c).

⇒ Which element exhibits the property of inertia?
Resistance
Capacitance
Inductance
Both resistance and inductance

⇒ The capacitors C₁, C₃, C₄ and C₅ have a capacitance of 4 μF each and the capacitor C₂ has a capacitance of 10 μF. The effective capacitance (in μF) between the points X and Y will
4 μF
6 μF
3 μF
8 μF

⇒ Consider the instructions

MOV M, B
OUT 4
LDAX

Which of the above require memory write cycle?
1, 2, 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The signal to noise ratio in telemetry should be better than
5 db
10 db
25 db
60 db

⇒ Watthour meter is an integrating instrument
TRUE
FALSE

⇒ In a synchronous counter all flip flops are clocked together.
TRUE
FALSE

⇒ Two voltages are -5 V and -10 V. In positive logic
-5 V is 1 and -10 V is 0
-10 V is 1 and -5 V is 0
-5 V is 1 in some circuits and 0 in others
-10 V is 1 in some circuits and 0 in others

⇒ Which is not a valid dimension statement?
DIMENSION KAT(10, 20)
DIMENSION BAT (30, 20)
DIMENSION KAT(K, 10)
DIMENSION BAT (10, 5)

⇒ In rectangular waveguides the ratio of width to height is about
0.5
1
2
4

⇒ A wire is carrying current I. The field intensity H at a distance r from the wire
is directed towards wire
is directed away from wire
is tangential every where to a circle of radius r
none of the above

⇒ Depth of penetration does not depend on frequency.
TRUE
FALSE

⇒ In 2's complement addition, the carry generated in the last stage is
added to LSB
neglected
added to bit next to MSB
added to the bit next to LSB

⇒ In a CE amplifier the Q point is very close to saturation point on the dc load line. This results in
positive clipping of collector current
negative clipping of collector current
both positive and negative clipping of collector current
either positive or negative clipping of collector current

⇒ In a CE bipolar transistor operating in active region, collector current is independent of
V_CE
I_B
both V_CE and I_B
none of the above

⇒ How many roots with positive real parts do the equation s³ + s² - s + 1 = 0 have?
Zero
One
Two
Three

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒

Match the following:

	List I		List II
A.	shift Register	1.	Frequency division
B.	Counter	2.	Addressing in memory chips
C.	Decoder	3.	Serial to parallel Data conversion

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-1, C-3
A-1, B-2, C-2

⇒ Heating effect of current is used in
ammeters
voltmeters
both ammeters and voltmeters
wattmeters

⇒ Poynting vector is the rate of energy flow having
W/m²
W-m
kWh/s
W/m

⇒ The charge of an electron is
1.6 x 10^-17 coulomb
1.6 x 10^-19 coulomb
1.6 x 10^-21 coulomb
1.6 x 10^-23 coulomb

⇒ For matching over a range of frequencies in a transmission line it is best to use
a balun
a broad band directional coupler
double stub
a single stub of adjustable position

⇒ Directivity gain depends on
the distribution of radiated power in space
solid angle of the radiated field pattern
both (a) and (b)
none of the above

⇒ If t_p is the pulse width, Δ_t is the propagation delay, T is period of pulse train then the following condition can avoid the race around condition
t_p = Δt = T
2t_p > Δt > T
t_p < Δt < T
t_p < Δt < T

⇒ An electron rises through a voltage of 100 V. The energy acquired by it will be
100 eV
100 joules
(100)^1.2 eV
(100)^1.2 joules