Question is ⇒ For an npn transistor connected as shown in the figure VBE = 0.7 volts. Given that reverse saturation current of the junction at room temperature 300K is 10-13A, the emitter curr, Options are ⇒ (A) 30 mA, (B) 39 mA, (C) 49 mA, (D) 20 mA, (E) , Leave your comments or Download question paper.

Question is ⇒ For an npn transistor connected as shown in the figure VBE = 0.7 volts. Given that reverse saturation current of the junction at room temperature 300K is 10-13A, the emitter curr, Options are ⇒ (A) 30 mA, (B) 39 mA, (C) 49 mA, (D) 20 mA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an npn transistor connected as shown in the figure V_BE = 0.7 volts. Given that reverse saturation current of the junction at room temperature 300K is 10^-13A, the emitter curr
A.	30 mA [Wrong Answer]
B.	39 mA [Wrong Answer]
C.	49 mA [Correct Answer]
D.	20 mA [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The fuse material used in electrical lines must have which one of the following properties?
High resistivity
Low conductivity
High melting point
Low melting point

⇒ Which of the following is also called handshaking programmed data transfer?
Synchronous transfer
Asynchronous transfer
Interrupt driver transfer
Both (a) and (c)

⇒ h parameters are used in transistor analysis.
TRUE
FALSE

⇒ To protect an SCR against high di/dt we connect
a capacitance in series with SCR
a capacitance in parallel with SCR
an inductance in parallel with SCR
an inductance in series with SCR

⇒ Which one of the following is a transferred electron device?
BARITT diode
IMPATT diode
TRAPATT diode
Gunn diode

⇒ The response shown in figur
over damped
critically damped
under damped
either (a) or (c)

⇒ The binary number 101100.110 in octal number will be
152.6
154.6
145.6
174.6

⇒ The waveform shown in the given Figure can be written
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) - u(t - 5)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) - 4u(t - 5)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) + 4u(t - 5)

⇒ A cable has an insulation resistance of 10¹⁰ ohms. If the length is doubled, the insulation resistance will be
2 x 10¹⁰ Ω
0.5 x 10¹⁰ Ω
10¹⁰ Ω
4 x 10¹⁰ Ω

⇒ The gain margin for a stable system
has a positive decibel value
has a negative decibel value
has a large negative decibel value
none of the above

⇒ The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to
any where
a dc ground potential
the most positive potential available in the circuit
the most negative potential available in the circuit

⇒ In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be
at the centre of ac load line
at the centre of dc load line
at the centre of collector voltage
at the centre of collector current

⇒ Both OR and AND gates can have only two inputs.
TRUE
FALSE

⇒ Operating point signifies that
zero signal I_C and V_BE
zero signal I_C and V_CE
zero signal I_B and V_CE
zero signal I_C, V_CE

⇒ The loops ' for , 'while' , 'do-while' are used in
Fortran 77
Pascal
C
none of the above

⇒ In figure the input and output Miller capacitances
0.25 μF each
500 pF each
0.25 μF and 500 pF respectively
500 pF and 0.25 μF respectively

⇒ What are the counting stages (Q₁, Q₂) for the counter shown in the figure be
11, 10, 00, 11, 10, ...
01, 10, 11, 00, 10, ...
00, 11, 01, 10, 00, ...
01, 10, 00, 01, 10, ...

⇒ 11011 in gray code = __________ .
10010₂
11111₂
11100₂
10001₂

⇒ Input and output impedance with feedback for voltage series feedback having A = -200, R₁ = 10 kΩ, R₀ = 50 kΩ and feedback factor β = -0.2 will be
410 kΩ, 2050 kΩ
410 kΩ, 1.219 kΩ
≈ 0.243 kΩ, 2050 kΩ
≈ 0.24 kΩ, 1.219 kΩ

⇒ A rectangular waveguide has a discontinuity in the form of reduced narrow dimension. In the equivalent circuit this discontinuity can be represented by
a shunt capacitance at the discontinuity
a shunt inductance at the discontinuity
a shunt resistance at the discontinuity
none of the above

⇒ Read the following statements

Magnetic tape is a sequential device.
Magnetic disc is a direct access device.
Magnetic tape and disc are both sequential devices.
Magnetic tape and disc are both direct access devices.

Which of the above statements are correct?
1 and 2 only
1 and 3 only
2 and 4 only
1, 2 and 3 only

⇒ The log magnitude plot of the given figure is
type 0 system
type 1 system
type 2 system
either type 0 or type 1 system

⇒ A single phase semiconverter is feeding a highly inductive load and has a freewheeling diode across the load. The waveshape of input current is
sinusoidal
rectangular
sinusoidal or rectangular
triangular

⇒ The resolution of a wire wound potentiometer is about
0.00001
0.001
0.01
0.05

⇒ If the network in figure (1), (2) are equivalent at terminals A - B, then voltage V and resistance R
100V and 12 Ω
60V and 12 Ω
100V and 30 Ω
60V and 30 Ω

⇒ If sound intensity is 8 W/m², the dB level of this sound is about
5 dB
50 dB
129 dB
1290 dB

⇒ For real and odd signals, the Fourier series coefficient a_k is __________ .
purely imaginary and even
purely real and even
purely imaginary and odd
purely real and odd

⇒ For an ideal noise free transistor amplifier the noise factor is
zero
zero dB
1 dB
depends on other factors

⇒ As the frequency increases, the absorption of ground wave by earth's surface
decreases
increases
remains the same
either (a) or (c)

⇒ A periodic rectangular signal, x(t) has the waveform shown in the given figure. Frequency of the fifth harmonic of its spectrum is _______
200 Hz
250 Hz
400 Hz
1250 Hz