Question is ⇒ For an I/p of Vs = 5 sin ωt (assuming ideal diode), circuit shown in the figure will behave, Options are ⇒ (A) clipper, sine wave clipped at -2 V, (B) clamper, sine wave clamped at -2 V, (C) clamper, sine wave clamped at 0 volts, (D) clipper, sine wave clipped at 2 V, (E) , Leave your comments or Download question paper.

Question is ⇒ For an I/p of Vs = 5 sin ωt (assuming ideal diode), circuit shown in the figure will behave, Options are ⇒ (A) clipper, sine wave clipped at -2 V, (B) clamper, sine wave clamped at -2 V, (C) clamper, sine wave clamped at 0 volts, (D) clipper, sine wave clipped at 2 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an I/p of V_s = 5 sin ωt (assuming ideal diode), circuit shown in the figure will behave
A.	clipper, sine wave clipped at -2 V [Wrong Answer]
B.	clamper, sine wave clamped at -2 V [Wrong Answer]
C.	clamper, sine wave clamped at 0 volts [Wrong Answer]
D.	clipper, sine wave clipped at 2 V [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A reflex klystron oscillator is a
low power device
high power device
high efficiency device
both (a) and (b)

⇒ The oscillator frequency is set for
best picture
max. sound
min. sound
sound in picture

⇒ Which of the following instructions in 8085 does not belong to data transfer group?
L X I rp, data 16
MOV M, r
MVIM, data
ADC M

⇒ Macroscopic quantities of a given material
are absolutely constant
are a function of temperature
are a function of temperature, pressure field
none of the above

⇒ For a NPN bipolar transistor, what is the main stream of current in the base region?
Drift of holes
Diffusion of holes
Drift of electrons
Diffusion of electrons

⇒ A UPS contains
rectifier
inverter
either rectifier or inverter
both rectifier and inverter

⇒ In a bipolar transistor which current is smallest
collector current
base current
emitter current
any of the three currents

⇒ The dual of A + [B + (AC)] + D is
A + [(B (A + C))] + D
A [B + AC] D
A + [B (A + C)] D
A [B (A + C)] D

⇒ In commercial FM Broadcasting, A radio station transmitting the signal at 98.3 MHz, it is
carrier frequency
modulation frequency
message frequency
channel frequency

⇒ A dc circuit breaker must use
natural commutation
forced commutation
both natural and forced commutation
either natural or forced commutation

⇒ The class of insulation of impregnated paper is
A
B
C
F

⇒ The expression H_Z = C cos(Bx) cos(Ay)yz is for
TE wave
TM waves
both TE and TM waves
some TE and some TM waves

⇒ Which of the following could be the equation for non-linear resistor shown in figu
a + be + ce² + de³
a - be - ce² - de³
a + be + ce² - de³
a + be - ce² - de³

⇒ In the graphical analysis of CE amplifier circuit, the intersection of base current and dc load line is called
saturation point
cut off point
Q point
operating point

⇒ A 120 V, 30 Hz source feeds a half wave rectifier circuit through a 4 : 1 step down transformer, the average output voltage is
30 V
13.5 V
10 V
7.07 V

⇒ For the transport lag G(jω) = e^-jωT, the phase angle
is constant
varies linearly with frequency
varies linearly with low frequencies only
values as per square law

⇒

Match the following:

	List I		List II
A.	On-off	1.	steam kettle with different settings
B.	Proportional	2.	Elevator
C.	Cascade	3.	Robot-positioning
D.	Digital	4.	Domestic Refrigerator

A-4, B-2, C-3, D-1
A-2, B-4, C-1, D-3
A-3, B-1, C-4, D-2
A-4, B-2, C-1, D-3

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ If number of information bits is 4, the parity bits in Hamming code are located at bit positions __________ from the LSB.
1, 2, 5
1, 2, 4
1, 2, 3
1, 2

⇒ In the given circuit, V₁ = 40 V when R is 10 Ω. When R is zero, the value of V₂ wil
40 V
30 V
20 V
10 V

⇒ The effective height of an antenna is slightly greater than physical height because
wave velocity in conductor is less than its velocity in free space
wave velocity in conductor is more than its velocity in free space
resistance of conductor is less than that of free space
none of the above

⇒ Tracking of extra terrestrial objects requires
high transmitting power
very sensitive receiver
fully steerable antenna
all of the above

⇒ Power received from Sun per m² surface area of a geosynchronous satellite in nearly __________ watt.
100
500
2000
1000

⇒ Consider an arbitrary distribution of conducting bodies in a charge free space according to the uniqueness theorem, which of following are required to be specified in order that the field is uniquely determined everywhere?

Total charge on each conductor
Potential at each conductor surface
Potential at same of conductor and total charge on the remainder
Total charge as well as potential gradient on each conductor surface

Select the correct answer using the codes given below codes
1 and 3
2 and 4
1, 2, and 3
1, 2, 3, 4

⇒ In a strain measuring device using a strain gauge, the output quantity is
voltage
resistance
impedance
either (a) or (b)

⇒ The range of a cordless telephone is about
1000 m
500 m
100 m
10 m

⇒ The analog signal given below is sampled at 1200 samples per second. m(t) = 2 sin 120 pt + 3 sin 240 pt + 4 sin 360 pt + 5 sin 480 pt + 6 sin 600 pt + 7 sin 720 pt. The folding (maximum) frequency is __________ .
300 Hz
360 Hz
600 Hz
480 Hz

⇒ The temperature coefficient of a thermistor
is positive
is negative
zero
may be positive or negative depending on its composition

⇒ A material has conductivity of 10⁵ mho/m and permeability of 4p x 10^-7 H/m. The skin depth at 9 GHz is
1.678 μm
26 μm
17 μm
32.32 μm

⇒ If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is
200 V
141.4 V
100 V
86 V