Question is ⇒ For any transfer function, the constant phase angle loci are, Options are ⇒ (A) a family of circles, (B) a family of straight lines, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper.

Question is ⇒ For any transfer function, the constant phase angle loci are, Options are ⇒ (A) a family of circles, (B) a family of straight lines, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For any transfer function, the constant phase angle loci are
A.	a family of circles [Correct Answer]
B.	a family of straight lines [Wrong Answer]
C.	either (a) or (b) [Wrong Answer]
D.	neither (a) nor (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Transconductance characteristics of JFET depict the relation between
I_D and V_GS for different value of V_DS
I_D and V_DS for different value of V_GS
V_GS and V_DS for different values of I_D
V_DS and I_D for different values of V_GS

⇒ The minimum charge carried by an ion is
zero
equal to the change of an electron
equal to the change of a pair of electrons
equal to the change of electrons left in the atom

⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.

⇒ Consider the following circuit configuration

common Emitter
common Base
emitter follower
emitter follower using Darlington pair.

The correct sequence in increasing order of I/P impedance of these configuration:
2, 1, 4, 3
1, 2, 4, 3
2, 1, 3, 4
1, 2, 3, 4

⇒ A single phase fully controlled bridge rectifier is fed by a source having inductance. The output voltage during overlap period is
V_m
0.5 V_m
zero
0.5 V_m - voltage drop across inductance

⇒ The number of cells in a 4 variable K map is
16
8
4
32

⇒ A moving coil meter has a resistance of 50 ohms and a full scale deflection current of 20 mA. To convert it into a voltmeter of 0-100 V range, the series resistance should be
5000 Ω
5050 Ω
4950 Ω
505 Ω

⇒ When a p-n-p transistor is operating in active region, the current in the n region is due to
only holes
only electrons
mainly holes
mainly electrons

⇒

Assertion (A): In India we use CCIR-B standard

Reason (R): Video signals are frequency modulated.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒ Calculate cut off frequency for dominant mode in rectangular waveguide if dimensions are a = 2, b = 1 cm.
7.5 GHz
1.5 GHz
15 GHz
150 GHz

⇒ Which of the following statement about TRIAC is incorrect?
It is not particularly suited to A.C. or mains power control
Any one of its main terminals can be used either as cathode or as anode
It can be triggered in response to both positive and negative gate terminals
None of the above

⇒ For 8 bit representation the minimum positive and minimum negative numbers are
2^-128 each
2^-28 and 2^-127
2^-127 and 2^-128
2^-127each

⇒ Which of the following modes of transmission will not be supported by a rectangular waveguide?
TE₁₅
TE₁₂
TM₁₁
TM₁₀

⇒ A function f(t) = k is
stable
marginal stable
unstable
none

⇒ To relay outdoor remotely located live programs, TV transmitter use
microwave links
coaxial cable link
open wire link
either (b) or (c)

⇒ When a lead acid battery is fully charged the colours of its positive and negative plates are
grey and dark brown
dark grey and brown
grey and brown
dark brown and grey

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The capacitors C₁, C₃, C₄ and C₅ have a capacitance of 4 μF each and the capacitor C₂ has a capacitance of 10 μF. The effective capacitance (in μF) between the points X and Y will
4 μF
6 μF
3 μF
8 μF

⇒ The signal defined by the equations f(t) = 0 for t < 0, f(t) = E for 0 ≤ t ≤ a and f(t) = 0 for t > a is
a step function
a pulse function
a shifted step function originating at t = a
none of the above

⇒ Threshold of perception occurs at a current of about 1 mA.
TRUE
FALSE

⇒ Which configuration is suitable for impedance matching?
CB
CE
CC
CB and CE

⇒ Output of a phase splitter is
a pair of sine waves of unequal amplitude
a pair of sine waves of equal amplitudes
a pair of sine waves of equal amplitudes and opposite phase
a pair of sine waves of unequal amplitudes and opposite phase

⇒ In TV transmitter some possible advantages of IF modulation are

The modulator section and visual exciter can be solid state devices
VSB filter can be introduced at low power level
The subsequent stages following VSB filter can be tuned permanently for wideband linear operation
It is economical

which of the above are true?
1 and 2
1, 2 and 3
2, 3 and 4
1, 2, 3 and 4

⇒ With increasing temperature, the electrical conductivity of metals
increases
decreases
increases first and then decreases
remains unaffected

⇒ A 2-terminal network consists of one of the RLC elements. The elements is connected to an ac supply. The current through the element is 1 A. When an inductor is inserted in series between the source and the element, the current through the element becomes 2 A. What is this element?
A resistor
An inductor
A capacitor
Cannot be single element

⇒ In a triode the potential of grid (with respect to cathode) is usually
zero
negative
positive
zero or positive

⇒ Thermal run away of a transistor occurs when
heat dissipation from transistor is excessive
transistor joints melt due to high temperature
there is excessive leakage current due to temperature rise
none of the above

⇒ Which of the following flip-flop is used as a latch?
J K flip-flop
R S flip-flop
T flip-flop
D flip-flop