Question is ⇒ For an RC admittance function Y,, Options are ⇒ (A) Y(∞) < Y(0), (B) Y(0) < Y(∞), (C) Y (∞) may be lesser or greater than Y(0), (D) Y(∞) = Y(0), (E) , Leave your comments or Download question paper.

Question is ⇒ For an RC admittance function Y,, Options are ⇒ (A) Y(∞) < Y(0), (B) Y(0) < Y(∞), (C) Y (∞) may be lesser or greater than Y(0), (D) Y(∞) = Y(0), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an RC admittance function Y,
A.	Y(∞) < Y(0) [Wrong Answer]
B.	Y(0) < Y(∞) [Correct Answer]
C.	Y (∞) may be lesser or greater than Y(0) [Wrong Answer]
D.	Y(∞) = Y(0) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In frequency modulation noise can be further reduced by
increasing deviation
reducing deviation
reducing carrier frequency
increasing signal amplitude

⇒ Which one most appropriate dynamic system?
y(n) + y(n - 1) + y(n + 1)
y(n) + y(n - 1)
y(n) = x(n)
y(n) + y(n - 1) + y(n + 3) = 0

⇒ A continuous time LTI system is describe
(e^t - e^3t) u(t)
(e^-t - 3e^-3t) u(t)
(e^-t + e^-3t) u(t)
(e^t + e^3t) u(t)

⇒ The collector voltage V_C of the circuit shown in the given figure aside is approxima
2 V
4.6 V
8 V
8.6 V

⇒ In the circuit of figure, v₁ = v₂ = 10 V.
I₁ = I₂
I₁ > I₂
I₂ > I₁
I₁ = 0

⇒ In a receiver, which of the following device has RF input but IF output?
Loudspeaker
Frequency changer
Demodulator
Audio amplifier

⇒ Self impedance is
same for transmitting (T_t) and receiving antenna (T_r)
T_t > T_r
T_r > T_t
no relation

⇒ The source of which of the following noise is different from that of the remaining?
Solar noise
Cosmic noise
Galactic noise
Atmospheric noise

⇒ The instruction MVI A, 20 in 8085 means
contents of memory location 20 are brought into the accumulator
the value 20 is brought into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ In a two phase servomotor the two stator windings have a phase difference of
30°
45°
90°
135°

⇒ For addition and subtraction operations, phasors
must be represented in polar form
must be represented in rectangular form
may be represented in any form
none of the above

⇒ Almost all high level languages have provision for logical operations.
TRUE
FALSE

⇒

Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.

Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The maximum positive and negative numbers which can be represented in 2's complement form using n bits are respectively
+(2^{n + 1} - 1), - (2^{n - 1} - 1)
+(2^{n + 1} - 1), - 2^{n - 1}
+2^{n - 1}, - 2^{n - 1}
+2^{n + 1}, - (2^{n - 1} + 1)

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒ The message carrying efficiency is best in
AM
FM
AM-SC
Phase modulation

⇒ Low-orbit satellites are not used for communications because they
produce sonic booms
do not provide 24 hour/ day contact to the users on Earth
heat up and melt
none

⇒ The circuit given below
counter
digital to analog converter
two-bit series-to-parallel converter
analog-to digital converter

⇒ The heat sink disposes off heat mainly by
radiation
natural convection
forced convection
conduction

⇒ The Ebers-moll equation for I_E in CB configuration is given by
I_E = a_nI_CI_EC0
I_E = a_II_C + I_C0
I_E = a_nI_C + I_C0(e^qVEB/KT-1)
I_E = a_II_C + I_E0(e^qV_EB/KT - 1)

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒ In a composite filter terminating half sections are used for impedance matching.
TRUE
FALSE

⇒

Assertion (A): The carry look ahead adder is very fast

Reason (R): The carry look ahead adder generates the carry and sum digits directly.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ How many distinct binary trees can be constructed with three nodes?
1
2
3
5

⇒ An antenna operates effectively when its dimensions are
of the order of magnitude of wavelength to be transmitted
very small than the magnitude of wavelength to be transmitted
very large than the magnitude of wavelength to be transmitted
either (a) or (b)

⇒

Assertion (A): Master slave JK flip flop is commonly used in high speed synchronous circuitry

Reason (R): Master slave JK flip flop uses two JK flip flops in cascade.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A current source inverter has simple commutation circuit.
TRUE
FALSE

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Special feature)
A.	Vidicon	1.	Highest sensitivity
B.	Plumbicon	2.	Temperature sensitive
C.	Saticon	3.	Large lag
D.	New vicon	4.	Special target for red response

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-1, D-2

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ Which of the following is a self-complementing code?
8421 code
Excess 3 codes
Pure binary code
Gray code