Question is ⇒ For AB + A C + BC = AB + A C the dual form is, Options are ⇒ (A) (A + B) (A + C)(B + C) = (A + B)(A + C), (B) (A + B ) (A + C)(B + C) = (A + B)(A + C), (C) (A + B) (A + C) (B + C) = (A + B) (A + C), (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ For AB + A C + BC = AB + A C the dual form is, Options are ⇒ (A) (A + B) (A + C)(B + C) = (A + B)(A + C), (B) (A + B ) (A + C)(B + C) = (A + B)(A + C), (C) (A + B) (A + C) (B + C) = (A + B) (A + C), (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For AB + A C + BC = AB + A C the dual form is
A.	(A + B) (A + C)(B + C) = (A + B)(A + C) [Correct Answer]
B.	(A + B ) (A + C)(B + C) = (A + B)(A + C) [Wrong Answer]
C.	(A + B) (A + C) (B + C) = (A + B) (A + C) [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure represen
Tunnel diode
PNP transistor
Photo sensitive diode
Photo emissive diode

⇒ A single phase semiconverter has a freewheeling diode. If the firing angle is a and the load is purely resistive, the periods of conduction and freewheeling respectively are
p - a and 0
p - a and a
p + a and 0
p + a and a

⇒ The V_o of the op-amp circuit shown in the give
11 V_i
10 V_i
V_i
zero

⇒ The circuit shown I/P in the figure repres
Low pass filter
High pass filter
Band Pass filter
Band stop filter

⇒ An FM signal has modulating frequency f_m and maximum frequency deviation of δ. The bandwidth will be nearly equal to
δ
2 δ
2f_m δ
f_m δ

⇒

Assertion (A): A higher level language is less efficient that machine language but more efficient than assembly language.

Reason (R): It is easier to learn and use higher level language than machine language.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Holes and electrons move in opposite directions.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	True type	1.	Type of calculator in window
B.	FIND	2.	Window command
C.	WORD PAD	3.	Name of a Font
D.	STANDARD	4.	Has many features of a simple word processor

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-3, B-2, C-4, D-1

⇒ Q of a coil

increases with Q increasing frequency
varies linearly with frequency
increase with increasing frequency because R increases at high frequency
decrease after the peak frequency because R increases at H.F. the correct statements are

A, B
C, D
A, C
B, D

⇒ In a CE amplifier the Q point is very close to cutoff point on the load line. This results in
saturation clipping
cut off clipping
both saturation and cut off clipping
either saturation clipping or cut off clipping

⇒ Hall effect can be used to find the type of semiconductor.
TRUE
FALSE

⇒

Assertion (A): A good algorithm should be fast, require minimal computer memory and time.

Reason (R): Many times an algorithm is prepared in the form of a flow chart.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A speech signal, band limited to 4kHz and peak voltage varying between + 5V and - 5V is sampled at the Nyquist rate. Each sample is quantized and represented by 8 bits. Assuming the signal to be uniformly distributed between its peak values, the signal to noise ratio at the quantizer output is
156 dB
32 dB
48 dB
64 dB

⇒ A moving coil meter has a resistance of 50 ohms and a full scale deflection current of 20 mA. To convert it into a voltmeter of 0-100 V range, the series resistance should be
5000 Ω
5050 Ω
4950 Ω
505 Ω

⇒ Emitter follower is in which of following configuration.
common Base
common Emitter
common collector
common Base or common Emitter

⇒ The system of the given fi
is unstable for all values of K
is stable for all values of K
can be stable for some values of K
data is insufficient to determine stability

⇒ If the peak value of output of a half wave rectifier is 100 V, the rms value is
100 V
50 V
70.7 V
35.35 V

⇒ If memory chip size is 256 x 1 bits, the number of chips required to make 1 k byte memory is
8
12
24
32

⇒ For type 0 system the starting point (i.e. ω = 0) of polar plot is finite and is on positive real axis.
TRUE
FALSE

⇒ In 8085 microprocessor, how many I/O ports can be accessed by direct method?
8
256
32 K
64 K

⇒ In a lead acid cell the density of the acid gives an indication of
the level of the acid
the eventual damages caused to the plates
the charge of the battery
the e.m.f. of the battery

⇒ Which of the following devices has a silicon dioxide layer?
NPN transistor
Tunnel diode
JFET
MOSFET

⇒ In an oscillator crystal, the parallel resonant frequency is
equal to
higher than
less than
series resonant frequency

⇒ The operating modes of 8255 A are called
mode 0 and mode 1
mode 0, mode 1 and mode 2
mode 0 and mode 2
mode 0, mode 2 and mode 3

⇒ The electrochemical equivalent of a material
depends on its valency
depends on its atomic weight
depends on its valency and atomic weight
depends on the degree of hardness of the material

⇒ In the circuit of figure both diodes are ideal. If v₁ = 10 V and v₂ = 10 V which diode will cond
D₁ only
D₂ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ The noise figure of klystron amplifier is about
25 dB
3 dB
zero
1 dB

⇒ A photoconductor is a
conductor
semiconductor
insulator
superconductor

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒ A cycloconverter for single phase operation has
one positive group and one negative group converters
two positive group and two negative group converters
three positive group and three negative group converters
any of the above