Question is ⇒ For an RC admittance function, Options are ⇒ (A) all poles and zeros are simple, (B) all poles and zeros are simple and lie on negative real axis, (C) all poles and zeros lie on imaginary axis, (D) all poles and zeros lie on positive real axis, (E) , Leave your comments or Download question paper.

Question is ⇒ For an RC admittance function, Options are ⇒ (A) all poles and zeros are simple, (B) all poles and zeros are simple and lie on negative real axis, (C) all poles and zeros lie on imaginary axis, (D) all poles and zeros lie on positive real axis, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an RC admittance function
A.	all poles and zeros are simple [Wrong Answer]
B.	all poles and zeros are simple and lie on negative real axis [Correct Answer]
C.	all poles and zeros lie on imaginary axis [Wrong Answer]
D.	all poles and zeros lie on positive real axis [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The switch in the circuit shown was on position a for a long time, and is moved to position b at time t = 0. The current i(t) for t > 0 is give
0.2e^-125tu(t) mA
20e^-1250tu(t) mA
0.2e^-1250tu(t) mA
20e^-1000tu(t) mA

⇒ In the below figure the average load current is 15 A. The rms value of transformer secondary current
15 A
10.61 A
7.5 A
14.14 A

⇒ Which of the following 8 bit microprocessors has maximum addressing modes?
8085
Z 80
6800
6809

⇒ The range of value "a" for which system will be stable. If impulse response of DT system is = aⁿ ∪[n]
a > 1
a < 1
1 < a < ∞
-1 < a < 1

⇒ In a crystal
the frequencies of series and parallel resonance are equal
the frequency of series resonance is more than frequency of parallel resonance
the frequency of parallel resonance is more than frequency of series resonance
None of the above

⇒ If A = 3 + j1 and B = 4 + j3, A - B =
8.062 ∠29.7°
10 ∠45°
2.236 ∠243.43°
6.72 ∠243.43°

⇒ The difference between measured value and true value is called
gross error
relative error
probable error
absolute error

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ In a low level AM system, the modulated amplifiers stage must be
harmonic devices
non-linear devices
class C amplifier
linear devices

⇒ A pole zero plot of a filter is shown in figure. I
low pass filter
high pass filter
band pass filter
all pass filter

⇒ For the time domain response shown in figure the
lies on negative real axis
lies on positive real axis
lies on imaginary axis
is complex or imaginary

⇒ Which of the following real expressions is correct in Pascal?
- Z + P * X
(X + Y) (A + B)
Z ** M
Z P * M

⇒ Colour picture tube needs higher anode voltage and needs larger beam and cathode currents than monochrome tube because
it is bigger in size
it has higher level of illumination
the tube has to illuminate three phosphors simultaneously
the tube has lower efficiency because of aperture mask

⇒ A transmission line having 50 Ω impedance is terminated in a load of (40 + j 30) Ω. The VSWR is
j 0.033
0.8.+ j 0.6
1
2

⇒ The directive gain of a transmitting antenna is proportional to
its cross-sectional area
square of cross-sectional area
square root of cross-sectional area
cube root of cross-sectional area

⇒ Which of the following is used as switch?
J-K flip-flop
Master slave J-K flip-flop
T-flip-flop
D-flip-flop

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.
TRUE
FALSE

⇒ A microcomputer has memory locations from 0000 to FFFF, each storing 1 byte. How many bytes can be the memory store?
12333
14666
16384
16655

⇒ Which of the following is correct?
y₂₂ = z₂₂/|z|
y₁₁ = z₂₂/|z|
z₁₁ = y₁₁/|y|
z₂₂ = y₂₂/|y|

⇒ Consider the following expressions in J
42, 40, 42 respectively
42, 42, 42 respectively
40, 42, 42 respectively
40, 40, 42 respectively

⇒

Assertion (A): Linear ICs include audio amplifier, wideband amplifier, RF amplifier and IF amplifier

Reason (R): The error voltage in a feedback circuit is very small

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In all pure metals, temperature coefficient of resistance is positive.
TRUE
FALSE

⇒ The multiplier resistance and meter coil in a voltmeter are in
series
parallel
series-parallel
either (a) or (b)

⇒ The advantage of LVDT over inductive bridge type transducer is that
it gives high output for small changes in core position
it can be used over a temperature range of - 265°C to 600°C
it can measure displacement of moving object
the error due to stray magnetic field is less

⇒ In intrinsic semiconductor the increase in conductivity per degree increase in temperature is about
0.02
0.06
0.15
0.25

⇒ A Maxwell's bridge has the unknown inductance in one arm and resistance in the other three arms.
TRUE
FALSE

⇒ An electron when placed midway between two equal and opposite charges will
remain stationary
oscillate between the charges
be thrown out of the field
spin in the field

⇒ If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be
a voltage source
a current source
both of the above
none of the above

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒ Which of the following impedance inversion is obtained?
Short-circuited stub
A quarter wave line
Balun transformer
A half wave line