Question is ⇒ For an RC impedance function, Options are ⇒ (A) all poles lie on <i>j</i>ω axis, (B) all poles are simple ,, (C) all poles are simple and lie on negative real axis, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ For an RC impedance function, Options are ⇒ (A) all poles lie on <i>j</i>ω axis, (B) all poles are simple ,, (C) all poles are simple and lie on negative real axis, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an RC impedance function
A.	all poles lie on jω axis [Wrong Answer]
B.	all poles are simple , [Wrong Answer]
C.	all poles are simple and lie on negative real axis [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Thermal runaway is not possible in FET, because as the temperature of FET increases.
the mobility decreases
the transconductance increases
impedance of the source
power dissipation in the chip

⇒ Addition of 0.3 to 3.5% silicon to iron
increases the electrical resistivity of iron
decreases the electrical resistivity of iron
does not change electrical resistivity of iron
silicon can't be added with iron

⇒ T.V. antennas are usually
Yagi-Uda
loops
helical
parabolic

⇒ Fourier transform of an external exponential e^jW0t
δ(f - f₀)
1
δ(f + f₀)
∞

⇒ A current wave is i = 100e^-60t The initial and final values of current are
100 and 50
100 and 0
0 and 100
100 and 100

⇒ The generic microprocessor contains a zero and a carry flag. These are located on
interrupt control
status register
either (a) or (b)
none of the above

⇒ A full wave diode rectifier using centre tapped transformer has diodes with forward resistance of 50 ohms each. The load resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulation is
0.2
0.5
1
2

⇒ Which of the following configuration has low thermal stability?
CB
CC
CE
All have identical thermal stability

⇒ The main application of enhancement mode MOSFET is in
amplifier circuits
oscillator circuits
switching circuits
all of the above

⇒ If there are no permanent dipoles in a dielectric material, the dielectric constant is independent of temperature.
TRUE
FALSE

⇒ Number of fundamental cut-sets of any graph will be
same as the number of twigs
same as the number of tree branches
same as the number of nodes
equal to one

⇒ At room temperature kT = 0.03 eV.
TRUE
FALSE

⇒ Consider the following operation in respect of Wheatstone bridge (K_b, denotes battery key, K_g denotes galvanometer key)

open K_b
close K_g
close K_b
open K_g

The correct sequence of operations is
1, 2, 3, 4
3, 1, 2, 4
4, 3, 2, 1
3, 2, 4, 1

⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases

⇒ Thu advantage of using a dual stop ADC in a digital voltmeter is that
its conversion time is small
its accuracy high
output is in BCD format
it does not require a comparator

⇒ In FM 'guard band' is provided
to limit upper frequency limit
to limit lower frequency limit
so that there is less adjacent channel interference
to limit transmitted power of a station

⇒ Which of the following is not a legal subscript?
J + 2
JA - 4
-3
3^* IA - 2

⇒ For matrix A, A^-1 A = 1
TRUE
FALSE

⇒ In a 3 phase full converter feeding a highly inductive load, the average load current is 150 A. The peak current through thyristor is
150 A
75 A
50 A
300 A

⇒ The V_TH at terminals A and B is equal
0 V
5 V
- 5 V
None of these

⇒ The maximum percent overshoot with maximum value of first overshoot as 3.5 V and steady state value as 2.575 V is
0.3592
0.2643
0.5761
0.1524

⇒ In figure the phase
will be 90° at ω = 0 and 0° at ω = ∞
will be 0° at ω = 0 and 90° at ω = ∞
will be 45° at ω = 0 and 0° at ω = ∞
will be 45° at ω = 0 and 90° at ω = ∞

⇒ A uniform plane wave in the free space is normally incident on an infinitely thick dielectric slab (dielectric constant ε_r = 9). The magnitude of the reflection coefficient is
0
0.3
0.5
0.8

⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz?
0.6698
0.7698
0.503
0.6598

⇒ The electric field of an EM wave propagating in the z direction given
linearly polarized in z direction
elliptically polarized
left hand circularly polarized
right hand circularly polarized

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected.Ignoring shadows, the port addresses
80 H
85 H
82 H, 83 H
80 H to 85 H

⇒ In 8085
RST 6.5 and RST 5.5 are high level sensitive interrupts
RST 6.5 and RST 5.5 are low level sensitive interrupts
RST 5.5 is low level sensitive interrupt but RST 5.5 is high level-sensitive interrupt
RST 5.5 is low level sensitive interrupt but RST 6.5 is high level sensitive interrupt

⇒

Assertion (A): If power gain doubles the power gain increases by 3 dB

Reason (R): The bel power gain of cascaded stages is equal to sum of each bel power gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The device having highest photo sensitivity is
photoconductive cell
photovoltaic cell
photodiode
phototransistor

⇒ For the design of a sequential circuit having 9 states, minimum number of memory elements required is
3
4
5
9