Question is ⇒ For an ac sinusoidal wave, the rms value is 10 A. For the same wave delayed by 60° in each half cycle, the rms value is likely to be, Options are ⇒ (A) 0.416666666666667, (B) 7.07 A, (C) 6.35 A, (D) 3.5 A, (E) , Leave your comments or Download question paper.

Question is ⇒ For an ac sinusoidal wave, the rms value is 10 A. For the same wave delayed by 60° in each half cycle, the rms value is likely to be, Options are ⇒ (A) 0.416666666666667, (B) 7.07 A, (C) 6.35 A, (D) 3.5 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an ac sinusoidal wave, the rms value is 10 A. For the same wave delayed by 60° in each half cycle, the rms value is likely to be
A.	0.416666666666667 [Correct Answer]
B.	7.07 A [Wrong Answer]
C.	6.35 A [Wrong Answer]
D.	3.5 A [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Intrinsic or characteristic impedance of free space has a value of
120 ohm
73 ohm
73 ε ohm
120 ε ohm

⇒ An ac network has a power factor of 0.8 lagging for fundamental frequency. If the applied voltage contains thrid and fifth harmonics, the overall power factor will be
more than 0.8 lagging
0.8 lagging
less than 0.8 lagging
0.8 lagging or less

⇒ In a 3 phase semiconverter, the freewheeling diode comes into operation only if firing angle
is zero
is 60°
is more than 60°
is more than 90°

⇒ The time base of a high frequency CRO whose screen diameter is 10 cm is set at 10 μ sec/cm. The lowest frequency which can be fully displayed on the screen is
more than 100 kHz
equal to 100 kHz
equal to 10 kHz
less than 10 kHz

⇒ Which of the following statements is incorrect?
A mesh with two resistors has two mesh currents
The algebraic sum of all voltages around any mesh or any loop must be zero
The principle node is a function where branch current can divide or combine
A Norton is a series circuit

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ If the output current wave shape of class C circuit has a period of 1 μs and a pulse width of 0.006 μs, the duty cycle is
0.06
0.006
0.00006
0.0006

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ The O/P char, of a FET is given in the figure. In which region is the device biased for small signal amplificat
AB
BC
CD
BD

⇒ In a bipolar junction transistor the base region is made very thin so that
recombination in base region is minimum
electric field gradient in base is high
base can be easily fabricated
base can be easily biased

⇒ A T network is inserted between source and R as shown in figure. The resistance seen by the source remains the same with or without T network when
5 Ω
10 Ω
15 Ω
20 Ω

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ The mean life time of carrier may range from 10^-9 seconds to hundreds of μ-seconds.
TRUE
FALSE

⇒ V_L = 100 cos (10t + 30&d
116.57 sin (10t - 29°) V
116.57 sin (10t + 29°) V
117.00 sin (10t - 29°) V
117.00 sin (10t + 29°) V

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V

⇒ Space wave may be a direct wave or wave reflected from earth.
TRUE
FALSE

⇒ When all the seven segments of a display are energized, the number shown is
0
1
7
8

⇒ The circuit realizes the func
(A + B) E + CD
(A + B) (E + CD)
(A + B) (E + C + D)
(AB + E). CD

⇒ To avoid creep in an energy meter
two shading bands are put on shunt magnet
two shading bands are put on series magnet
two holes are cut in the disc on opposite sides of spindle
the potential coil is made of very thin wire

⇒ RC oscillator can be used upto
1 kHz
10 kHz
50 kHz
100 kHz

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The voltage multiplication is
25
50
125
250

⇒ The signal flow graph of a system is shown in the given figure. The effect of disturbance T_D can be reduce
increasing G₂ (s)
decreasing G₂ (s)
increasing G₁ (s)
decreasing G₁ (s)

⇒ Which of these is also called 'hot carrier diode'?
PIN diode
LED
Photo diode
Schottky diode

⇒

Assertion (A): Power transistors are more commonly of silicon npn type.

Reason (R): The fabrication of silicon npn transistors is easy.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Ohmic range of carbon composition resistors is
10 to 100 ohms
10 to 10 K ohms
10 to 200 ohms
10 to 25 M ohms

⇒ Consider the following:

Oscillator
Emitter follower
Cascaded amplifier
Power amplifier

Where of these use feedback amplifiers?
1 and 2
1 and 3
2 and 4
3 and 4

⇒ Fourier transform F(jω) of an arbitrary signal has the property
F(jω) = F(- jω)
F(jω) = - F(- jω)
F(jω) = F*(- jω)
F(jω) = - F*(jω)

⇒ VLF is generally used for
telegraphy
satellite communication
instrument landing system
all of the above

⇒ In a full wave voltage doubler circuit, the input frequency is 560 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
200 Hz

⇒ Which of the following could be the equation for non-linear resistor shown in figu
a + be + ce² + de³
a - be - ce² - de³
a + be + ce² - de³
a + be - ce² - de³