Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | For a symmetrical two hinged parabolic arch, if one of the supports settles horizontally, then the horizontal thrust |

A. | is increased [Wrong Answer] |

B. | is decreased [Correct Answer] |

C. | remains unchanged [Wrong Answer] |

D. | becomes zero [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :Tabassum khan Said on 2020-10-11 21:57:39in kani's method the displacement contribution of a number with a sway of delta is Himanshu Gupta Said on 2019-07-04 04:35:13agar vertically settle hoti hai to : No change agar horzontally settle hoti hai : decrease. !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be

more

less

the same in both the cases

100%

⇒ The timber floor not spanning on the masonry wall but properly anchored to the wall gives

lateral restraint but not rotational restraint

rotational restraint but not lateral restraint

both lateral and rotational restraints

neither lateral nor rotational restraint

⇒ The analysis of statically indeterminate structures by the unit load method is based on

Consistent deformation

Stiffness method

Consistent force

None of these

⇒ For masonry built in 1:1:6 cement-lime-sand mix mortar or equivalent, the horizontal shear stress permissible on the area of a mortar bed joint is

0.15 MPa

0.125 MPa

0.1 MPa

0.075 MPa

⇒ If the horizontal cross-sectional area of a wall is 1200 cm2, then the basic stress shall be multiplied by a reduction factor equal to

0 6

0.75

0.85

0.95

⇒ For earthquake resistant masonry buildings, where seismic coefficient is less than 0.08, the horizontal distance between two openings shall not be less than

Vt x height of shorter opening

Vt x height of longer opening

Ax height of shorter opening

Vi x height of longer opening

⇒ The fixed support in a real beam becomes in the conjugate beam a

roller support

hinged support

fixed support

free end

⇒ The horizontal thrust due to rise in temperature in a semicircular two-hinged arch of radius R is proportional to

R

R

^{2}

1/R

1/R

^{2}

⇒ Effects of shear force and axial force on plastic moment capacity of a structure are respectively to

increase and decrease

increase and increase

decrease and increase

decrease and decrease

⇒ Which of the following will give higher ratio of brickwork strength to mortar strength ?

1 : % : 3

1 : Vz: 4>/2

1:1:6

1:2:9

⇒ A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m2. The maximum height of wall from stability consideration is

0.64 m

0.96 m

1.28 m

1.5 m

⇒ The deformation of a spring produced by a unit load is called

stiffness

flexibility

influence coefficient

unit strain

⇒ In column analogy method, the area of an analogous column for a fixed beam of span L and flexural rigidity El is taken as

L/EI

L/2EI

L/3EI

L/4EI

⇒ Principle of superposition is applicable when

deflections are linear functions of applied forces

material obeys Hooke's law

the action of applied forces will be affected by small deformations of the structure

none of the above

⇒ The moment distribution method in structural analysis can be treated as

Force method

Displacement method

Flexibility method

None of these

⇒ The number of independent displacement components at each joint of a rigid-jointed space frame is

1

2

3

6

⇒ Bending moment at any section in a conjugate beam gives in the actual beam

slope

curvature

deflection

bending moment

⇒ The three moment equation in structural analysis is basically a

Stiffness method

Displacement method

Energy method

Flexibility method

⇒ The method of virtual work in the analysis of structures results is

Compatible deformations

Equilibrium of forces

Stress strain relations

None of these

⇒ Which of the following methods of structural analysis is a displacement method ?

moment distribution method

column analogy method

three moment equation

none of the above

⇒ In moment distribution method, the sum of distribution factors of all the members meeting at any joint is always

zero

less than 1

1

greater than 1

⇒ Select the correct statement

Flexibility matrix is a square symmetrical matrix

Stiffness matrix is a square symmetrical matrix

both (a) and (b)

none of the above

⇒ The principle of virtual work can be applied to elastic system by considering the virtual work of

internal forces only

external forces only

internal as well as external forces

none of the above

⇒ The thickness of each leaf of a cavity wall shall not be less than

5 cm

7.5 cm

10 cm

15 cm

⇒ The moment area theorems in the structural analysis fall in the category of

Force method

Displacement method

Stiffness method

Iterative method

⇒ In moment distribution method the sum of distribution factors of all the members meeting at any joint is always

Zero

< 1

> 1

= 1

⇒ While using three moments equation, a fixed end of a continuous beam is replaced by an additional span of

zero length

infinite length

zero moment of inertia

none of the above

⇒ The three moments equation is applicable only when

the beam is prismatic

there is no settlement of supports

there is no discontinuity such as hinges within the span

the spans are equal

⇒ In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as

sum of thickness of both leaves

two-third of the sum of thickness of both the leaves

actual thickness of the stronger leaf

larger of (b) and (c)

⇒ For strengthening a 50 m long and 5 m high straight compound wall built in brick work, which one of the following would be most suitable?

providing buttresses at certain intervals

providing a deeper foundation

using a richer mortar

using stronger bricks