Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | For a type 0 system and unit ramp input, the steady state error is |

A. | 0 [Wrong Answer] |

B. | ∞ [Correct Answer] |

C. | 1 [Wrong Answer] |

D. | 1/K [Wrong Answer]_{V} |

View Answer
Explanation:-
Answer : BDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The hexadecimal number given below represent decimal numbers which are multiples of DC, C8, BE, 46, IE

2

6

7

10

⇒ Diamond is a paramagnetic material.

TRUE

FALSE

⇒ It is desired to evaluate the expression

`F = B * COS (Y) + C * SQR (COS (Y) + A * COS (Y) * COS (Y) * COS (Y)`

`F = B * COS (Y) + C * SQR [COS (Y)] + A * COS (Y) * SQR [COS (Y)]`

`F = B * COS (Y) + C * COS(Y) * COS (Y) + A * COS (Y) * COS (Y) * COS (Y)`

` X = COS(Y)`

⇒ Consider the following line 15

line 25

line 35

any of the lines 15 or 25, 35

⇒ A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be

230 V

0.5 x 230 V

2 x 230V

230/2V

⇒ The tuned circuit of the oscillator in a simple AM transmitter employs a 50 H coil and a 1 nanofarad capacitor. If the oscillator output is the carrier frequency will be

448 kHz

555 kHz

625 kHz

712 kHz

⇒ The type of noise that interfere very much with high frequency transmission is

white

transit time

flicker

shot

⇒ Which one is correct option? - A pure capacitor never dissipates energy, but only stores.
- Capacitor can store finite amount of energy even cunent is zero.
- The current through a capacitor is zero if voltage across it d.c.
- Voltage across a capacitor cannot change instantaneously since it would require an infinite current.
*q*_{c}(0^{-}) = *q*_{c}(0^{+})

5, 4, 3, 2

3, 4, 1, 2

2, 4, 3, 1

1, 2, 3, 4, 5

⇒ An FM transmitter delivers 80W to a load of 30 W when no modulation is present. The carrier is now frequency modulated by a single sinusoidal signal and the peak frequency deviation is so adjusted to make the amplitude of the second sideband is zero in the given out

5.12 W

21.78 W

2.56 W

16.81 W

⇒ Purpose of antenna is

to transmit and receive energy

to convert EM into electrical

to convert electrical into EM

all of the above

⇒ The dc output voltage from a power supply

increases with higher values of filter capacitance and decreases with more load current

decreases with higher values of filter capacitance and increases with more load current

decreases with higher values of filter capacitance as well as with more load current

increases with higher values of filter capacitance as well as with more load current

⇒ In a cable with ∈_{r} = 4, the wave velocity is

3 x 10^{8} m/s

0.75 x 10^{8} m/s

1.5 x 10^{8} m/s

10^{8} m/s

⇒ Decade counter has 4 flip flops and skips states 10 to 15.

TRUE

FALSE

⇒ **Assertion (A):** Logical group of instructions contains instructions for logic operations.

**Reason (R):** Data transfer group instruction is basically a copying instruction.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is correct R is wrong

A is wrong R is correct

⇒ When a *p*-*n*-*p* transistor is properly biased to operate in active region the holes from emitter.

diffuse through base into collector region

recombine with electrons in base

recombine with electrons in emitter

none of the above

⇒ In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?

Half wave rectifier

Full wave rectifier

Bridge type full wave rectifier

Three phase full wave rectifier

⇒ In an amplifier with a gain of - 1000 and feedback factor β = - 0.1, the change in gain is 20% due to temperature. The change in gain for feedback amplifier will be

0.1

0.05

0.002

0.0001

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The input signal-to noise ratio is

2

10

20

100

⇒ The storage capacity of a CD is

360 k bytes per side

360 M bytes per side

540 k bytes per side

540 M bytes per side

⇒ In the circuit, the value of the voltage sour

-22 V

-12 V

+12 V

-10 V

⇒ The Hilbert transform of cos ω_{1}*t* + sin ω_{2}*t* is

sin ω_{1}*t* + cos ω_{2}*t*

sin ω_{1}*t* - cos ω_{2}*t*

cos ω_{1}*t* - cos ω_{2}*t*

- sin ω_{1}*t* + cos ω_{2}*t*

⇒ For a transistor to have-a larger β it must have and a

close to zero

close to 0.5

close to unity

nearly infinite

⇒ A wire has a resistance R ohm. If another wire of the same material and same weight has double the diameter (as compared to the first wire), the resistance of the second wire will be

0.5 R

0.25 R

0.125 R

R/16

⇒ A 10 μF capacitor is charged from a 5 volt source through a resistance of 10 kΩ. The charging current offer 35 m sec. If the initial voltage on C is - 3 V is

0.56 mA

5.6 mA

6 mA

5 μA

⇒ **Assertion (A):** In 8085 when RESET OUT goes low processing begins.

**Reason (R):** CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is correct R is wrong

A is wrong R is correct

⇒ A bypass capacitor produces

dc ground

ac ground

both dc and ac ground

none of the above

⇒ An ac sinusoidal wave has an rms value of 10 V. The peak to peak value is

10 V

0 V

14.14 V

28.28 V

⇒ A modem is connected to PC at

serial port

parallel port

SCSI port

input port

⇒ In which of the following is the width of junction barrier very small?

Tunnel diode

Photo diode

PIN diode

Schottky diode

⇒ The amplitude of a random signal uniformly distributed between - 5 V and

0.0333 V

0.05 V

0.0667 V

0.10 V

```
```

```
```

```
```

```
```