Question is ⇒ For an RC impedance function Z, Options are ⇒ (A) Z(∞) = Z(0), (B) Z(∞) < Z(0), (C) Z(∞) ≤ Z(0), (D) Z(∞) > Z(0), (E) , Leave your comments or Download question paper.

Question is ⇒ For an RC impedance function Z, Options are ⇒ (A) Z(∞) = Z(0), (B) Z(∞) < Z(0), (C) Z(∞) ≤ Z(0), (D) Z(∞) > Z(0), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an RC impedance function Z
A.	Z(∞) = Z(0) [Wrong Answer]
B.	Z(∞) < Z(0) [Wrong Answer]
C.	Z(∞) ≤ Z(0) [Correct Answer]
D.	Z(∞) > Z(0) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In case of surface waves the field strength at a point is directly proportional to
antenna height
wave frequency
current of the antenna
distance of the point from the antenna

⇒ A 14 pin AND gate IC has __________ AND gates.
8
6
4
2

⇒ In ionosphere incidence angle is 60°. The maximum usable frequency f_m is equal to
2f_c
f_c
0.5 f_c
3 f_c

⇒ Lowest noise can be expected in case of
carbon composition resistors
carbon film resistors
tin oxide resistors
metal film resistors

⇒ For an ideal noise free transistor amplifier the noise factor is
zero
zero dB
1 dB
depends on other factors

⇒ It is desired to reduce distortion in a CE amplifier circuit. We should
reduce emitter current
reduce collector current
reduce ac base voltage
reduce base emitter voltage

⇒ Tesla is unit of
Φ
B
H
MMF

⇒ A specimen of a material has a resistivity of 1.78 x 10⁸ ohm-m. The material is
semiconductor
conductor
semiconductor or conductor
insulator

⇒ An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is
1.6 dB
2 dB
3.6 dB
6 dB

⇒ Periodic recharging of the memory cells at regular intervals of 3 to 8 millisecond is required in a
ROM
Static RAM
Dynamic RAM
PLA

⇒ An op-amp has
low input and output impedance
low input impedance and high output impedance
low output impedance and high input impedance
high output impedance and high input impedance

⇒ The number of days when Earth's shadow falls on a geosynchronous satellite is
88
277
5
10

⇒ If a function f(t) is an odd, function, its Fourier series
contains only sine terms
contains only cosine terms
contains a constant and sine terms
contains a constant and cosine

⇒ Which of the following is not a characteristic of a flip flop?
It is a bistable device
It has two outputs
It has two outputs are complement of each other
It has one input terminal

⇒ The main advantage of TDM over FDM is
TDM requires more bandwidth than FDM
less complicated in hardware than FDM
better SNR
required filter

⇒ For class B operation the theoretical maximum efficiency is
1
0.785
0.5
0.275

⇒ For decimal numbe'r 13.5, the floating point representation in 4 byte excess 128 code is
01101100 00000000 00000000 10000100
00000000 01101100 00000000 10000100
00000000 01101100 10000100 00000000
01101100 00000000 10000100 00000000

⇒ Class A and class B chopper
operate in first quadrant
operate in second quadrant
class A chopper operates in first quadrant while class B operates in second quadrant
may operate in either first or second quadrant

⇒ The full form of the abbreviations TTL and CMOS in reference to logic families are
Triple Transistor Logic and Chip Metal Oxide Semiconductor
Tristate Transistor Logic and Chip Metal Oxide Semiconductor
Transistor Transistor logic and Complementary Metal Oxide Semiconductor
Trisate Transistor Logic and Complementary Metal Oxide Silicon

⇒ In Weston synchronoscope the fixed coils are connected across
bus bars
incoming alternator
lamp
either (a) or (b)

⇒

Assertion (A): The output voltage of an inverter can be controlled by PWM technique

Reason (R): In a current source inverter the input current is constant.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The materials which become polarized on the application of mechanical stress are called piezoelectric.
TRUE
FALSE

⇒ Consider the following statements as regards DPSK and DEPSK

DPSK demodulator requires a device which operates at carrier frequency and provides a delay of bit time T_b
In DPSK, synchronous demodulation recovers the signal b(t) and the decoding of b(t) to generate d(t) is done at base band
In both DPSK and DEPSK errors always occur in pairs

Which of the above statements are correct?
1 and 3
1 and 2
2 and 3
1, 2 and 3

⇒ A microprocessor is generally
single chip SSI
single chip MSI
single chip LSI
any of the above

⇒ Consider the following statements:

The positiveness of coefficients of characteristic equation is necessary as well as sufficient condition for stability of first and second order systems.
The positiveness of coefficients of characteristic equation ensures negativeness of real roots but is not sufficient condition for stability of third and higher order systems.

Out of above statements:
only 1 is correct
both 1 and 2 are correct
only 2 is correct
both are wrong

⇒ 25 persons are in a room. 15 of them play hockey, 17 of them play football and 10 of them play both hockey and football. Then the number of persons playing neither hockey nor football is:
2
17
13
3

⇒ Conversion rate, for a successive approximation ADC which uses 2 MHz clock and 5 bit binary ladder containing 8 VV reference voltage is __________ .
64516.12 conversions/sec
400000 conversions/sec
400000 bps
2.5 bps

⇒ Calculate the directivity of an antenna for θ_E = 30°, θ_H = 60
46
23
50
100

⇒ An AM signal and a narrowband FM signal with identical carriers, modulating signals and modulation index of 0.1 are added together. The resultant signal can be closely approximated by
Broadband FM
SSB with carrier
DSB-SC
SSB without carrier

⇒ Of the four INSAT-I satellites planned by India so for, only __________ has proved to be successful.
INSAT-IA
INSAT-IB
INSAT-IC
INSAT-ID