Question is ⇒ For a wave propagating in air filled rectangular waveguide., Options are ⇒ (A) guide wavelength is never less than free space wavelength., (B) wave impedance is never less than the free space impedance, (C) TEM mode is possible if the dimension of the waveguide are properly chosen., (D) propagation constant is a real quantity., (E) , Leave your comments or Download question paper.

Question is ⇒ For a wave propagating in air filled rectangular waveguide., Options are ⇒ (A) guide wavelength is never less than free space wavelength., (B) wave impedance is never less than the free space impedance, (C) TEM mode is possible if the dimension of the waveguide are properly chosen., (D) propagation constant is a real quantity., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a wave propagating in air filled rectangular waveguide.
A.	guide wavelength is never less than free space wavelength. [Correct Answer]
B.	wave impedance is never less than the free space impedance [Wrong Answer]
C.	TEM mode is possible if the dimension of the waveguide are properly chosen. [Wrong Answer]
D.	propagation constant is a real quantity. [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The capacitance of a parallel plate capacitor varies as per the equation C(t) = C₀ (1 - cos ωt). It is connected to a battery of V volts. The equation for current is
ωC₀V (1 - cos ωt)
ωC₀V(1 - sin ωt)
ωC₀V (1 - sin 2ωt)
ωC₀V sin ωt

⇒ The gate electrode in the FET corresponds to the
collector in a bipolar transistor
base in a bipolar transistor
emitter in a bipolar transistor
none of the above

⇒ In floating point representation, mantissa is expressed in
excess 3 notation
gray code
excess 32 notation
2's complement

⇒ In the switching circuit, switches A, B have value 0 for OFF, 1 for ON and the output Y has 0 volts for 1 volts, then the expression for
AB
A + B
A + B
AB

⇒ The electromagnets of an induction wattmeter
are laminated
are not laminated
may be laminated
must not be laminated

⇒ It is required that a strain gauge has gauge factor of 100. The proper strain gauge is
constantan strain gauge
nichrome strain gauge
semiconductor strain gauge
alloy strain gauge

⇒ A silicon controlled switch has :
2 leads
3 leads
4 leads
5 leads

⇒ Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to
electron
doping
thermal energy
free electrons

⇒

Assertion (A): It is possible that a digital circuit gives the same output for different input voltages

Reason (R): A digital circuit is also called logic circuit.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The ASCII code is
5-bit code
7-bit code
9-bit code
11-bit code

⇒ Which of the following contributes to harmonics distortion in amplifiers?
Positive feedback
Presence of noise
Defective active device
Non-linearity in active device

⇒

Assertion (A): If source and destination addresses are made implicit the length of instruction is reduced.

Reason (R): 8085 has only 3 addressing modes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ To prevent overloading in the last IF amplifier one should use
variable sensitivity
squelch
double conversion
variable selectivity

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒ A typical value of g_m for a FET is about 25 μs.
TRUE
FALSE

⇒ In 8085, which of the following is an 8 bit register?
A
SP
PC
both (a) and (b)

⇒ A two branch parallel circuit has a 10 Ω resistance and 0.5 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply. At resonance, the source current is
0.416666666666667
0.0416666666666667
0.2 A
0.05 A

⇒ The distance between maxima and minima of a standing wave is
λ/4
λ/2
λ
2λ

⇒ A reverse voltage of 18 V is applied to a semiconductor diode. The voltage across the depletion layer is
0 V
0.7 V
about 10 V
18 V

⇒ Which of the following are useful in comparing the noise performance of receivers?

Input noise voltage
Noise figure
Noise resistance
Noise temperature

Select answer as per the following codes:
1, 2 and 3
1, 3 and 4
2, 3, 4
1, 2, 4

⇒ For class B operation the theoretical maximum efficiency is
1
0.785
0.5
0.275

⇒ Loss of charge method is suitable for medium resistances.
TRUE
FALSE

⇒ On the basis of the type of chemical bonds, solids may be classified into
ionic crystals
ionic and valence crystals
ionic crystal, valence crystals and metals
ionic crystals, valence crystals, metal and vander wall crystals

⇒ Which of the following is a self-complementing code?
8421 code
Excess 3 codes
Pure binary code
Gray code

⇒ A 4 bit binary adder has 4 full adders.
TRUE
FALSE

⇒ The resistivity of intrinsic semiconductors, at room temperature, is of the order of
1 Ω-m
1000 Ω-m
10⁶ Ω-m
10^-3 Ω-m

⇒ The antenna current of an AM broad cast transmitter, modulated to a depth of 40% by an audio sine wave is 11 amperes. It increased to 12 ampere as a result of simultaneous modulation by another sine wave. The modulation index due to this second sine wave is :
0.4
0.757
0.643
0.8

⇒ Switching systems
are limited to small data networks
require additional lines
are not used in data system
improve the efficiency of data transfer

⇒ The given characteristic polynomial s⁴ + s³ + 2s² + 2s + 3 = 0 has
zero root in RHS of s-plane
one root in RHS of s-plane
two roots in RHS of s-plane
three roots in RHS of s-plane

⇒ Bipolar IC memories are fabricated using
high density versions of the bipolar transistor flip-flop
low density versions of the unipolar transistor flip-flop
high density versions of the MOSFET
low density versions of the MOSFET