Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
For a voltage transfer function H(s), realizable by RLC network, the following statements are made
| |
A. | 3 and 4 are correct [Correct Answer] |
B. | 2 and 4 are correct [Wrong Answer] |
C. | 1 and 2 are correct [Wrong Answer] |
D. | 1 and 3 are correct [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4
⇒ N circles for a = a_{1}, and a = a_{1} ± 180° n (where n = 1, 2, 3, ....) are the same.
TRUE
FALSE
⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0
⇒ An ideal op-amp has zero slew rate.
TRUE
FALSE
⇒ The chip 8259 is a
programmable interrupt controller
programmable peripheral interface
I/O device
memory chip
⇒ A voltage v(t) which is a gaussian ergodic random process witha mean of zero and a varance of 4 volt^{2} is measured by a meter which first square and then reads its dc component. The reading will be
0
4
16
2
⇒ The point P in the following figure is stock at 1. The output f wil
ABC
A
AB C
A
⇒ If figure, power dissipated in 30Ω resistance will be maximum when value of
30 Ω
16 Ω
9 Ω
zero
⇒ A voltage multiplier circuit, using diodes and capacitors is suitable for
high voltage high current device
high voltage low current device
low voltage low current device
low voltage high current device
⇒ Earth's curvature affects the effective height of antenna.
TRUE
FALSE
⇒ Figure shows an RC potentiometer to measure ac voltage. It is desired that V_{0}/V_{i} should be independent of frequency. The value of C should
10 μF
11 μF
0.1 μF
0.09 μF
⇒ Which of the following microphones has an inbuilt amplifier?
Condenser
Moving coil
Ribbon
Carbon
⇒ Out of Metal-film type and Carbon-film type, the one with better tolerance specification is
carbon-film
metal-film type
both have same tolerance
none of these
⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
1 MΩ
100 kΩ
15 kΩ
≈ 0
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ A compensator has its pole and zero as shown in the given fi
lag compensator
lead compensator
lead-lag compensator
series compensator
⇒ At very low temperatures, semiconducting materials behave as insulators.
TRUE
FALSE
⇒ At t = 0^{+}, the current i_{1- V/2R- V/4R- V/Rzero}
⇒ A sample of N-type semiconductor has electron density of 6.25 x 10^{18}/cm^{3} at 300k. If the intrinsic concentration of carriers in this sample is 2.5 x 10^{13}/cm^{3} at this temperature the hole density works out to be
10^{6}/cm^{3}
10^{8}/cm^{3}
10^{10}/cm^{3}
10^{l2}/cm^{3}
⇒ Which of the following materials has the highest electrical conductivity?
Steel
Silver
Aluminium
Zinc
⇒ The given figure shows a control system. The maximum value of gain for which the system is stabl
3
3
4
5
⇒ A stationary process has
all statistical properties independent of time
all statistical properties dependent of time
zero variance
ensemble average equal to time average
⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above
⇒ M circles are symmetrical with respect to
real and imaginary axis
M = 1 straight line and real axis
M = 1 straight line and imaginary axis
M = 1 straight line
⇒ The feedback control system shown in figure is stable for what values of K and
K < 0, T > - 1
K > 0, T > 0
K > 0, T > - 1
K < 0, T > 0
⇒ Electrical contact materials used in switches, brushes, relay must possess
high thermal conductivity and high melting point
low thermal conductivity and low melting point
high thermal conductivity and low melting point
low thermal conductivity and high melting point
⇒ A microprocessor with a 16 bit address bus is used in a linear memory selection configuration. Address bus lines are directly uses as chip selects of memory chips with 4 memory chips the maximum addressable memory space is
64 k
16 k
8 k
4 k
⇒ If e = 10 sin(10^{8} t + 3 sin 10^{4} t) then modulating frequency is
159 Hz
1590 Hz
1.59 MHz
15.9 MHz
⇒ UHF range is
30 MHz to 300 MHz
300 MHz to 3000 MHz
3000 MHz to 30, 000 MHz
above 30, 000 MHz
⇒ M circles are symmetrical with respect to real axis.
TRUE
FALSE
⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4
⇒ N circles for a = a_{1}, and a = a_{1} ± 180° n (where n = 1, 2, 3, ....) are the same.
TRUE
FALSE
⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0
⇒ An ideal op-amp has zero slew rate.
TRUE
FALSE
⇒ The chip 8259 is a
programmable interrupt controller
programmable peripheral interface
I/O device
memory chip
⇒ A voltage v(t) which is a gaussian ergodic random process witha mean of zero and a varance of 4 volt^{2} is measured by a meter which first square and then reads its dc component. The reading will be
0
4
16
2
⇒ The point P in the following figure is stock at 1. The output f wil
ABC
A
AB C
A
⇒ If figure, power dissipated in 30Ω resistance will be maximum when value of
30 Ω
16 Ω
9 Ω
zero
⇒ A voltage multiplier circuit, using diodes and capacitors is suitable for
high voltage high current device
high voltage low current device
low voltage low current device
low voltage high current device
⇒ Earth's curvature affects the effective height of antenna.
TRUE
FALSE
⇒ Figure shows an RC potentiometer to measure ac voltage. It is desired that V_{0}/V_{i} should be independent of frequency. The value of C should
10 μF
11 μF
0.1 μF
0.09 μF
⇒ Which of the following microphones has an inbuilt amplifier?
Condenser
Moving coil
Ribbon
Carbon
⇒ Out of Metal-film type and Carbon-film type, the one with better tolerance specification is
carbon-film
metal-film type
both have same tolerance
none of these
⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
1 MΩ
100 kΩ
15 kΩ
≈ 0
⇒
Assertion (A): In standing wave pattern, the nodes and anti nodes are separated by half wave-length
Reason (R): When line is terminated in resistance R_{L}, the standing wave ratio is SWR = Z_{0}/R_{L} or R_{L}/Z_{0}
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ A compensator has its pole and zero as shown in the given fi
lag compensator
lead compensator
lead-lag compensator
series compensator
⇒ At very low temperatures, semiconducting materials behave as insulators.
TRUE
FALSE
⇒ At t = 0^{+}, the current i_{1- V/2R- V/4R- V/Rzero}
⇒ A sample of N-type semiconductor has electron density of 6.25 x 10^{18}/cm^{3} at 300k. If the intrinsic concentration of carriers in this sample is 2.5 x 10^{13}/cm^{3} at this temperature the hole density works out to be
10^{6}/cm^{3}
10^{8}/cm^{3}
10^{10}/cm^{3}
10^{l2}/cm^{3}
⇒ Which of the following materials has the highest electrical conductivity?
Steel
Silver
Aluminium
Zinc
⇒ The given figure shows a control system. The maximum value of gain for which the system is stabl
3
3
4
5
⇒ A stationary process has
all statistical properties independent of time
all statistical properties dependent of time
zero variance
ensemble average equal to time average
⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above
⇒ M circles are symmetrical with respect to
real and imaginary axis
M = 1 straight line and real axis
M = 1 straight line and imaginary axis
M = 1 straight line
⇒ The feedback control system shown in figure is stable for what values of K and
K < 0, T > - 1
K > 0, T > 0
K > 0, T > - 1
K < 0, T > 0
⇒ Electrical contact materials used in switches, brushes, relay must possess
high thermal conductivity and high melting point
low thermal conductivity and low melting point
high thermal conductivity and low melting point
low thermal conductivity and high melting point
⇒ A microprocessor with a 16 bit address bus is used in a linear memory selection configuration. Address bus lines are directly uses as chip selects of memory chips with 4 memory chips the maximum addressable memory space is
64 k
16 k
8 k
4 k
⇒ If e = 10 sin(10^{8} t + 3 sin 10^{4} t) then modulating frequency is
159 Hz
1590 Hz
1.59 MHz
15.9 MHz
⇒ UHF range is
30 MHz to 300 MHz
300 MHz to 3000 MHz
3000 MHz to 30, 000 MHz
above 30, 000 MHz
⇒ M circles are symmetrical with respect to real axis.
TRUE
FALSE